Can I get a step by step for this question? Using the data presented for the given soil sample, determine the soil classification using the ASTM and the AASHTO Soil classification system. Give the group index if needed. The soil is inorganic soil. Sieve No. 19mm (¾ in.) 12.5mm (1/2in.) No. 4 (4.75 mm) No. 10 (2.00 mm). No. 20 (0.850 mm) No. 40 (0.425 mm) No. 100 (0.150 mm) No. 200 (0.075 mm) Percent Passing 100 83 67 56 54 45 39 36 Cu: 5.5 and Cc: 1.8 Atterberg limits: Liquid limit: 20%, Plasticity Index: 6%

Q: draw the particle size distribution curve for the given table using excel.

A: To Determine draw the particle size distribution curve for the given table using excel

Q: EXERCISE 2 Results from a grain-size (sieve) analysis of a given soil are tabulated below. The soil…

A: Given, Sieve analysis data  LL = 23% PL = 19%

Q: If soils cumulatively retained on sieve #4 is 68%, then the percentage of soil classified as sand,…

A: Based on the cumulative retention on sieve #4, we need more information about the particle size…

Q: Classify the soil according to ASTM-CS

A: The soil is classified into fine-grain soil or coarse grain soil based on the soil passing through…

Q: Soil 1 Diameter or Sieve No. Mass Retained Soil 2 Diameter or Sieve No. Mass Retained (g) (g) % in ½…

A: American Association of State Highway and Transport Officials (AASHTO) and Unified soil…

Q: 3. The sieve analysis data for a granular soil are given below. %passing 19mm sieve = 100 %passing…

A: Step 1

Q: EXERCISI Results from a grain-size (sieve) analysis of a given soil are tabulated below. The soil…

A: Given information, WL = 23% P.L = 19%

Q: A soil sample with the following composition by weight  45% Silt, around 15% Gravel and rest Sand,…

A: Sand: It is the most commonly utilised construction material. It is composed of rock fragments as…

Q: What is dry unit weight of the soil sample below (va) in Ib/ft ? The combined weight of a mold and…

A: Given data : Combined weight of mold and compacted soil sample (W1)=8.7 lbMold weight (W2)=5 lbmolds…

Q: GEOTECHNICAL ENGINEERING: The resuts of a sieve analysis for a soil sample are given in the table.…

A: The data given is:  Cc = 2 Cu = 6 LL = 20 PL = 14 % passing through 4.75 mm sieve = 95 % passing…

Q: A sample of soil was tested in the laboratory, and the test results were listed as shown in the…

A: As percent passing No. 200 (58.8%)is more than 36%, the soil is either A4,A5,A6 or A7 depending on…

Q: Classify the following soils by the AASHTO classification system

A:

Soil classification and characteristics

Soil classification is a method of categorizing soil based on its properties, types, and uses. The motive of soil classification is to arrange various types of soils and divide them into groups for various engineering and agricultural purposes. Soil classification is carried out by various agencies as per their purposes. From an engineering perspective, soil classification is done to find out the suitability of soil for various construction purposes like the construction of dams, foundations, highways, infrastructures, and so on. For engineering purposes, the soil is classified by the following systems: