Answered: Calculate the voltage at the terminals…

Calculate the voltage at the terminals of a coil of resistance 10 ohms and inductance 15H at the instant when the current is 12A amd increasing at the rate of 6A/sec.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: 4. An Impedance Coil has a resistance of 7.5 ohms and an inductive reactance of 18 ohms (connected…

Q: Q.1 Two coupled coils have K = 0.5, N₁ = 250 turns, N₂ = 500 turns and the mutual flux being 0.7 Wb.…

A: Given- Two coupled coils- K=0.5, N1=250 turns, N2=500 turns, Mutual flux=0.7 Wb, Primary coil…

Q: Based on Figure Q1(a), identify the equivalent inductance seen at the terminal of a and b. [4 marks]…

Q: An inductor of value 5.6 H is connected across 240 V, 109 Hz supply. Then the value of inductive…

Q: Q20. A circuit comprises a coil of inductance 15mH and resistance 102 in series with a variable…

A: The solution for the given series RLC circuit is done below.

Q: if the area of each p former oil.

A: Since you have asked a multiple question we will solve the first question for you, If you want any…

Q: When an impedance coil is connected to a 100 V, 60-Hz, ac supply, the circuit current is 1 A. When…

Q: A non-inductive resistor is connected in series with a coil across a 230V, 50Hz supply. The current…

A: Let 'R' be the non inductive resistor and a coil with resistance 'r' and inductance 'L' may be all…

Q: An air filled parallel-plate capacitor is connected to a 12 Volts battery, the battery is…

A: Given V=12VC1=7.3 nCd1=8 cmd2=3 cm

Q: A 0.4-mF capacitor has a charge of 20 mC. How much is the voltage across it?

Q: 10 A Capacitor istores 0124 Cat volts. Its Capacitance is ? A

A: It is given that:

Q: A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the…

A: In this question, We need to determine final value of current, current after 4ms and 6ms. We know,…

Q: What is the value of the induced voltage of the self-inductance when the rate of current is from 200…

A: First, find the rate of change of current, didt=20μ-200μ5u=-36 A/s Let the self-inductance of the…

Q: The sinusoidal ac source in the figure has an rms 20 value of V. Considering all possible values of…

A: Solution is explained down !!

Q: 5. An industrial coil has a resistance of 32 ohms and a reactance of 24 ohms and rated 440 volts at…

A: Given data, Resistance R=32 Ω. Inductive reactance XL=24 Ω. Frequency f = 60 Hz.

Q: AC 15. What would the equivalent resistance be of a 159 uF capacitor? 16. What is the RMS voltage of…

Q: The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True…

A: Due to guidelines we can solve one question at a time.

Q: A coil has resistance of 5 ohm and inductive reactance of 4 ohm. a) what is the impedance of the…

A: This question belongs to circuit theory . It is based on the concept of impedance and admittance of…

Q: A capacitance is rated 100 kVar, 380 volts, 50 hz. What will its rating be at 60 Hz 220 V?

A: This question belongs to circuit theory . It is based on the concept of calculation of rating of…

Q: The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True…

A: Concept of CRO CRO is called as Cathode Ray Oscilloscope. The main component of CRO is Cathode Ray…

Q: A self-inductance of 10 mH and its resistance 50 connect to AC source of voltage 200 V, and…

Q: 1. A coil has a resistance of 18 ohm when its mean temperature is 20 °C and of 20 ohm when its mean…

Q: A generator rated at 30MVA, 11kV has a reactance of 40%. Calculate its p.u. reactances for a base of…

A: Per unit values will be found by using 1. Base and actual values 2.old and new base values if old…

Q: 3. For a parallel circuit of 20 ohms resistor and a 10 ohms inductor, is connected to a 110/60 cps…

A: We need to find out current for given circuit

Q: A series circuit conducting of a 30-uf capacitor and a 0.155-henry inductor is connected to a…

Q: A coil has a resistance of 75 ohms and an inductance of 1.4H. When the applied voltage is 240V, at…

Q: If i have a coil with an inductance 0.14 H and a resistance of 12ohm is connected across a 110V ,…

A: In this question we discuss about how to make the current through coil and supply voltage in phase

Q: Determine the equivalent inductance of the network below if all inductors are 6 mH. Answer Round off…

Q: A coil draws 1875 watts when connected to a 165 V dc source. It consumes 30.72 watts when use on a…

A: I have checked every calculation but not getting 39 mH but my solution is 100% correct. There may be…

Q: 2. Using a Square function with 90,000 Hz in your function-generator, a 1000-ohm resistor, and a 1…

A: Need to determine the charging time for the capacitor and the same should be verified using the…

Q: Q5: Two capacitors (2ª F, 8 µF) are connected in series across 100 volt. Then these capacitors are…

A: As per the guidelines of Bartleby we have to solve first question only for remaining questions we…

Q: A relay has 12 ohms resistance, and a 2.4 H inductance is suddenly switched across 120 volts supply…

A: it is asked to find the instantaneous current after 0.1 second for given relay

Q: An e.m.f. of 16 volts is induced in a coil of inductance 4H. The rate of change of current must be…

A: Given; EMF induced vL=16 V Coil inductance L=4 H

Q: The diagram shows an inductor that is part of a circuit. The direction of the emf induced in the…

Q: A coil has a resistance of 18 when it mean temp is from 20o C to 50o C. Find its mean temp rise when…

Q: Draw block diagrams for each of the following elements, first voltage as input and current as…

Question

Calculate the voltage at the terminals of a coil of resistance 10 ohms and inductance 15H at the instant when the current is 12A amd increasing at the rate of 6A/sec.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
If i have a coil with an inductance 0.14 H and a resistance of 12ohm is connected across a 110V , 25Hz source. how would you make the current in the coil and the phase between the cirrent and supply voltage ?
Draw block diagrams for each of the following elements, first voltage as input and current as output, and then vice versa: a. resistance, b. capacitance, c. inductance.
A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the final value of current, the value of current after 4 ms, the value of the voltage across the resistor after 6 ms, the value of the voltage across the inductance after 6 ms, and the time when the current reaches 15A.
How much is the inductance of a coil that induces 500 V when thje current changes at the rate of 5 mA in 2-µs?
4
ANSWER COMPLETELY WITH CLEAR SOLUTIONS
In the circuit shown, Determine the following: a) The equivalent reactance and its nature (inductive or capacitive). b) The voltage across each inductor and capacitor. c) The equation of the current. d) The impedance of the circuit.
fast and right please
25/ Identify the statement from the following when the inductance can have low value. a. If the number of turns of the wire is less b. If the cross-sectional area is lesser c. If the length of the wire is longer d. All the given options
The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True O False The sinusoidal current waveform having the maximum value of 30 A then the R.M.S value is Three coils each having resistance of 29 n are connected in star across 436 V, 50 Hz supply. Then the total power consumed is O 19665.10 W O 3784.66 W O 755.20 W O 226.05 W
5. An industrial coil has a resistance of 32 ohms and a reactance of 24 ohms and rated 440 volts at 60 Hz. Assume the reactance is consisting of inductor. What is the value of the inductor in henry? Ans. 0.06 H