Compute the deflection of a structural member made of aluminum if a load of 755 N is applied to the bar. The member has a uniform rectangular cross-section with dimensions of 6 mm x 100 mm, as shown in the accompanying figure.

Q: During the design of a building the deflection of a beam is calculated to be 0.90 inch. In order to…

A: Given, δi = 0.9 in  δa = 0.75 in

Q: A rigid triangular plate is suspended from a horizontal plane by three vertical wires attached to…

A: Diameter = d = 1mm Modulus of Elasticity = E = 196000Nmm2 Length of each wire = L = 1440mm Ratio of…

Q: g) Calculate the magnitude of the maximum bending stress in the beam. Enter your answer in MPa to…

A: Given:Required:Maximum bending stress

Q: 1× aluminium (E=69 GPa) beam with a length of 280mm and cross section of 20x1mm A L/2 +/+ L/2 B P=…

A: 1. Calculate deflection at B in the cantilever beam. 2. Calculate the deflection at B in the propped…

Q: Q4/ if the modulus of elasticity typical of a particular metal wire is (23.4 GPa). Calculate the…

A: E=23.4GPa d=6mm L=2.5m

Q: w Refer to the beam shown. The cantilever beam has a uniform load due to its weight and a tip load.…

A:

Q: Deflection  Given: the beam cross-section shown have the following cross-sectional properties  f'c…

A:

Q: on 333. A member has a cross section as shown in the Figure. The second moment of area (inertia) of…

A:

Q: A rigid bar is supported by a spring as shown in figure below: 50 kN/m B 5m 5m The deflection of…

A: For a rigid bar supported by a spring,To find the deflection of point C

Q: 12. Assume a uniformly load simply support beam with a rectangular cross section. The width of the…

A: Given Data: The width of the both the beams (aluminum and steel) is b. The depth of the aluminum…

Q: Q- Calculate the Poisson's ratio of the bar material if a tensile force of 350 kN is applied to it…

A: Given Tension force = 350 KN Diameter reduce (∆d)= 0.024mm Length increase (∆l)= .85 mm Dimensions…

Properties of Aluminium

Aluminum (or Aluminum) is a silvery-white in color metal. The chemical symbol of aluminum is Al and it has an atomic number (Z) of 13 in the periodic table. The aluminum name for this metal is derived from the Latin word ‘alumen’, which means bitter salt. Aluminum was discovered in the year 1825 by Hans Oersted, and later Friedrich Wöhler isolated aluminum. It is the most commonly found metal in the earth’s core, which is around 8% of the total core mass. Moreover, it is the third most commonly found element on earth after oxygen and silicon. Electron distribution of aluminum per shell is 2, 8, and 3 with a valency of 3. Atomic weight is nearly 26.9815 u.