Consider a 10:1 pressure rise in the ideal compressor with air as the working fluid compared to the a pump with water as the working fluid and the same pressure rise and same inlet pressure. Check all that apply O The compreesor takes 300 times more work/unit mass as the pump The work per unit mass is about the same between the two. Becase the pump deals iwth a liquid the work will be higher. O The compressor in a Brayton cycle has a much greater effect on performance than a pump in a Rankine cycle.

Consider a 10:1 pressure rise in the ideal compressor with air as the working fluid compared to the a pump with water as the working fluid and the same pressure rise and same inlet pressure. Check all that apply O The compreesor takes 300 times more work/unit mass as the pump The work per unit mass is about the same between the two. Becase the pump deals iwth a liquid the work will be higher. O The compressor in a Brayton cycle has a much greater effect on performance than a pump in a Rankine cycle.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

EX: In a combined cycle power plant air inlet condition are (1.01 bar) and (17 °C) ,compressor exit pressure is (10 bar). Gas turbine inlet temperature is (800 °C), the plant produce a total of (50MW) and the exhaust from the gas turbine leaves the steam generator at(150 °C).While the steam leaves the steam generator at (60 bar) and (400 °C) .Find the flow ratio required and the thermal efficiency in each cycle. Take the condenser pressure to be (0.02 bar) and compressor gas turbine and turbine and steam turbine efficiencies (80%,85% and 87 % respectively?
An R22 system has compression raito of 4:9:1 NRE of 72 btu/pd , heat compression of 18 btu/ pd and constant volume of 1.4 cfm at inlet to the compressor . what's the displacement of compressor for 1 ton of refrigerant.
Urgentt.
Q2/Gas turbine unit having heat exchanger with thermal ratio(0.75),ahigh pressure stage turbine drives the compressor and a low pressurestage turbine generate the power. The overall pressure ratio is (5/1) andthe maximum temperature is (1000 o c).The isentropic efficiencies ofcompressor, H.P.T and L.P.T are (0.7),(0.78) and (0.8) respectively andmechanical efficiency of both shafts is (99 %) . Calculate:a- The pressure between turbine stages when the air intake conditionare (1 bar) and (29 oc) b- Thermal efficiency when the mass flow is (30 kg/sec)Cpg= 1.15 kJ/kg.K ɣg=1.33
Q3:A small truck has #cylinder ,4 liter compression ignition engine that operates on ir standard Dual cycle with air fuel ratio of 16:1, the compression ratio is 17 and the cylinder diameter is 14.5Cm. At the start of compression stroke Ta=50'C and Pa=100 kpa .It can be assumed the half of the heat input is added at constant volume and halt at constant pressure Calculate: 1-Temperature and pressure at each state of the cycle. 2-Indicated thermal efficiency. 4:28 PM
Find the efficiency of Ideal Brayton cycle having pressure ratio of 8. What will be new efficiency if pressure ratio is changed to 10.
Please proceed asap,urgent. Thanks.
Exit temperature?
Explain ideal Rankine cycle with P-V, T-S and h-S plot.
Air temperature 30 ° C pressure 1 bar flows into the ideal gas turbine cycle by a pressure ratio air compressor (r). 12 The hot gas discharge temperature from the combustion chamber is 1200 K. The air flow in a constant cycle is 60 kg/s a. Draw the diagram T-5 of this cycle b. Find the net power output (kW). C. Find the thermal efficiency of this cycle
7 The schematic of a two stage air compressor with an intercooler is shown. 100 kPa, 290 K 1.6 MPa C2 °C. (Assume all process to be The temperature of air after first stage compression is ideal and optimal)
Explain in essay why using too much compressor stages is not efficient.