Chlorine is used to disinfect swimming pools. The accepted concentration for this purpose is 1 ppm  chlorine, or 1 g of chlorine per million grams of water.  Calculate the volume of a chlorine solution (in  milliliters) a homeowner should add to her swimming  pool if the solution contains 6.0 percent chlorine by  mass and there are 2.0 × 104 gallons (gal) of water in  the pool (1 gal = 3.79 L; density of liquids = 1.0 g/mL).

Q: Determine the height of the fluid inside a manometer that is attached to a CO2-filled tank The…

A:

Q: A sodium hydroxide solution is standardized by titrating 0.8592 g of ordinary standard potassium…

A: Given, Mass of potassium hydrogen phthalate, m = 0.8592 g Molar mass of potassium hydrogen…

Q: Consider a sphere shaped naphthalene (CH) having a radius of 20 mm suspended into a large volume of…

A: Answer:Part (a): Calculate the Rate of Evaporation of NaphthaleneDetermine the molar mass of…

Q: A wastewater sample with a DO content of 1.4 mg/L is diluted with deionized water with a DO content…

A: DO of waste water sample = 1.4 mg/LDO of diluted water = 8.8 mg/LDO after mixing = 7.8 mg/LA)…

Q: Calculate the pressure in the natural gas pipeline (shown in figure below) in psia. Density of water…

A:

Q: The electrolyte in automobile lead batteries is a 4.04M sulfuric acid (H2SO4). Calculate the mass…

A: Given Data: Molarity of Sulfuric acid ( H2SO4) = 4.04M Density of the solution = 1.161 g/ml Formula…

Q: 5. For the general balance equation under what conditions will the balance take the simple form…

A: The balance equation, a fundamental concept in engineering, can be simplified to "input = output"…

Q: your

A: Given: The wavelength of Radiation = 459 nm Work Function of Metal = 4.5 eV

Q: An electrolysis cell that deposits copper (from Cu2+ ions) operates for 30 minutes at an electric…

A: Given that: Copper is deposited from Cu2+ ion by electrolysis cell. Time taken, t = 30 min = 1800 s…

Q: What units must the constant 0.644 have? = What should be the value of the constant when all units…

A: following expression is given in the question h=0.644k0.67vp0.5 cp0.33D0.5 μ0.17        1unit of…

Q: Calculate grams of iron that are required to make 3.00 L aqueous solution containing 9.00% iron…

A:

Q: The C-C stretch in allene (H,C-C-CH2) is about 1650 cm"; the C-H stretch is about 3,100 cm".…

A:

Q: A solution is prepared by adding 118 g of lactose (milk sugar) to 176 g of water at 55 °C. The…

A:

Q: Consider the volume vs temperature graph below of an unknown 36.00 mL alcoholic mixture:…

A: To determine the percentage alcohol content of the alcoholic mixture whose temperature-volume…

Q: If the thermometer reads 15C (wet bulb temperature, T₁ = 15C), use the heat-mass transfer analogies…

A:

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the…

A: mass of product=100g product has one-third of water by mass the ratio of solid and preservatives=4:5…

Q: CMC of a surfactant in water at 25 oC is 0.5 g L−1 and at 45 oC is 0.3 g L−1. The molar mass of the…

A:

Q: • Calculate the time required for 80% sublimation of a sphere of naphthalene (diameter : 15mm) in…

A: This system is a volatile solid sublimation time. The expression to obtain the time contains the…

Q: Calculate the de Broglie wavelength associated with an oxygen atom traveling at the speed of 162  in…

A:

Q: At 25oC, a hydrocarbon mixture composed of two volatile fluids, 73.0% o-xylene (vapor pressure =…

A: Total pressure(P) = XO-xylene PO-xylene + Xtoluene Ptoluene                           =…

Q: Complete the question by hand calculation(please show every step):- Do the mass balance and energy…

A: The following syngas gas conditions and composition are givenComponent Composition (mol%)Carbon…

Q: An industrial slurry of density 3000kg/m3, per m3 of water and containing 300kg of calcium…

A: given- calcium carbonate(precipitated)=300kg density of calcium carbonate(precipitated)=3000kg/m3…

Q: Limestone (calcium carbonate) particles are stored in 50-L bags. The void fraction of the…

A:

Q: 100 kg of a mixture of sodium sulfate crystals (Na,SO, – 10H;0) and sodium chloride (Nacl) is heated…

A:

Q: When conducting an experiment of Nadsorption on a sample of coal at 77 Cand in the absence of…

A: N2 gas is adsorbed in the surface of coal. The pressure versus specific volume data for the…

Q: 2. To prevent the presence of air, noble gases are placed over highly reactive chemicals to act as…

A: given: mass of helium=5.50 g mass of krypton=35 g molecular weight of helium=4.0 g/mol molecular…

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the…

A: Basis mass of solid supposed= x g Given that-  Product residue= 100 g Feed contains, Solid= 15% by…

Q: The food product containing 55% water is made at the rate of 250 kg/hr. You need to dry the product…

A: Given that, The mass flow rate of the feed F = 250 kghr % of the water in the feed xF = 55% = 0.55 %…

Q: A hydrocarbon has a MW of 114 g/mol and has a composition of carbon 84.06% and hydrogen 15.94%. What…

A: Given: Molecular weight = 114 For 100g of the compound,  C = 84.06g H = 15.94g

Q: Atmospheric (1 atm) air with a relative humidity of 40% blows over a smooth, wet flat plate. The…

A: Pressure =1 atm Relative humidity = 40 % Length of plate = 0.6 m Width of plate = 3 m Free stream…

Q: A laboratory technician is asked to prepare a 15 L solution of potassium chloride (KCl) with a…

A: Volume of the KCl solution = 15L = 15000 mlMolarity, M = 0.2 mol/Lgram molecular wt. of KCl, m =…

Q: The density of X metal was found to be 6.84 g/cm 3 , when X crystalizes, it forms face- centered…

A: Given, Density of metal X, ρ = 6.84 g/cm3   Calculate the mass of unit cell as follows: mass of unit…

Q: Practice Problems 1. Express a pressure of 2.00 x 105 Pa in terms of (i) mm Hg and (ii) lb/in²…

A: Since you have posted multiple questions but according to the guiedlines we can solve only one…

Q: Using sodium carbonate as the primary standard, a solution of hydrochloric acid was analyzed using a…

A: Mass of Na2CO3 reacted in the procedure, mNa2CO3 = 0.356 g Volume of HCl used, VHCl = 24.22 mL Molar…

Q: O Calculate the number of grams in 13.4 L of chlorine gas (Cl2) at STP.

A: Chlorine gas: Chlorine appears as a greenish yellow gas with a pungent suffocating odor.  Toxic by…

Q: A water droplet having a diameter of 0.10 mm is suspended in still air at 320K, 101 kPa, and 20%…

A: Data given: Radius of droplet=R= 0.05 mm, DAB=0.220 cm2/s, Temperature, T=320K, Pressure, P= 101…

Q: Calculate the average density (in g/cm) of 30 wt% Ammonium Sulfate solution given that the pure…

A: Ratio of mass of system or component with its respective volume gives us density of the system or…

Q: Bovine serum albumin (BSA) is a biochemically useful protein. A 0.376 g sample of bovine serum…

A: In thermodynamics, the equation of state is described as a thermodynamic equation which is relating…

Q: Calculate the molarity of NaOH (40 g/mol) solution if 12.25 mL was used to titrate 0.2615 gram of…

A: The molarity of NaOH is to be determined for the given solution.