Answered: Complete the sentence The power factor…

Engineering

Electrical Engineering

Complete the sentence The power factor must be close to will be reduced To insure that losses in the transmission lines

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.9P: For the circuit shown in Figure 2.24, compute the voltage across the load terminals.

See similar textbooks

Related questions

Q: The input power to a 3-phase load is measured as 6700 watts. If the line voltage and line current to…

A: Given information is shown below:

Q: What is load line and what is duty cycle?

Q: 2. When a large shunt capacitor is suddenly connected in parallel with the load bus in the…

Q: Explain why higher the load factor of the power station, lesser will be the cost per unit generated

A: Load factor is the ratio of average load to the peak load during a certain period of time. For a…

Q: Investigate the principles of predictive maintenance in power substations and how it can prevent…

A: Predictive maintenance in power substations is a proactive approach to managing and maintaining…

Q: Mention three reasons behind increasing the voltage to large values during the transmission stage in…

A: The explanation is as follows.

Q: Is it possible to measure the phase-shift angle in an AC single-phase circuit by an indirect method…

A: The electrical circuits have resistance, inductance and capacitance as their elements. In the…

Q: Shunt conductance of transmission line accounts for. losses. Ohmic O Windage O Series voltage drop…

A: Two conductors or transmission lines separated by very small distance ,a shunt conductance is formed…

Q: In a 33 kV overhead line, there are 3 units in the string of insulators. If the capacitance between…

Q: Electricity has composite demand. True False

A: To justify that Electricity has composite demand or not

Q: 1. Explain the reasons for the low power factor in the power system network

A: Power factor (PF) is the ratio of working power, measured in kilowatts (kW), to apparent power,…

Q: a. i. Why do power systems operate in an interconnected arrangement? ii. How is the frequency…

A: The connection of several generating stations in a network of particular transmission voltage level…

Q: * Two generators, rated at 100 MW and 400 MW, are supplying power to a network. The system frequency…

A: we need to tell the value of droop R of the 100MW generator.

Q: For the first question, is the statement true or false: "The load is not absorbing nor generating…

A: It is given that:unity power factor i.e., .

Q: how do we calculate duty cycle?

A: Pulse Width Modulation - PWD Duty cycle: A duty cycle is the fraction of one period in which a…

Q: 10- If power factor is less than unity then it will result in a. Large kVA rating of equipment b.…

A: power factor = RZ

Q: generator operating at 50Hz delivers 1 pu power to an infinite bus through a transmission circuit in…

A: In this question , we wil find critical clearing angle by equal area criteria...

Q: 63 G5 K

A: Definition: Short circuit MVA is equal to its MVA rating divided by its own per unit impedance or…

Q: What are the key factors that influence power quality in electrical grids?

A: Power quality refers to the characteristics of electrical power as it is delivered to consumers.…

Q: Match the items in List - I with the items in List - II and select the correct answer using the…

A: The list in the table,

Q: Unit commitment if the spinnind reserve not there in the power system what will happen?

A: Here we need to conclude what will happen if the spinning reserve is not present in the power…

Q: Determine the Primary Conductor Size (include the AWG size number), Secondary Conductor Size…

A: P= 90 KVA Three phase transformer 400/230 V

Q: One advantages of load balancing is that each phase conductor carries the ? current value

A: We need to tell about advantage load balancing is that each phase conductor carries the equal…

Q: An earth “ground” at the base of the transmission line tower has a resistance of 2W. If a lightning…

Q: The rating of generator is expressed in terms of kVA Select one: True False

A: The rating of generator is in Apparent power kVA.because the power factor is varied for different…

Q: hort term and long term effects of wind energy on power system

A: SHORT TERM AND LONG TERM EFFECTS OF WIND ENERGY ON POWER SYSTEM: 1. The following factors are…

Q: OR e) Explain the following protection schemes of alternators. i) Stator inter turn protection. ii)…

Q: The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine…

A: In this question per unit impedance given on some Mva and kv..We have to find new ou impedance on…

Q: 32. The incremental cost characteristics of two generators delivering a load of 200 MW are as…

Q: Justify only three of the following: (a) low efficiency of the steam power plants, (b) low…

Q: Lighting arresters are used in power system to protect electrical equipment against a. Direct stokes…

Q: Explain the concept of predictive maintenance in power substations and its potential to reduce…

A: Predictive maintenance is a proactive approach to maintenance that leverages data, sensors, and…

Q: 5-A Load of particular kVA is drawing a current which lags behind the voltage at an angle of 75.43…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Complete the sentence
The power factor must be close to
will be reduced
To insure that losses in the transmission lines

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a double-line ground fault occurs at node 5, calculate the currents in the generator. Use VBase = 10 KV (L-L) and sBase = 300 KVA on the node 4 side. The voltage at node 4 is 10 KV.
Differentiate Kirchhoff's voltage law from Kirchhoff's Current law.
In class B chopper, which of the given statement is true The power flows always from load to source The value of On time is always less than Off time The duty cycle is always less one The load current and voltage are always positive Ae Lr Ps Pr Iyp
For the system shown in Figure 3.34. draw an impedance diagram in per unit by choosing 100 kVA to be the base kVA and 2400 V as the base voltage for the generators.
Copper losses in a generator vary with load Select one: O True O False
Two generators, rated at 100 MW and 400 MW, are supplying power to a network. The system frequency is 60 Hz. The load on the system decreases by 160 MW and the frequency rises by 0.5 Hz. What is the droop R of the 100 MW generator? 32 Hz/MW 0.00208 Hz/MW -.004 Hz/MW -0.016 Hz/MW -0.008 Hz/MW
When a loaded generator is supplying power to a motor, a balanced 3-ph fault occur at the terminals of the motor. When using Internal Voltage method Ig =(0.48-j3.24) and when using the Thevenin method Ig=(-0.32-j3.84), then load current has a magnitude of: Answer: Next page uch ch DELL
4 5 A Moving to another question will save this response. Question 4 Shunt capacitors are used for lagging power factor circuits created by the heavy loads on transmission line. O True O False A Moving to another question will save this response. 26°C juao hp f4 2$ 4 & 3 6 - 8 E & R DI F1 GY Hi J C{ 1 :)
is used to prevent debris in the hydro power plant. Tunnel Penstock Surge tank Trash rack
What would be the maximum weight W of the block, shown in the following figure, so that the tension developed in any cable does not exceed 500 N: 30° D 40°7 B D40 DMA
A Moving to another question will save this response. Question 4 What is the approximate value of surge impedance of a power cable ? 400 100 40 1600 A Moving to another question will save this response.
Explain briefly why is there no wattmeter reading when the load is purely capacitive.