Compute the maximum shear . Compute the maximum moment he wall is fxed at the free end Belermine the moment at the foundation Jhe end moment equations at the 30 o and at the base 20

Q: If the gap between C and the rigid wall at D is initially 0.15 mm, determine the magnitudes of the…

A:

Q: 4) Find the magnitude and direction of the resultant force and moment at A 1414.21lb 2.53' -1000lb…

A: To find resultant and moment about point A

Q: Determine the resultant force at pins A, C, and E. Also, determine the forces on pin D. y 80 kN/m 40…

A: in the given beam the transverse loading on the beam both shear force and bending moment my…

Q: A pin connected frame is subjected to a hirizontal force of 240 kN at points C and D respectively.…

A:

Q: 607 mm 605 mm C A B 25.5mm 53 mm f the gap between C and the rigid wall at D is initially 0.153 mm,…

A: Given. The load (P)= 205KN GAP BETWEEN CD =0.153 mm   Our aim is to calculate the support Reactions.…

Q: The equilateral triangles have sides of 2 m. The tops and bottoms of the equilateral triangles are…

A: Given, To find,  A) The Support Reactions.  B) Internal Member Forces.  C) Identify the nature of…

Q: Determine the force in member CG of the truss if P₁ = 107 kN and P₂ = 187 kN. Input tension as…

A:

Q: 6 kN/m 10 kN B 3 m -1.5 m- -1.5m-

A: Joint A  Vertical reaction Va Horizontal reaction Ha Joint C  Vertical reaction Vc Horizontal…

Q: The pin at C has a diameter xx(see table below). Assume that the pin supports at C is stated at the…

A:

Q: Determine the reactions at the pin A and the tension in cord BC. Set F = 40 kN. Neglect the…

A:

Q: he box girder below is subjected to a shear of V=15kN. Determine the shear flow at point B. Give…

A: The magnitude of the shear force on the box girder = V = 15 kN To determine:- a) The shear flow at…

Q: Find the maximum positive force in member KL due to a concentrated live load of 16 kN and…

A:

Q: A uniform live load of 1.8 kN/m and a single concentrated live force of 4 kN are placed on the floor…

A:

Q: 1-67 The beam is supported by a pin at A and a short link BC. If P = 15 kN, determine the average…

A:

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.