Answered: Consider a boost converter that…

Engineering

Electrical Engineering

Consider a boost converter that supplies a resistive load with 32

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Values of Vg = 125 V, V0 = 75 V, f = 15 kHz, R = 10  are given for the buck converter. The…

A: Given Vg =125 VV0 =75 Vf =15 KHzR =10 Ώ ∆IL =5%∆V =1%

Q: A step down converter has a load resistance R-0.50hms. an input voltage Vs-200V and a battery…

A: The solution is given below

Q: A dual slope A/D converter has a reference voltage of 8.000 volts. The time to charge the…

A: From the given data, Discharging time (t2) = 0.315ms Charging time (t1) = 0.516ms Reference Voltage…

Q: A boost regulator has L=0.15 mH and C=0.11 mF with a duty cycle of 0.66 at a switching frequency of…

A: The peak to peak ripple in the output voltage is…

Q: Write the loop equations for a Buck converter in the two modes if the inductance is characterized by…

A: Buck converter We have to write loop equations in two modes i) Mode 1 : Switch is on ii) Mode 1 :…

Q: 4. a) Determine the output waveform for the following circuit. b) Repeat with the B input held LOW…

A: Given a GATE with the different input waveform To find its output waveform

Q: A step up dc/dc converter has input voltage Vs = 9 V, the average output voltage Va = 15 average…

Q: O Inductor Diode Voltage Surce Swilching Device Capactor This DC-to-DC converter has a duty cycle of…

A: Given data: Duty cycle = 33.3% = 0.333 Converter input = 5 V Output voltage = ? The dc-dc…

Q: What type of A/D converter would work best for video signals with a frequency content up to 5 MHz?…

A: A/D converters (ADC) provide different speeds, different accuracy and use various interfaces. The…

Q: A step up converter is operated with a duty cycle of k = 0.75. The input voltage is V,= 20V, and the…

A: Duty cycle, k = 0.75, Input voltage, Vs = 20 V Inductance, L = 5 m H Load resistance, R = 20 Ω The…

Q: A step up dc/dc converter has input voltage Vs = 9 V, the average output voltage Va = 15 average…

A: A step up dc-dc converter has, Input voltage (Vs)= 9 volts Output voltage (Vo)= 15 volts Load…

Q: A step up dc/dc converter has input voltage Vs = 9 V, the average output voltage Va = 15 average…

Q: Determine the waveform, theoretical, of the peak output voltage at Resistor L. 120 V rms 5:1 ooooo…

A: Given:a full wave rectifier circuit, we are required to determine the output voltage waveform at…

Q: Propose an electronic circuit which has an input/output waveform like the one shown in the figure…

A: The above question is based on operational-amplifier based circuit design.The input voltage VIN is a…

Q: Estimate the maximum surge current in a half wave rectiﬁer with a transformer having an rms…

Q: 3. Show the step-by-step solution for each half cyclel. Sketch the output voltage waveform for the…

A: The solution can be achieved as follows.

Q: d) Design (Find the values of the R₁, R2, and C₁) an astable multivibrator circuit to have an output…

Q: The inductor current of a buck-boost converter is shown in the figure. The minimum inductor current…

Q: 3. Determine Veand Sketch output waveform for the clamper network shown. 20 V Si C Vi R Vo 4 V -20 V…

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: 20V RO -20V A laptop charger is connected with a load resistance R=37940 and practical PN junction…

A: Here circuit is given and we need to find output voltage

Q: 30°, the average value of output current ir A single-phase full-wave transistor rectifien feeds…

A: In this question we will find single phase full wave rectifier average value of output current for…

Q: 2- For the circuit given below : Vin is a sine wave Vinpp=18 V and Vref=-0.7 V, Assume Vsat=+12V…

A: we need to draw the input and output waveform of the given opamp

Q: In continuous conduction mode, the switching frequency in a DC/DC converter influences which…

A: DC/DC converter:- It is an electronic device that is referred to as a voltage regulator. It is a…

Q: Why this happening to my circuit? I am inputting a 0-3.3 V sine wave into my voltage follower…

A: According to the question, we need to discuss the problem in the designed circuit for voltage drop…

Q: For the following parts, identify the name of each circuit, plot the output waveform, and find the…

A: Given, Input AC voltage, V∘=Vmsinωt and Circuit 1, Circuit 2, Circuit 3, Average output voltage…

Q: 02. For the circuit shown below, sketch io & Ve a-60 a. Find the conduction angle of the thyristor.…

Q: ER10 13k2 R9 5V RMS Vin R11 2kQ and F= 1000 Hz 10k (+)

A: Need to find currents and time period for the given circuits

Q: Design a boost converter to provide an output voltage of 36V from a 24 V source. The load is 50 W.…

A: The solution can be achieved as follows.

Q: In an ideal, steady-state and uni current mode, a Buck-Type DC-I has a load resistance of 20 ohm…

A: According to question:

Q: a. Quantify how the resistors and the capacitor influence the output voltage of the circuit, Vout.…

A: a) The circuit is given as Case 1: Vout=+VCCVoltage at terminal x will beVx=R2R×(+VCC)Vx=VCC2=…

Q: DC to AC 1) Determine the efficiency of the following DC to AC converter (i.e. how much of the…

A: The figure of the signal is: From the figure: The RMS value of the voltage signal is determined as…

Q: Principles of analysis of converters in steady state. A steady state DC-DC Cuk converter is…

A: DC-DC Cuk converter Input voltage, Vs= 24 V Output voltage Va= 12 V Switching frequency, fs=200 kHz…

Q: The input voltage Vi of the following circuits is a triangular signal with an amplitude of 18Vpp,…

Q: A Capacitor filter is used at the output across the load to minimize the ripple factor of the output…

A: The amount of alternating current (AC) component compared to direct current (DC) component in a…

Q: The following circuit has a voltage across the load of 18V, a peak-peak ripple voltage of 318mV,…

A: Given With capacitor V0(cap)=18 V Peak to peak ripple voltage Vrpp=318 V To find output voltage…

Q: t=0 R1 R3 В ww 1= 0 INT 1 INT 2 V1 R2 V 30 V

Q: Design a buck converter such that the output voltage varies between from 20V to 28V while the input…

A: Dear student as per our guidelines we are supposed to solve only one question in which should…

Q: An RLC�� circuit with a 15 μF�F capacitor is connected to a variable-frequency power supply with an…

A: Dear student,Since you have posted multiple questions ,we will provide solution only to first…

Q: Design a buck converter such that the output voltage varies between from 20V to 28V while the input…

A: as per our guidelines we are supposed to solve only one question in which should contain three…

Q: Given Vi = 20V peak-to-peak, draw the output waveform for the said clamper circuit below:

Q: A boost converter has an input voltage Vb=5V. The average load current is lo=0.5A. The switching…

A: The ripple current in the inductor is ∆I = Vb(Vo-Vb)f L Vo ... (1) Where f is the…

Q: -Design a buck converter that has an output of 12 V from an input of 18 V. The output power is 10 W.…

A: Given data:: output voltage Vo=12v input voltage of a buck converter=18V Output power = 10W Output…

Question

Consider a boost converter
that supplies a resistive load
with 32<R<64 Ohms. Vo=30V
and the supply voltage (Vi) is
variable in the range 7.5-to-
20V and the switching
frequency is 10kHz (a)
Determine dmin and dmax (b)
Determine the minimum
inductance so that the
minimum inductor current
(IL,min) is at least 20% of the
average current (c)
Determine minimum
capacitance required to
maintain the output voltage
ripple < 0.3V (peak-to-peak).
[please upload your answer in
PDF format] *

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Peripheral Interface Controller (PIC) Microcontroller

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A step up dc/dc converter has input voltage Vs = 9 V, the average output voltage Va = 15 average load current la = 0.8 A. The switching frequency is f = 20 kHz, inductance is L = 0.3 mH and the parallel capacitance is C = 0.44 mF. Which one is the ripple current of inductor, Al ?
Calculate current gain, input and output impedance, and linearity. Beta = 90 IS = 2E-15
A stabilization circuit has a stability factor of 0.04 and an internal resistance of 5 2. The unstabilized voltage can vary between 75 and 100 V, and the load current can vary from 40 to 80 mA. Determine the maximum and minimum values for the stabilized load voltage.
Sketch out the fellowing signals: (a=7, b=5, c=8) a-) V = 15a(sin2r1000*ct) b-) V = 3b(cos(7500*ct)+3) c-) Assume that you measure the signal V1 using Digital Volt Meter(DVM) and ossiloscope. What will you read on the DVM display and oscilloscop dispaly when the input voltages are defined as 1-) V = 15a(sin2m1000*ct) 2-) V = 3b(cos(7500*ct)+3) Write down and sketch all the voltages for each case. Show all parameters, including period and maximum values of the signals. aR V AC aR V, aR What will you read at the DVM display when you read the voltages at AC mode What will you read at the DVM display when you read the voltages at DC range
For the buck-boost converter, determine the duty cycle, the switching frequency, and the inductor current ripple. The output voltage ripple is about 1%. vs 10 V, mH, C 0.5 micro.F, Vout=-20 V, R-IO Q
which of the following are true? In forward bias, the transition capacitance dominates In forward bias, the diffusion capacitance dominates In reverse bias, the transition capacitance dominates In reverse bias, the diffusion capacitance dominates
You have a complex waveform made up of a 500 Hz signal with an 8Pa peak amplitudeand 0 deg starting phase and a 1000 Hz signal with a 2Pa peak amplitude and 90degstarting phase.a.What is the amplitude of the complex waveform at 15ms?
An RL load (R=0.2 Ohms, L=10 mH) is controlled by a converter. The supply voltage Vs is 600V and the chopper frequency is 200 Hz. The maximum peak to peak ripple current is equal to: Select one: a. 30A b. 55A c. 90A d. 75A
Draw the small signal equivalent circuit of the following circuit. Note that C1 and C2 are large AC coupling capacitors. 5 VIO C1 RF Q1 C2 fem RL Vo
C'uk Converter Design A C'uk converter has an input of 12 V and is to have an output of - 24 V supplying a 60 W load. Select the duty ratio, the switching frequency, the inductor sizes such that the change in inductor currents is no more than 12 percent of the average inductor current, the output ripple voltage is no more than 1.5 percent, and the ripple voltage across C1 is no more than 3 percent.
A buck converter operating in continues mode has the following parameters: Imin =0.9 A, Pout 124 W, R=2.6 2, f= 250 Hz, and the average value of the input current = 1.8 A. %3D %3D Find The inductor L in mH.
In the given circuit, a step down transformer with an RMS voltage as 220V / 22 V is used with RL = 3 KΩ. Assume diode as Silicon and the input frequency is F= 70 Hz. 1- Name the given circuit . 2- Find The PIV. 3- Find Current trough load resistance. 4- Draw the Input and Output wave forms.