Compute the support reactions, member end actions and draw shear force & bending moment diagram for the given beam as shown in Fig.2 using flexibility method. Take EI= constant. 10 k 1.5k/ft A B C 15 ft 5 ft 5 ft Fig.2

Q: What is overfire air (OFA)?

A: Overfire Air (OFA) systems are used to redirect an amount of the combustion air away from the…

Q: A drain pipe is to be laid between two points. One point is 13'0" higher in elevation than the other…

A:

Q: Define the term capillary fringe.

A: The capillary fringe is characterized as the saturated zone of water immediately just above the…

Q: tiate between focus and epicenter

A: solution of above problem is below:

Q: Profile Level Notes: The elevation of BM A = 366.65' BS (plus sight) on BM A = 3.85' IFS (minus…

A:

Q: What are the dangers of mezzanines?

A: Mezzanines: A mezzanine is an intermediate level between the floor and ceiling of any story. In…

Q: Describe Ground improvement methods?

A: Techniques known as "ground improvement methods" are applied to improve the characteristics of rock…

Q: 1. Write short notes on Scattering? 2. What is Atmospheric Windows?

A: 1. The phenomenon of waves of light or energy deflects from the straight path when they pass through…

Q: What is the area of the opening of a 7-inch round duct to the nearer tenthsquare foot?

A:

Q: Define about Prefabricated Vertical Drains ?

A: In construction of various structures on compressible, saturated soils like soft clay, excessive…

Q: Would you recommend using the Custom Mercator projection for Ontario? Justify your answer

A: Question Would you recommend using the Custom Mercator projection for Ontario? Justify your answer.…

Q: How to get the vertical clearance on the center and location of the drain cover?

A: Vertical Clearance : The vertical clearance of bridge is the distance measured from road surface to…

Q: Define Horizontal Drainage.

A: Horizontal drainage is a helpful strategy for consolidating soils which are weakened by water…

Q: Define the term Drainage.

A: Drainage is defined as an artificial process of removing excess water from surface and sub-surface…

Q: 1. Determine the x and y of the shaded area shown. Y 60 Ø30.00- 30 30 60

A: Determine the centroid of the given section.

Q: Define Interceptor Drains.

A: An interceptor drain is a type of drain used in drainage system which cut off the horizontal flow of…

Q: Define what is Inclinometer ? Explain the use of Inclinometer ?

A: Inclinometer- It is a device or sensor used to measure the inclination angle of any bent structure.…

Q: Define Exfiltration.

A: Exfiltration in civil engineering is a way to manage the  water collected during and after the storm…

Q: Define types of deep foudations

A: Deep foundations are the foundations and the depth of the foundation is too high relative to the…

Q: What purpose does a sealant backup rod serve?

A: sealant is a substance used to block the passage of fluids through the surface or joints or openings…

Q: What perameters are used for Existing ground level ?

A: Solution: Ground level means the existing level of the site at any of the point. When earth filling…

Q: What is the effective technique for perimeter building waterproofing and drainage?

A: The buildings built in the areas where the water table is high, the areas with marshy lands or due…

Q: Describe the statement unforeseen underground conditions?

A: unforeseen underground conditions These usually refers to the conditions when the underground is not…

Q: flowchart detailing the deisgn of One-way Slab

A: One-way Slab: - It is a slab in which longer span is equal or greater than 2 times of shorter span…

Q: What are the highway culvert design criteria and sizing principles, what risks they are exposed to…

A: Brief concept introduction- Highway culvert- A highway culvert is a drainage system that allows…

Q: Show step by step solution

A: FINAL ANSWER:-       Therefore,the minimum coefficient of friction is 0.2167.Explanation:

Q: Describe the Effects of Drainage.

A: The drainage can be defined as it is an artificial or a natural process of discharging surface and…

Q: Locate the centroid of the shaded area. -12- tat-5²-

A:

Q: Write the problems associated with tunnels development ?

A: Tunnels are civil engineering structures that create an underground passage that may pass through a…

Q: Define Blanket Drains.

A: A blanket drain is a drainage system that is used on the road cut to handle seepage areas.

Q: Define Consolidation Drainage.

A: For coarse substances (sands and gravels) each volume change response to a change for loading…

Q: Determine Coordinates of Centroid of the Following Shaded Area 60 mm 20 mm 60 mm 20 mm

A: The Centroid is the average position of all the points of an object. The dimensions of flange are…

Q: What defines ground water table position?

A: The water table is an underground boundary between the surface of the soil and the region where…

Q: actical Part 5/ Find the Elevation in the point (B). BS 12.64 Elevation 100.00 FS 3.11 TP: BS 10.88…

A: Given data- Elevation of point A=100.00Back sight BS and fore sight FS readings for points are given

Q: STA sa 1.24 BM-a 234.51m TP- 1 1.11 3.40 1+ 00 4.6 1+25 2.8 3.6 1+50 1+75 2.4 TP-2 3.21 2.46 2+00…

A:

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.