Connected in series, three resistors consume the following power values: 50 watts, 30 watts, and 20 watts. The resistor dissipating 20 watts has a voltage drop of 10 volts across it. Determine the magnitude of the voltage source across which the said series combination is connected. O 60 volts: O 30 volts: O 50 volts; O 40 volts:

Connected in series, three resistors consume the following power values: 50 watts, 30 watts, and 20 watts. The resistor dissipating 20 watts has a voltage drop of 10 volts across it. Determine the magnitude of the voltage source across which the said series combination is connected. O 60 volts: O 30 volts: O 50 volts; O 40 volts:

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Three resistors R1=8.2 ohms, R2=9 ohms, R3=9 ohms are connected in series and to a 120-volt potential difference. Find the power dissipated in resistor 3 when connected to the 120-volt line.
Two 3.8microF capacitors, two 2.2kohms resistors and a 16.0V source are connected in series. Starting from the uncharged state, how long does it take for the current to drop from its initial value to 1.50 mA
Three resistors, R1 = 17.3, R2 = 13.2, R3 = 78, are connected in series across a 16.6 V battery. What is the voltage drop (in Volts) across R1?
A 500 Ohm, 200 Ohm, and 300 Ohm resistors are all in series and connected to 100 V power supply. What is the potential difference across the 200 Ohm resistor? 50v 100v 30v 20v
A 2.00 µF and a 5.50 µF capacitor can be connected in series or parallel, as can a 40.0 kN and a 100 kN resistor. Calculate the four RC time constants (in s) possible from connecting the resulting capacitance and resistance in series. resistors and capacitors in series 0.24 X S resistors in series, capacitors in parallel S resistors in parallel, capacitors in series capacitors and resistors in parallel
The circuit of the figure shows a capacitor, two ideal batteries, two resistors, and a switch S. Initially S has been open for a long time. If it is then closed for a long time, what is the change in the charge on the capacitor? Assume C = 41 μF, 81 = 4.1 V, 82 = 5.3 V, R₁ = 0.520, and R₂ = 0.45 0. Number ap Units R₁ C R₂ www
A 10 kΩ resistor and a 3 nF capacitor are connected across a 10 V battery. The time it takes for the potential across the capacitor to reach 4 V is (a) 17.5 msecs (b) 15.3 msecs (c) 12.0 msecs (d) 18.0 msecs (e) 2.85 msecs
Refer to the circuit below. The power delivered by the 20 V voltage source is given by: 8Ω I3 6Ω 2 A 20 V I2 5 V + 10 V 4Ω O A. P20 = 20(/1 - /2) B. P20 = 20(12 - l1) OC. P20 = 20/2 20 P20 %3D E. None of the given answers 20 F. P20 12
In Lab 8, Ohm's Law, a student measures the below values of voltage V and current I. First convert all mA to A, then on graph paper plot V vs. 1, and calculate the slope of the line. This slope represents the unknown resistor. I (mA) 1.8 V (v) 0.51 2.6 0.78 4.3 1.18 2.42 3.67 8.8 14.2 18.6 4.58
The following 1⁄4 W resistors are in series: 1.2 kΩ, 2.2 kΩ, 3.9 kΩ and 5.6 kΩ What is the maximum voltage that can be applied across the series resistors without exceeding a power rating? Which resistor will burn out first if excessive voltage is applied?
A 20.0-μF capacitor is charged to 200 V and is then connected across a 1000-Ω resistor. What is the initial current just after the capacitor is connected to the resistor? Group of answer choices 100 mA 150 mA 300 mA 50 mA 200 mA
Using your data, answer the following questions: a. To three decimal places, what fraction of the total charge does a capacitor in an RC circuit have after charging for 4.15 time constants; the fraction f such that q(4.15t) = fQmax