club to modelThe setup shown was built by theamany simultaneous principles learned in Dynamics class.When the rope is at an angle of a = 35°, sphere A (mA = 2.5kg) has a speed vo= 0.75 m/s. The coefficient of restitutionbetween A and wedge B (m³ = 7 kg) is e = 0.8 and the lengthof rope / = 1.15 m. The spring constant has a value of k = 450N/m and 0 12º.wwwDetermine:a.) the velocities of A and B immediately after the impact,b.) the maximum deflection of the spring, assuming A does not strike B again before this point.

Given DatamA=2.5 kgmB=7 kgVo=0.75 m/sα=35°e=0.8l=1.15m

club to model The setup shown was built by the many simultaneous principles learned in Dynamics class. When the rope is at an angle of a = 35°, sphere A (m₁ = 2.5 kg) has a speed vo= 0.75 m/s. The coefficient of restitution between A and wedge B (mB = 7 kg) is e = 0.8 and the length of rope / = 1.15 m. The spring constant has a value of k = 450 N/m and = 12º. www Determine: a.) the velocities of A and B immediately after the impact, b.) the maximum deflection of the spring, assuming A does not strike B again before this point.

club to model The setup shown was built by the many simultaneous principles learned in Dynamics class. When the rope is at an angle of a = 35°, sphere A (m₁ = 2.5 kg) has a speed vo= 0.75 m/s. The coefficient of restitution between A and wedge B (mB = 7 kg) is e = 0.8 and the length of rope / = 1.15 m. The spring constant has a value of k = 450 N/m and = 12º. www Determine: a.) the velocities of A and B immediately after the impact, b.) the maximum deflection of the spring, assuming A does not strike B again before this point.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Two bodies, A and B, weighing 50 kg and 25 kg, respectively, are connected to each other by a rope mounted on a pulley without friction. Five seconds after the body system is released from equilibrium, body B descends at a speed of 10 m / s. Calculate Body acceleration A (a), cable pull force S and coefficient of friction A across the ground (u).
5. The coefficient of static friction between the flat bed of the truck and the crate it carries as shown in Figure 5 is µ, = 0.30. (a) Set up the appropriate global axes system and draw the free body, kinematic and kinetic diagrams of the crate on the bed. (b) Determine the maximum acceleration amax and hence the maximum velocity Vmax which the truck can acquire from rest in a distance of 50m up a 10-percent grade if the crate is not to slip backward. (c) If the truck was travelling on a horizontal road with the maximum speed you have determined in part (a) above, would the minimum stopping distance be different than 50 m as given above if the crate is not to slip? Give a brief engineering explanation in support of your answer. 10 Figure 5
A spherical bowling ball with mass m = 4.6 kg and radius R = 0.105 m is thrown down the lane with an initial speed of v = 9.5 m/s. The coefficient of static friction between the ball and the ground is 0.35 and the coefficient for kinetic friction is μ = 0.3. Once the ball begins to roll without slipping it moves with a constant velocity down the lane. 1) What is the magnitude of the angular acceleration of the bowling ball as it slides down the lane? 2) What is magnitude of the linear acceleration of the bowling ball as it slides down the lane? 3) How long does it take the bowling ball to begin rolling without slipping? 4) Once it begins to roll without slipping, what is the force of friction on the ball?
Problem 2 A load is to be raised 12 ft by the hoisting system shown, developed by ASCE Club students to lift various loads to the ceiling of the Construction Materials Laboratory. Assume gear A is initially at rest, then accelerates uniformly to a speed of 110 rpm in 5 s, and then maintains a constant speed of 110 rpm. Gear A has radius A 4.0 in, gear B has radius B = Drum C rotates with gear B. = 22 in, and drum C has radius rc = 18 in. Determine: (a) the number of revolutions executed by gear A in raising the load, (b) the time required to raise the load to 12 ft. TB B с Load rc
Problem 1. Find the horizontal force magnitude P needed to start the motion of the block with mass mo in two scenarios: (a) when P is applied to the right and (b) when P is applied to the left. Develop a general solution for each scenario, and subsequently, substitute the values 0= 25°, m = mo = 2.5 kg, µs = 0.40, and μk = 0.35 into your expressions for evaluation. Hgs H k P (a) A mo 0 m P (b) B
View Available Hint(s) VOAZO If vec F, N = N Figure 1 of 1 Submit Provide Feedback Next > F 國
Learning Goal: Use the general equations of motion for plane motion to determine the initial acceleration of a spool. A spool has an outer radius R = 380 mm, an inner radius r = 210 mm, a mass m = 90 kg, and a radius of gyration KG = 320 mm. A rope is wrapped around the inner radius and pulled to the right as shown in (Figure 1). The coefficient of static friction between the spool and the ground is us = 0.2. The coefficient of kinetic friction is k = 0.15. Figure R A P 1 of 1 Part A Draw the free-body diagram for the spool, assuming the friction force acts to the right. Draw the vectors, starting at the black dots. The location and orientation of the vectors will be graded. The length of the vectors will not be graded. + 0 No elements selected Select the elements from the list and add them to the canvas setting the appropriate attributes. Submit Request Answer
Figure 2 В A Block A is hanging from a massless string which runs over a massless and frictionless pulley and connects to Block B. Block B slides over an inclined plane with ordinary kinetic friction. The plane under block B is inclined at an angle theta = 0 away from vertical. The other side of Block B is connected to another massless string which runs over another massless and frictionless pulley to connect to Cart C. Cart C rolls without friction over a plane which is inclined at an angle of phi = y away from vertical. C
PROBLEM NUMBER 2 DYNAMICS THE CIRCULAR PACKAGE (B) AND THE BOX PACKAGE (A) SHOWN BELOW HAS AN IDENTICAL MASS OF 2.70 kg. IF THE COEFFICIENT OF KINETIC FRICTION BETWEEN BOX A AND THE CONTACT SURFACE IS 0.15. CALCULATE THE ACCELERATION OF BOX A IF THE CIRCULAR PACKAGE MOVES DOWN WARD A 34°
Show complete solutions. Please draw the figure or the illustrations. Problem:Two horses are pulling a barge with mass 2000 kg along a canal, as shown in the Figure. The cable connected to the first horse makes an angle of 30o with respect to the direction of the canal, while the cable connected to the second horse makes an angle of 45.0o. Find the initial acceleration of the barge, starting at rest, if each horse exerts a force of magnitude 600 N on the barge. Ignore forces of resistance on the barge.
loold Question 5 Given, at the instant 0 = 60°, the boy's center of mass G is momentarily at rest. The boy has a mass of 60 kg. Neglect his size and the mass of the seat and cords. Find: The boy's speed and the tension in each of the two supporting cords of the swing when 0 = 90°. %3D V : 5 .13 msnoio 10 ft T 373.25N den bavom et A nerk AV bnit HA nsrkw -G
5) A block weighing 50 lb is shown on an inclined surface. The block is released from rest at the po- sition shown. The spring has a spring constant of k = 10 lb/in., and the coefficient of friction be- tween the block and the incline is 0.3. What is the maximum compression of the spring? 6) For the system in Question 5, what is the velocity of the block the moment it leaves the spring? 50 lb 10' 30° K www. Page 1 of 2