Calculate the total head of the system below. Assume a flow of 70 m³/h and that the pressure drops in the suction and discharge are 3 m and 4 m, respectively. ZA = 15m, ZB = 5m and ZC = 5m. Please, type resolution, as handwriting interferes with understanding!

Q: What are the liquid and vapor flow rates for the bottom and distillate streams

A:

Q: width and 5 m A horizontal square wooden rod, 2 m long. 0.2 m head width is hung and fixed at the…

A:

Q: Manometeri is being used to indicate the pressure difference between two point. Calculate the volume…

A:

Q: Water flows in a pipeline composed of 75 mm and 150 mm pipe. Calculate the mean velocity in the 75…

A:

Q: Example 7.2: A simple U-tube manometer is installed across an orifice meter. The manometric fluid is…

A: U tube manometer is the simplest pressure measuring devices and are used for measuring low pressure…

Q: On a circular pipe there are different diameters: diameter D1= 2 m changes into D2 = 1.5 D1. The…

A:

Q: air h, h, water

A: Given Density of water ρw =1000 kg/m3 h1 = 60 cm h = 45 cm h2 = 180 cm Find-Difference of…

Q: Q3) Water flows through a 10-mm diameter pipe at a flow rate of 1.33×104 m³/s. Find (a) Velocity (V)…

A: As water is flowing through the pipe with a flow rate of Q. Reynold's number is the dimensionless…

Q: Estimate the friction factor for a flow with a Reynolds Number of 1,203. Enter your answer in…

A: Friction factor for flow having Reynolds no. 1203 needs to be calculated.

Q: as repeating variable. Determine a suitable set of dimensionless parameters in FLT system and check…

A: Anything which can be measure is expressed in terms of dimensions using physical properties.…

Q: A Coriolis is an example of a flowmeter that measures the mass flow rate through a conduit. O True O…

A: We have to answer about the Coriolis and its use.

Q: Air (y = 0.075 lbf ft3) is flowing as in figure. If u = 13.9 ft s and the centerline velocity, vc =…

A: Given : Density of air = 0.075 lbf / ft3 Velocity ( V1 ) = 13.9 ft / sec Velocity ( V2 ) = 15.7 ft /…

Q: Water is flowing inside the pipe shown in the sketch below. A Venturi meter equipped with a…

A: Given thatdp =12 cmdt = 6 cmh =4.5 cm

Q: Question 3 The average volumetric flow through an open rectangular duct can be estimated using the…

A:

Q: 4. Initially filled with water, a conical reservoir is 24 ft deep and 12 ft across the top. Water…

A: The orifice is a small hole or space in any flowing fluid system. An orifice meter is using to…

Q: As flow meters, these devices mechanically divide a fluid stream into discrete, known volumes and…

A:

Q: Water at 20°C flows in a cylindrical pipe with internal diameter of 2 cm. At what critical fluid…

A:

Q: A straight pipe with an expansion in pipe from 6 to 11 cm transports water at a rate of 0.011 m /s.…

A:

Q: . I change my experiment around a bit, so that it will allow me to change the viscosity of the fluid…

A: a)Reynolds number is given as Re=ρuDμ Where ρ- Density of fluid μ- Dynamic viscosity u- Average…

Q: Determine the fluid speed at the origin

A: Velocity Field (V) = (5z-3)i^ + (x+3)j^ + 4yk^ At origin= (0,0,0)

Q: 1. What is the net force acting on a car cruising at a constant velocity of 70 km/h (a) on a level…

A: Given that  constant velocity = 70 km/h  we have to find the net force acting on a car cruising on a…

Q: 5.1-2. Frictional Pressure Drop in a Flow of Olive Oil. Calculate the frictional pressure drop in…

A: Olive oil density and viscosity at a given temperature are obtained. The Reynolds number is…

Q: Pressure is expressed as the equivalent O True O False height of a fluid column.

A: Pressure is defined as the ratio of force acting per unit area. P = ForceareaP = mgA

Q: parallel piping hor. plane. pipe consists of two pipelines, i.e. Pipe 1 and Pipe 2. Pipe 1 is 60 m…

A: As per Bernoulli's equation applied between points A and B,PAγ+VA22g+ZA=PBγ+VB22g+ZB+hL1Neglecting…

Q: A Poiseuille flow experiment was carried out to measure the viscosity of air at 298 K. The sample…

A: Given data: Length of tube; L=100 cm=1 mInternal Diameter; D=1 mm =0.001 mRadius; R=0.0005 mP1=865…

Q: 2. Air flows from left to right through a duct with a constriction in the middle as shown below.…

A:

Q: Water -Bo C CC14 D 2B.9 Analysis of a capillary flow meter. Determine the rate of flow (in lb/hr)…

A: Diameter of the capillary = 0.01 in Density of the manometric fluid, CCl4 = 1.594 g/cm3

Q: There are two identical pipes one carries water and the other carries air. Initial velocities are…

A: In fluid dynamics, turbulent flow is defined as a fluid motion characterized by chaotic changes in…

Q: Sea water flows through a cast iron pipeline having a diameter of 'd' m. The volumetric flow rate is…

A: The Pressure difference, viscosity and the density of the fluid is:

Q: Laminar fluid flow in a wide rectangular slit is described by the velocity field equation shown…

A: Write the continuity equation as follows: dρdt+ρ∇·V→ = 0 For a fluid to be incompressible, rate of…

Q: Two mercury manometers, one open-end and the other sealed-end, are attached to an air duct. The…

A: Given data:For sealed end manometer ,The reading(h) on the sealed-end manometer is 789 mm. For open…

Q: 6. Compute the hydrostatic pressure (psi) that a drilling mud with relative density equals 1.4…

A: The hydrostatic pressure exerted by a fluid at a certain depth is given by the formula: P = ρgh…

Q: A jet of water flows from a 4-in diameter nozzle such that the velocity at point 1, the top of the…

A: Given Data; Steady Flow Diameter of Nozzle; D1 = 4 inches=0.1016 m Diameter of Pipe; D2= 6 inches=…

Q: True or false: Osmotic pressure can be explained by the difference in fugacities

A: It is to be mentioned whether fugacity difference explains the osmotic pressure or not.

Q: Q5:Air flows inside pipe 12 cm diameter with mass flow 1.5 kg/min. 1-Is flow laminar or turbulent?…

A:

Q: 2) Both ends of the nozzle with an inlet cross-sectional area of lx10-S ft² and an outlet cross-…

A: In fluid mechanics, Bernoulli's theorem is described as the total mechanical energy of the flowing…

Q: 0.4 m 0.4 m 0.5 m 1.0 m water s 0.90 oil, s=

A: Solution Given that different fluids with specific gravity One atmosphere (101.325 kPa) is also the…

Q: The speed of an aeroplane flying at 3500 metres is measured using a Pitot-static probe. Determine…

A: Given that :h = 3500 m △P = 3.5 KPadensity = 0.9 kg/m3

Q: The primary and secondary dimensions quantities in FLT system are: Api = FL-3, A, L', A2 L, p FL-4…

A: A system can be measured in terms of physical quantities. Physical quantities are of two types - one…

Q: What size of orifice would give a pressure difference of 41 cm water column for the flow of liquid…

A:

Q: The flow times of n-butyl alcohol and water at 20 ° C from an Ostwald viscometer were measured as…

A: The absolute viscosity of n-butyl alcohol for the Ostwald viscometer is to be calculated.