CONFIGURATION: RELIAB LITY AND MAINTENANCE: Formated capadiy. TB 3 MTTF 1,000,000 hours Integrated controller SATA Start'stop cycles 50,000 Encoding metrod EPFML Dosign lilo 5 years (minimum) Buffer size 32ME Data errors Platers (nonrecoverabie) < per 105 oits read PERFORMANCE: Data surfaces 16 Seek tirmes Trecks per sutace 16,383 Track to track Track density 190,000pi Fead 0.3ms Recording density 1,462Khpi Byles per seclor 512 White 0.5ms Average Sectors per Track 63 PHYSICAL Fead 4.5ms While 5.0ms Helght 26. 1mm Average latency 4.17ms Length 147.0mm Rotational speed Width 101.6mm (4-0.20%) 1200rpm Weight Temperature (C) 720g Deta transfer rale: Operating 5'C to 5°C From disk 12MB/sec Nonoperating'storage -40'C to 71'C To disk 3GB/sec Relative humidty 5% to 95% Start ime Acoushc roise 20dEA, ide (0 to drive ready) 9 sec POWER RECUIREMENTS +5VDC Pover Mode +5% - 10% +5.0VDC Spin up 255mA 16.5W Readwite 1,080mA 14.4W Idle 730mA 9.77W Stancty 270mA 1.7W Seep 250mA 16W FIGURE 7.15 A Typical Rigid Disk Specification as Provided by a Disk Drive Manufacturer

Q: What are the contents of the ROM in as shown?(All FETs are NMOS.)

A: Determine the contents of the ROM in the given figure: The circuit of NMOS static ROM is shown…

Q: When data is transferred to SCSI disks, SAS employs parallel cables to do it. Is this statement…

A: Find answer with explaination in step 2

Q: Assume that the head of a moving-head disc has 200 tracks numbered 0 to 199 and is currently serving…

A: The FCFS Disk Scheduling Technique is the most basic disc scheduling algorithm, and it works on a…

Q: Find the missing bits in the below RAID level 3 using parity bits. (Note: read from row 1 to row 4…

A: Here in this question we have given raid level 3 parity bit concept.there we have given some missing…

Q: Parallel lines are used by SAS to deliver data to SCSI discs. Is this statement true or false?

A: Introduction: The Small Computer System Interface (SCSI, pronounced ski SKUZ-ee) is a protocol that…

Q: Now that you know the spacing between the pits that store information on the CD (d=1.208x10^-6 m),…

A: To calculate the information capacity of a CD, we need to know the formula for the information…

Q: I need a term for the sum of the rotational delay and the seek time.

A: Rotational delay and seek time: Rotational delay is the amount of time it takes for a track sector…

Q: What phrase is used to summarize the rotational delay as well as the seek time?

A: Seek Time is the amount of time it takes for the head of a disc to travel from one track to another…

Q: arallel wires to interact w

A: Given   SAS uses parallel wires to interact with SCSI discs. Is this correct or incorrect?

Q: If the radius of a CD-ROM is 6 cm, what is the average number of bits per cm2 if the total number of…

A: average number of bits per cm2 = total area/total bits

Q: ow many bits would be squandered in the single block used for the inode bitmap on a VSFS-formatted…

A: Introduction to VSFS Formatted disk It is defined as a virtual simple file system (VSFS) known as…

Q: What phrase is used to refer to the sum of the rotational delay and seek time?

A: Ans: The phrase that is used to refer to the sum of the rotational delay and seek time is called the…

Q: Compare the bit-map and hole-list methods for keeping track of free space on a disk with 800…

A:

Q: The disc method for reducing the amount of time lost due to rotational delay is known as staggered…

A: What is storage: Storage refers to the process of saving and retrieving data for later use.

Q: Assume two disks now perform RAID3 for bits given below 111111 0000000 Show all steps how data is…

A: RAID 3 is a Redundant Array of Independent Disks (RAID) standard that uses striping at the byte…

Q: Suppose a disk rotates at 5,400 revolutions per minute and has each surface divided into 16 sectors.…

A: ANSWER TO THE GIVEN QUESTION   Hard disk rpm speed is 5400 and hard disk is divided into 16 sectors.…

Q: For a 5,000 RPM disk, assume its average seek time is 7 msec, and it has 100 MB/sec bandwidth;…

A: To answer these questions, we will use the following formulas: Average access time = Average seek…

Q: SAS communicates with SCSI drives using parallel wires. Is this true or false?

A: Given:   SAS communicates with SCSI drives using parallel wires. Is this true or false?

Q: When communicating with SCSI discs, SAS employs the usage of parallel wires. Is this the right…

A: What is an interface: An interface is a shared boundary across which two or more separate components…

Q: Write a program using 8051 to read 8 bit input data from P1, divide the input data by 2, and sends…

A: ANSWER: 8051 UART module In the event of offbeat sequential correspondence start and stop pieces are…

Q: What exactly does it imply for disc drives when they have reached the superparamagnetic limit?

A: Understanding the Super paramagnetic Limit: The super paramagnetic limit is a critical magnetic data…

Q: I need the answer of the table pls.

A: Solution the below:

Q: SCSI discs communicate with SAS through parallel lines. There are two ways to look at it

A: Introduction: Serial Attached SCSI (SAS) is a point-to-point serial protocol used in computing to…

Q: How many binary levels are needed to achieve the capacity 18 MBps

A: Below is the answer:

Q: Choose the correct answer: 1. The signal used to insert Tw state:

A: Subject: Digital circuit and fundamentals of microprocessor The process by which the normal working…

Q: By using metode masking and Bit Test instructions, perform sequentially for the E87AH number (write…

A: We need to perform the mentioned operations on given data bits.

Q: It's difficult to tell the difference between a secret data channel and a hidden timing channel.…

A: Conversion from a timing channel to a storage channel counterpart Per timing channel can be…

Q: Let's say there are seven requests: 16, 24, 43, 82, 140, 170, and 190. Additionally, the disc arm is…

A: To calculate the total seek time, you will need to determine how far the disk arm must move to reach…

Q: What is the maximumum length of the IV

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: how do we know that the serial port has received a certain number of bit data byte in a program?

A: The question is how do we know that the serial port has received a certain number of bit data byte…

Q: There's an option on Skype that lets users call from their computer to an ordinary phone. This means…

A: the answer is given below:-

Q: How many 16k * 1 RAMS are required to achieve a memory with a word capacity of 16k and a word length…

A: Given: How many 16k * 1 RAMs are required to achieve a memory with a word capacity of 16k and a word…

Q: d) Consider a 15bit address in high-order interleaving, determine the bank and offset value from the…

A:

Q: Write MIPS code to echo one keyboard input to the monitor, where your code shall do the following:…

A: the program is given below:-

Q: Parallel wires are used by SAS to interact with SCSI disks. Is this correct or incorrect?

A: Introduction: Data may be sent between computers and peripheral devices using Small Computer System…

Q: If we are using AES in CTR mode to encrypt a file of size 232 bytes, how many bits we need to…

A: The correct answer is 832 bits.   Explanation :…

Q: Data bit recording in magnetic discs is based on which property of magnetic material? Please…

A: Magnetic Disk is kind of secondary storage. It is a flat disc with magnetic covering to store…