Consider a 24 in long simply supported beam with 2 point loads symmetrically placed at 6 inches from each support. If the beam started cracking directly in the middle at 400 lbs and ultimately failed at 800 lbs, find the Modulus of Rupture of the beam (in psi). Consider the beam width= 4in and thickness =4in. Pla Pla bin 12 in 24 in bin yin Vin

Consider a 24 in long simply supported beam with 2 point loads symmetrically placed at 6 inches from each support. If the beam started cracking directly in the middle at 400 lbs and ultimately failed at 800 lbs, find the Modulus of Rupture of the beam (in psi). Consider the beam width= 4in and thickness =4in. Pla Pla bin 12 in 24 in bin yin Vin

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 500 Hz. The ceiling is acoustic ceiling tile (ACT), Symbol for pi = .95 at 500 Hz Using the same…

A: Room dimensions: Length = 4 mWidth = 7 mHeight = 3 mFloor absorption coefficient= 0.15 Wall…

Q: Determine the x. Measure it from the y-axis. 100 140 mm 140 mm

Q: The length of chain measured with a chain was found to be 250 m. If the length of chain was measured…

Q: Find the moment of inertia about the x and y axis for the region shown below. y 500 50 -60 400 500…

Q: y 0₁ Variable FR 02 F2 F3 5 13 0₁ = 12 0₂ F3 F₁ Values for the figure are given in the following…

Q: Find the Displacement of object if work done on object is 500 J and force applied on object is 22.25…

A: Given data : Work done is denoted by W Force applied on object is denoted by F Required :…

Q: The length of chain measured with a chain was found to be 250 m. If the length of chain was measured…

A: Given: Measured length of chain, L' = 250 m Actual length of chain, l = 30 m The chain was 10 cm…

Q: a) The true length of a line was known to be 50 m. The line was measured with a 30 m tape and found…

A: The linear measurement in the survey can be carried out using the chain, tapes etc, While measuring…

Q: Find the centroid of the given figure y 3 in. 1 in. 1 in. a 2 in. -3 in.-3 in.

A: From the given figure, We have to find the centroid

Q: 12. Find the relative error in the computed area of an equilateral triangle due to an error of 3% on…

A: Solution: a'=1+0.03a Area; A=34a2 Area'=34×1.03a2 Relative error: R=A'-AA×100

Q: Problem 3 9.4 Find the distance h for which the moment of inertia of the plane region about the…

A: d=300mm To find h

Q: Q: The lengths of the sides of a plot of land were measured and they were equal to (200 x 300 m)…

A: Given:- The size of the plot = 200×300 m The nominal length of the tape = 30 m The real length of…

Q: Homework 1- a worker with spikes on his shoes pulls with a constant horizontal force of magnitude 20…

A: As per guidelines we are supposed to answer only first question so please repost rest questions…

Q: The following figure: If the dimensions of the rectangle are (100X50) how much is the area specified…

Q: Do not include the unit in writing the answer. Express all values up to 3 decimal places. You can…

A: Given data in question Back sights Fore sights Height of instrument Elevations To find out…

Q: Q1: Calculate the enclosed area (m) shown in the following figure? 13 42 9 8 41 7 62 164 44 66 g0 28…

Q: Given a rectangular figure whereinb 200 mm andh 300 mm. cg means center of gravity (centroid). What…

Q: Use g = 9.807 m/s² = 32.17 ft/s² and ywater = 9790 N/m³ = 62.4 lb/ft³ FL A two-dimensional analysis…

A: Given, FL=fL,V,D,α,ρ,μ,c where, L=Length V=velocity D=Diameter α=angle of attack ρ=density…

Q: Given: The drag force (FD) on a sphere falling through a fluid is a function of viscosity (u),…

Q: From the Figure, determine the equation of moment and what would be the value of moment if X 5 m and…

Q: C A D (Note: Please provide all the numbers as ratios, do not use decimal points. For example, use…

A: Free body diagram - Vertical force at A = RA For the sum of vertical force - ∑My = 0⇒RA - 20×11 =…

Q: Hello, thank you for the help. Could you please tell me why you divided the velocity by 1000 in the…

A: Given: WT = h1+½ v12 -h2 required: Explain why ½ v1² is divided by 1000.

Q: A snowball rolls off a barn roof that slopes downward at an angle of 40°. The edge of the roof is…

Q: The fuel gage for a gasoline tank an a car reads proportional to its bottom gage. The tank is 35 cm…

A: Pressure when tank is full of gasolinePG=γghgPG=(0.68×9.81)(0.35)=2.335kPa

Q: 235 mm 115 205 mm mm 50 mm 90 mm 140 mm Answers: i mm y = i mm i mm II IN

Q: or higher is required for t visualize the line you thin , Σy = 569, Σy2 = 64,791 1

A: Given: Take y be the maximum wind speed and x be the lowest pressure.

Q: The length of chain measured with a chain was found to be 250 m. If the length of chain was measured…

Q: For the section shown, calculate lyy. Present your answer in mm4 giving it to 4 significant figures.…

Q: From the given figure determine the location of its centroid from the given origin.

A: Steps: 1 Centroid: - It is defined as the arithmetic mean of all the points of figure. Centroid is…

Q: Area A1) = lox6. 60 mm = 3 m lo = Smm Area (Az) =}T (3) =14:139 mm? 3 mm , 43) = 1.27 mn Sea (As)…

A: 1. Explanation for '3' The formula for locating the centroid of the semicircle from its diameter is…

Q: 1400 1200 1000 800 600 400 200 1000 2000 3000 4000 5000 6000

Q: 17.9 What are the ratio scales for the equivalent scales of 1 in. = 50 ft and 1 cm 10 m? -

Question

Please explain step by step so I can understand, the answer should be 112.5

Consider a 24 in long simply supported beam with 2 point loads symmetrically placed at 6 inches from each support. If
the beam started cracking directly in the middle at 400 lbs and ultimately failed at 800 lbs, find the Modulus of Rupture
of the beam (in psi). Consider the beam width= 4in and thickness =4in.
Pla
bin
12 in
24 in
bin
yin
Vin

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data,

VIEW

Step 2: Reaction at the beam support.

VIEW

Step 3: Modulus of rupture of the beam.

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Physics Required Calculate in steps and then draw in a clear way as follows: The design of two folds (two ramps) staircases for a building, a clean floor height of 3.58 meters, taking into account that the thickness of the node on the ground floor and tiles is 0.5 cm. The internal dimensions of the stairwell are 6 m * 2.80 m. Knowing that the lantern The staircase is 0.2 cm. taking into consideration The human standards that must be taken into account during the design, are as follows: sleeper width (pedal) = 0.3 cm Step Height = 0.17 cm
kindly solve the Ixx and Iyy. Enclose and summarize final answers.
20 y+ 10y + 26y = Find the particular solution of each of the following equations which satisfies the given conditions: 23 y+4y 0
Compute for the centroid of the shaded area on the figure shown below: (2 boxes) (all units are in millimeters)
Discuss the topic of Uncertainty in Measured Properties.
I need the answer as soon as possible
7. Symbols for area measure and volume measure are written with exponents. Example: 3 cm2 not 3 sq cm 4 km3 4 cu km not
Determine the solutions of the following Differential Equations using Reduction of Order
Assignment 1 Engineering Mechanics - Saved Engineering Mechanics Assignment # 1 State Law of Gravitation. Furthermore Mass of different objects are given in table. Find out gravitational force for each set of parameters given in the table (CLO1) Mass of Object 1 Mass of Object 2 Separation Distance (kg) (kg) (m) 6.38 x 10 m Football Player Earth 100 kg a. 5.98 x104 kg (on surface) Earth 6.38 x 10 m Ballerina 40 kg b. 5.98 x104 kg (on surface) Physics Student Earth 6.60 x 10 m 70kg 5.98 x1024 kg (low-height orbit) Physics Student Physics Student d. 1m 70 kg 70 kg Physics Student Physics Student e. 70 kg 0.2 m 70 kg Physics Student Physics Book 70 kg 1m 1kg Physics Student 70 kg Мon 7.34 x 10 kg 1.71x 10°m (on surface) Jupiter 1901x 10" kg 6.98 x 10'm (on surface) Physics Student h. 70 kg