Can you recheck the plastic section modules here (Zx)

Q: We would like to increase the yield strength of the bar through cold work. (a) Using the Copper…

A:

Q: Discuss the classification of cross sections as per the IS 800: 2007 based on yield and plastic…

A: The objective of the question is to understand the classification of cross sections as per the…

Q: Discuss the classification of cross sections as per the IS 800: 2007 based on yield and plastic…

A: The objective of the question is to understand the classification of cross sections as per the…

Q: A steel [E = 200 GPa] rod with a circular cross section is 11 m long. Determine the minimum diameter…

A: Allowable stress=170 MPaForce=230 kN = 230000 NStress=ForceArea170=230000π4×d2d=41.5 mm

Q: What did you use for the axis y is the % finer but what is the x axis axis

A: Given:Required:Give the name of x and y axes used in the graph.

Q: (a) determine the average shear stress and shear strain in each of rubber blocks (b) determine the…

A:

Q: A 10 inch long silver wire is stretched to a total length of 11.50 inches. Find the value of strain

A:

Q: Calculate quantity of the Reinforcing for the beam shown in figure below. A 0.3 m 3.2 m 2016 08 @…

A:

Q: 0.5 mm 350 mm - Bronze A = 1500 mm² E = 105 GPa x = 21.6 x 10-6C 450 mm Aluminum A = 1800 mm² E = 73…

A:

Q: Distinction between the semisolid and the solid state.

A: The semi-solid state and solid state of soil are shown in the atterberg curve is shown below.

Q: e beam is made from a material that can safely support a tensile or c Based on this criterion,…

A: Reactions :∑ MB=0RA1.6-F1=0RA=FA1.6Max moment :MMax=RA1=FA1.6  kN-m

Q: Which of the following options are correct for the section shown in figure? 40 mm 100 mm 100 mm…

A: Given data, To find the  (a)elastic section modulus (b)Shape factor

Q: What is the approximate value of the tensile strength governed by yielding of the cross- section of…

A:

Q: The aluminum shell is fully bonded to the brass core, and the assembly is unstressed at a…

A: Given Data:Temperature of 78°FChange in Temperature = 210°FBrass…

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.