) Consider a cellular telecommunication environment that uses a regular cell structure with cell radius R. Due to increased demand, the user density per cell has now increased by a factor of 16. Without allocating more spectrum, devise a scheme that will restore the quality of service provided to what it was before the increase in demand.

) Consider a cellular telecommunication environment that uses a regular cell structure with cell radius R. Due to increased demand, the user density per cell has now increased by a factor of 16. Without allocating more spectrum, devise a scheme that will restore the quality of service provided to what it was before the increase in demand.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

How much increase in spectral efficiency is provided by W-CDMA in comparison to GSM? a) Two times b) Three times c) No increase d) Six times
Q3: Derive an expression that defines the propagation constant y starting from the basic transmission line equivalent eircuit. Maient and
4. One of the key factors that drives the design of a satellite based personal communication system is the size and allowable power of the handset transmitter. If the handset is limited to a three-quarter watt (0.75W) transmitter, and has an antenna with a gain of only 1.5 dB, what is the maximum range over which we can close the uplink with an acceptable margin (10 dB)? Givens: a) satellite antenna diameter of 1.0 meter (.65 efficiency), b) transmitter frequency 900 MHz, c) bandwidth 150 KHz, and d) noise temperature 500K.
Q3\ B\ An optical link is required to operate over 10 km without repeaters. The fiber available exhibits a rise time due to intermodal dispersion of 0.7 ns km', and arise time due to intramodal dispersion of 0.2 ns km!. In addition, the APD photodetectoer has a rise time of 1 ns. Estimate the maximum rise time allowable for the source in order for link to be successfully operated at a transmission rate of 40 Mbps using RZ pulse format. (6 degrees)
5. A solar pathfinder indicates that a fixed array in Seattle, Washington, experiences a 25% loss of sunlight due to shading. For a grid-tied building that consumes 6000 kWh/year of electricity, what size array will provide all of the electricity on average? Assume standard sys-tem losses.
Please solve the question and explain fully. Thanks.
the GSM radio cellular system uses GSMK in a 200.KHZchannel with a channel data rate of 270.833 KBS. calculate (A) the frequency shift between mark and space (B) the transmitting frequency if the carrier(center) frequency is exactly 880MHZ (C) the bandwidth efficiency of the scheme in b/s/HZ
Why telecom has natural tendency of monopoly?Under what condition, a telecom operator may be caught in inescapable loss trap and what are major segments of telecom industry?
What are (a) the values of the intercept points in the load line and (b) the slope of the load line given the circuit?
4. Give the reasons: onductor c. The transposition of the overhead transmission line. d. A charging current is existing in a line even when line is open circuited at the load end.
b) A 16km long, air-spaced twin wire line has a characteristic impedance of 2500. It connects a 2.2kV DC source (of 2502 output impedance) to a 1500 load. (i) Calculate the total inductance, total capacitance and signal transit time of the twin wire line. (ii) Calculate the voltages and currents of both the forward and reflected waves along the twin wire line, and also the load power. c) The twin wire line develops a sudden short circuit at its midpoint. Describe fully and quantitively the subsequent changes in voltages and currents at all points along it in response to this fault, noting the times at which these changes occur, until steady-state conditions are attained.
- The plot of the obtained VSWR for the short circuit load, and compare the obtained speed of em wave in the cable with that of the speed of light. - The obtained value of the load.