Comparators Question The non-inverting Schmitt trigger below is being designed to have a VTH = 4V and VTL=1V. The VOH and VOL are set by the push-pull output to 5V and OV. Calculate the hysteresis voltage, reference voltage, and R2 given that R1 is 10.7k. What is the closest 1% value resistor for R2? R2 R1 VIN VOUT VREF

Comparators Question The non-inverting Schmitt trigger below is being designed to have a VTH = 4V and VTL=1V. The VOH and VOL are set by the push-pull output to 5V and OV. Calculate the hysteresis voltage, reference voltage, and R2 given that R1 is 10.7k. What is the closest 1% value resistor for R2? R2 R1 VIN VOUT VREF

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

i need the answer quickly
please help
The hysteresis voltage UHys of a Schmitt trigger with non-zero reference is calculated as: 23
Obtain the waveform of output states Q and ̅for the D latch when the input condition as in Figure 5 is given. (explain your result)
An op-amp comparator in a firing circuit can produce waveforms at the output of up to 28 V peak-to-peak without any distortion. An inverse cosine-based firing circuit with a voltage range from +14 to -14 (reference voltage) is used to produce a gating signal for the SCR at the desired delay angle. if the reference voltage is 5.92 volts, the delay angle (in degrees) would be:
c) Design (Find the values of R₁ and assume C₁ = C₂) timer 555 IC as a monostable multivibrator circuit to have a pulse waveform output as shown in the below figure. R1 C1 9 Vcc C2 10nF 4 6 555 5 ovo tH = 0.001 sec
if you design differentiator to differentiate input signal varies in frequency between 1 KHz and 20 KHz then find. Cutoff frequency=.......... 01000 O2000 03000 04000