Component Ibmol/h K-value C3 125 2.056 nC4 200 0.925 nCs 175 0.520

Q: (vi) What will be the ratio of volume of mixed reactor to the volume of P.F.R. (for identical flow…

A: Note: Since you have posted multiple questions, we will provide the solution only to the first…

Q: A throttling steam calorimeter is an instrument used for the determination of the quality of wet…

A:

Q: 46. Air enters a diffuser with a velocity of 200m/s. Determine the speed of sound in m/s at the…

A: Given  Temperature (T) = 38 o C                              = 311.15 Velocity  = 200 m/s

Q: Calculating the entropy change for a composite ;process Calculate the entropy change when argon at…

A: Given:Initial temperature, T1=250C=298 KPressure, P=1 bar=105 PaInitial volume, V1=0.5 dm3Final…

Q: Q.4: A very long cylindrical rod is placed along the positive x-axis with one end at x = The rod is…

A: Given data: Temperature of the rod a cylindrical rod varies with distance and time. Sides of rod are…

Q: the following Question: problems: Use the psychrometric charts to answer I. The wet bulb and dry…

A:

Q: a.What is the approximation of Fick's equation (Hint: the first three terms)! b. A quiescent body of…

A: (a)   The first law of Fick’s gives the relationship between the diffusive flux and the…

Q: a closed, rigid tank contains only water vapor and has a dew point of 50 Celsius. the total mass of…

A: Given, The dew point of water, Td = 50 °C The temperature of the water, T = 70 °C

Q: A pipe (ID: 130 mm, OD: 165 mm, k=15 W/m²-K, Length: 2 meters)is insulated with several materials,…

A: Given Pipe Di=130mm D0=165mm K=15 W/(m2K) L=2m Inside fluid –Oil temperature T1=118℃ Insulation is…

Q: 4-A gas at 250 K and 15 atm has a molar volume 12 per cent smaller than that calculated from the…

A: This question is based on thermodynamics. Data given :  Temperature , T  = 250 K Pressure , P = 15…

Q: The class includes 40 people. Heat loss from the walls of the class, including the glass windows, is…

A: (a) Write the energy balance equation for the system as follows: dEdt =…

Q: A steel tube (k =15 W/ m-°C) whose inner and outer diameter 5 cm and 7.6 cm respectively, is covered…

A: Given Data  The inner diameter  of the steel tube (Di)=  0.05 m  The outer diameter of the steel…

Q: 2.6 A cylinder 10 m high, with a cross-sectional area of 0.1 m², has a mass-less piston at the…

A:

Q: Consider a location where the surface temperature is 27°C and the temperature at a depth of 750 m is…

A: For a detailed solution, please see the attached files.

Q: At the initial state, the pressure and temperature of water vapor in the metal tank were 20 MPa, 520…

A: Initial temperature of water vapor, T1 = 520ºC = 793.15 K Initial pressure of water vapor, P1 = 20…

Q: 1-44 The gage pressure in a liquid at a depth of 3 m is read to be 28 kPa. Determine the gage…

A: Given  h1 = 3m h2 = 9 m P1 = 28 KPA

Q: Imagine gas in a piston – cylinder device. The fluid is compressed resulting to an increase in…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A given calibration liquid is known to have a kinematic viscosity of 24.3 cS at 25°C. Testing this…

A: Write the equation for viscosity as follows: μ = Bρtμρ= Btκ = Bt     ......1   Where, μ is the…

Q: QE/ Consider the flow of a gas with density 1 kg/m³, viscosity 1.5 x 105 kg/(m.s), specific heat Cp…

A:

Q: The equivalent to a 270 degrees Fahrenheit interval in Kelvin is: Answer:

A: Given: T = 270 °F

Q: Cold air flows between two very long parallel plates. The air enters at 25°C. The top plate is held…

A:

Q: A person does 30 kJ work on 2 kg of water by stirring using a paddle wheel. While stirring, around…

A:

Q: Calculate the maximum rate of evaporation in kgs-1 per m2 of surface for water at 20°C into a…

A: The diffusion phenomenon is not considered as there is a perfect vacuum. The water vapor transfer…

Q: Calculating the entropy change for a ;composite process Calculate the entropy change when argon at…

A: Entropy is defined as the measure of a system's thermal energy per unit temperature. In other words,…

Q: Imagine a gas in a piston - cylinder device. The fluid is compressed resulting to an increase in…

A: The force exerted on a moving object or body is called work. This is a boundary phenomenon. The form…

Q: A sealed constant-volume container has 0.8 kg of liquid water and 0.2 kg of water vapor at 0.10 MPa…

A:

Q: 47. Air enters a diffuser with a velocity of 200m/s. Determine the speed of sound Mach number at the…

A: Given, Velocity of air = 200 m/s Air at 30°C have, R =  0.287 kJ/kg.K Specific heat ratio k = 1.4

Q: A client has an airstream that is 150 ºC and at 1 atm of pressure that contains 50,000 ppm of…

A: Given data: Concentration of heptane in air stream = 50,000 ppm Heptane removed = 40 %

Q: Applying the phase rule at point d, F= ? 1.) 1 2.) 2 3.) 3 4.) 0

A: Given Data:  Applying phase rule and given PT diagram. Find Degree of Freedom at point d.

Q: Record the T1 and T2 values. How much energy is required to heat 65.0 g ice to from 0 Celsius to 79…

A: Mass (m) = 65 gm T1 = 0 C = 273 K T2 = 79 C = 352 K.  specific heat capacity = 4.184 J/g.C To find :…

Q: The expansion of a hypothetical closed system takes place at a constant pressure with no change in…

A: First law of thermodynamics for closed system: dQ-dW=dEdQ-dW=dU+dEp+dEkas kinetic and potential…

Q: Determine the specific volume of superheated Refrigerant 134-a at 1.2 MPa and 80 °C, using (a) the…

A:

Q: pressure increase

A: