Consider a cellular system with operating frequencies around fc = 900 MHz, cells of radius100 m, and nondirectional (isotropic) antennas, under the free-space path loss model, what transmit power is required at the base station such that all mobile devices within the cell receive a minimum power of 10 µW? * 142W 0.142122KW 124.122W 142MW

Consider a cellular system with operating frequencies around fc = 900 MHz, cells of radius100 m, and nondirectional (isotropic) antennas, under the free-space path loss model, what transmit power is required at the base station such that all mobile devices within the cell receive a minimum power of 10 µW? * 142W 0.142122KW 124.122W 142MW

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Help me
Please show all steps A parabolic dish antenna has a diameter of 5 meter, operating at 30 GHz frequency.a) What is the effective area Ae of the antenna? b) What is the antenna power gain in ratio and in dBi?
Q5: A directional coupler has the scattering matrix given below. Find the return loss, coupling factor, directivity, and insertion loss. Assume that the ports are terminated in matched loads. [S] = 0.15/45° 0.85290° 0.85290° 0.15445° 0.006290° 0.22180° 0.006490° ¹0.006290° 0.22180° 0.22180° 0.006290° 0.22180° 0.15445° 0.85290° 0.85290° 0.15/45°
1. Determine the following; (a) What is the wavelength of an 800-MHz signal? (b) What is the wavelength of a 1.9-GHz signal? (c) What is the wavelength of a 38-GHz signal? (d) What is the frequency of a 10-m amateur radio signal? (e) What effect would the ionosphere have on signals at each of the preceding frequencies?
A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage source which has an internal resistance of 25 Ω) a) Make a diagram of the above system, b) Is an impedance matching circuit needed? If yes, where should the impedance circuit be inserted and make a diagram of the system with the adjusting circuit, c) How many cm is the length of the dipole antenna above, d) How much power is emitted when not using the adjusting circuit and e) How much power is emitted when using the adjusting circuit. Solve subparts D,E max 20 minutes ASAP
In a line-of-sight radio system, losses are mainly due to free-space path loss (FSPL). FSPL is proportional to the square of the distance between the transmitter and receiver as well as the square of the frequency of the radio signal. Calculate and sketch the FSPL for the situation as below: (1) For fixed frequency at 900 MHz, at the range of 1 km, 10 km, 30 km, and 50 km. (i) For fixed frequency at 5.8 GHz, at the range of 1 km, 10 km, 30 km, and 50 km. State your observation on those two graphs in terms of frequency different and range.
A broadcast transmitter produces about 2.8 KW in the sidebands when modulated at a level of 75%.a.) how much carrier power does the transmitter have under those conditions?b. how much increase in antenna current would result by the 75% modulation if the antenna resistance is 50 ohms?
Suppose you have a receiver whose sensitivity is -100 dBm (minimum received power with which it can operate) and a signal is transmitted to it at a power of 1W. At both ends of the link there are antennas with 3dB gains; installed at heights of 5 and 1 meter, respectively. The stage is flat terrain with no obstacles. What is the maximum distance that these transmitters can be separated? Assume an operating frequency of 700 MHz.
7 Basic path loss. Find the basic path loss for communication between two points, 2000 km apart, at a frequency of 5 GHz.
2. For link to be maintained between a geosatellite and an earth station about 35,786 km apart, calculate the carrier power (in dB) necessary giving the following antenna characteristics: a. 60% efficiency b. 2.5-cm wavelength c. 1.3-m diameter transmitting dish d. 1.0-m diameter receiving dish e. To ensure high service quality, it is suggested that the carrier power at the receiver input must be at least -116dBW.