Consider a 25-mm-diameter and 15-m-long smooth tube that is used for heating fluids. The wall is heated electrically to provide a constant surface heat flux along the entire tube. Fluids enter the tube at 50°C and exit at 150°C. If the mass flow rate is maintained at 0.01 kg/s, determine the convection heat transfer coefficients at the tube outlet for water, engine oil, and liquid mercury.

Q: In a condenser, saturated water vapour flows through cool water pipes, condenses on the surface of…

A: Copper tube diameter, d=4 cm =0.04 mAverage velocity of water through the tube, V=3 m/sWater inlet…

Q: Air at atmospheric pressure and 27 degree celsius is blown across a long 4.0-cm diameter tube at a…

A: Solution:

Q: In a gas-fired boiler, water is bein cm-diameter tube submerged in velocity of 7.5 m/s, and leaves…

A: The properties of the air at 1 atm pressure and 300 oC temperature,The mass flow rate of air in the…

Q: a) What is the required tube length for these conditions? b) To design a water heating system,…

A: first we calculate reynolds numebr  then evaluate nusselt number  then figure out h and the use…

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A:

Q: The average convection heat transfer coefficient during this cooling process is ____ W/m2·°C

A: Given DataThe steel ballDensity ρ = 8055 kg/m3Specific heat cp = 480 J/kg·KThe diameter  D =0.15…

Q: A manufacturing plant produces an efluent as a waste product. As part of a waste heat recovery…

A: Firstly, convert all temperatures in oC The temperature of the system, The temperature of water at…

Q: An ASTM B75 copper tube sheathes a heating element that is used to boil water at 1254 kPa. The…

A:

Q: Engine oil flows at a rate of 0.05 kg/s through a section of a 2.5 cm diameter tube. The oil enters…

A:

Q: Liquid ammonia is transported from a production plant to a processing center via a 0.6-m diameter…

A: Introduction Given data: diameter of pipeD=0.6 mmass flow ratem=0.15 kg/ssurface…

Q: 2- A- Water is to be heated from 15°C to 65°C as it flows through a 3-cm-internal-diameter 5-m-long…

A:

Q: A tube with a square cross-section 2 mm in side and 1.5 m in length imposes a constant heat flux of…

A:

Q: Water flows at 1 kg/s in a 10 mm diameter tube and is to be heated from 25 to 75 °C. The tube…

A: INTRODUCTION : When a flowing fluid travels through a heat exchanger, our focus is on either cooling…

Q: Consider a 50-mm-diameter and 25-m-long smooth tube that is maintained at a constant surface…

A: Write the expression of the average temperature.Here  indicates inlet temperature and  indicates…

Q: Liquid ammonia is transported from a production plant to a processing center via a 0.6-m diameter…

A:

Q: Oranges of 2.5-in-diameter (k= 0.26 Btu/h·ft·°F) and α= 1.4 10-6 ft2/s) initially at a uniform…

A:

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A:

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A:

Q: Air at 206.8 kPa and at an average temperature of 200 oC is being heated as is flows through a tube…

A: Given data  Pressure = 206.8 kpa Average temperature= 200°C Inside diameter of pipe = 40mm Velocity…

Q: Air at 1 atmosphere and a temperature of 60f enters 1/2-in. id tube with a velocity of 80 fps. The…

A: Given information Pressure of air entering = 1 atmTemperature = 60°F = 288.7056 KDiameter of tube =…

Q: Cylinder has a 0.Im in length and 0.1min diameter, is nitially at 292 K. It is suspended in a steam…

A: T1=Initial Room Temperature=292 KT2=Final Room Temperature=373 Khe=Heat Transfer Coefficient=8500…

Q: Engine oil flows at a rate of 0.05 kg/s through a section of a 2.5 cm diameter tube. The oil enters…

A: Given: Mass flow rate of the engine oil→m=0.05 Kg/s Diameter of the tube→D=2.5 Cm=0.025 m Initial…

Q: Liquid water enters a 10-m-long smooth rectangular tube with a = 50 mm and b = 25 mm. The surface…

A: According to the given data L=10m a=50mm=0.05m b=25mm=0.025m Ti=20°C Te=80°C We need to find The…

Q: Consider a 50-mm-diameter and 25-m-long smooth tube that is maintained at a constant surface…

A:

Q: Water with a mass flow rate of 0.002 kg/s at 18oC flows inside a tube while the flow is already…

A:

Q: 150 L/s of hot air at 80 degrees Ceelsius enters an 8m long uninsulated square duct of cross-section…

A: Heat transfer coefficient is calculate using Colburn equation. Surface temperature is assumed to be…

Q: 8.62, 8-62 Consider a 10-m-long smooth rectangular tube, with a = 50 mm and b = 25 mm, that is…

A: Write the given information.Write the expression of the mean temperature.Write the properties of…

Q: A liquid is entering a 10 m long pipe of 0.2 m diameter at 25°C with an average velocity of 0.02…

A:

Q: A flat plate 1.5 m wide and 2.0 m long whose surface is kept at 150 oC will be cooled by a current…

A: Laminar flow: Laminar flow is a type of fluid (gas or liquid) movement in which the fluid moves…

Q: Determine the evaporation rate when a container contains  hot water and the surface temperature of…

A:

Q: Consider a 10-m-long smooth rectangular tube, with a= 50 mm and b= 25 mm, that is maintained at a…

A:

Q: Water at 20°C flows through smooth tubes of 25 mm dia at a mean velocity of 2.2 m/s. The surface of…

A: Write the properties of water at 20 oC. μ=2.47 kg/hr·mk=0.534 kcal/hr·m°Ccp=1 kcal/kg°CPr=4.6255

Q: Air at a pressure of 1 atm. abs. and 50°C flows parallel to the top surface of a rectangular plate,…

A:

Q: Air is to be heated from 15 C to 270 C, as it flows through a tube 25mm diameter at average velocity…

A:

Q: How is the Reynolds number related to Darcy-Weisbach?

A: Reynolds number is used to determine the nature of the fluid, Laminar or turbulent fluid.

Q: 9-94 A hot liquid (c, = 950 J/kg-K) flows at a flow rate PtD of 0.005 kg/s inside a tube with a…

A:

Q: Steam condenses at 100°C on the outer surface of a pipe with a thermal conductivity of 180 J/ms°C.…

A: There are 3 resistances present in the given question that are- 1. Convective surface resistance of…

Q: Water is to be heated from 35 °C to 65 °C in a rough tube with a relative roughness of 0.001. The…

A: Given: The initial temperature of the water, Ti= 35o C The Outlet temperature of the water, To= 65o…

Q: Geothermal steam at 172°C condenses in the shell side of a heat exchanger over the tubes through…

A:

Q: The sensible heat-transfer coefficient for a dry surface has been determined to be 50 W/(m2-C) at a…

A: Given-Information:- Dry bulb temperature, Tdb= 24°C Wet bulb temperature, Twb = 18°C Area, A = 1m2…