9 ft- Problem 3. The frame that supports the 1000 lb anvil consists of members ABCDE, A 3 t B 1 ft CFG, and DF; the pulley with center G; and the cable. Determine: (a) the forces that pins C, F, and G exert on member CFG; (b) the forces that pins B, C, and D exert on member ABCDE; and (c) the reactions that pin A and roller E exert on member ABCDE. C 3 ft 3 t E

Q: Please solve the whole problem and show all work

A: Step 1Step 2From equation 1, we can say that Ay​=−Ey​ Ay​=30k units in downward directionAccording…

Q: Determine the componets of the reactions of the beam, Please show all work

A:

Q: 2-21. Determine the reactions at the supports A and Ros the compound beam. There is a pin at C. 4…

A: To Find :- reactions at supports A & B.

Q: 2. The uniform plate has a weight of 400lb. Determine the tension in each of the supporting cables,

A:

Q: Prove if the truss below is determinate, stable, or unstable. P is 3 Kips. Assume A and D as pin…

A:

Q: 0.15 m 0.4m 0.2 m 03 m 0.5 m 0.25 m 0.2 m

A: The position vectors and unit vector are as follows: rCD=(-0.2i-0.3j+0.25k) munit…

Q: nt B of each force Olb F3 = 160 lb 4-5. Determine the moment of each of the three forces about point…

A:

Q: As shown below, the compound bream is fixed at A and supported by a rocker at B and C. There are…

A: Step 1:Step 2:Step 3:

Q: The 7/8-in.-diameter pins at A and C that support the structure are in single shear. Find the…

A:

Q: 3) Determine reactions at the supports of the structures shown below. A 6 kN B |--2 m2 m2 m -——3 m-…

A: Given:Required:Support reaction

Q: ight acting Id in equilibrium E has been ing and does not Y 2 ft the hinges and B 3 ft 2 ft 10='V D…

A:

Q: Rigid bar ABC is supported by a pin at bracket A and by tie rod (1). Tie rod (1) has a diameter of 5…

A: Given:

Q: 3) Determine the force in member A 10 ft. И И 10 ft. 17 ft. Member A 8 ft.5 ft.-- 10 ft. 1000 lbs.

A: Given:Required :Force in member A

Q: Classify each of the structures as statically determinate, statically indeterminate, or unstable. If…

A: Kindly Note: As per our company guidelines we are supposed to answer the first three sub-parts.…

Influence Lines

The graphs that show the variation of a function at a specific point on a beam or truss due to a unit load placed at any point along the structure are known as influence lines in engineering. Some common functions that are studied with influence lines are shear, moment, and deflection. In designing beams and trusses, it is important to use influence lines in structures where loads would move along their span such as bridges, crane rails, conveyor belts, floor girders, etc. The influence lines help to study where a load will create the maximum effect for any of the functions.