Figure below shows the power consumption of a certain household in 1 day. Calculate the total energy consumed in kWh Figure below shows the power consumption of a certain household in 1 day.Calculate the total energy consumed in kWh.1200 WPA800 W200 W12 2 4 6 8 10 12 24 6 8 10 12noont (h)

Answered: Image /qna-images/answer/ca986e3a-5f7f-4e6b-8602-03642638701e.jpg

Answered: Calculate the total energy consumed in…

Engineering

Mechanical Engineering

Calculate the total energy consumed in kWh

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: If the daily kw-hr energy by household using solar energy within 6 hrs peak sunlight in a day is 412…

A: Daily solar energy used by household, E = 412 kw hr No of hours, n = 6 hrs

Q: A room has to be maintained at 25 deg C at all times. Assuming the outside temperature of the room…

A: GivenT1=25oC=298KT2=-5oC=268KQ=42kW

Q: A rider tucked in 15 cm behind another rider expends almost 30% less energy than the front rider.…

A: Given data:Rider tucked in 15 cm behind another rider saves 30% energy This is a problem related…

Q: A piston cylinder assembly contains air with an internal energy of 36 kJ/kg. It is compressed to a…

A: GIVEN DATA WE HAVE TO FIND MASS OF AIR

Q: Consider an isolated system that is, one that does not interact with its surroundings. In this case

A: Isolated system is defined as the system where mass and energy interaction is zero. So, in the…

Q: A pulley has 5 supporting lines and supports an 800N weight. A force of 190N is required to move the…

A: From the given data: Load = 800 N Effort required to move the weight = 190 N Number of pulley = 5

Q: A closed system receives 60 KỊ heat but its internal energy decreases by 30 KJ. Then the work done…

A: This problem is related to the basics thermodynamics. First law of thermodynamics

Q: A horizontal force of 5.0 N is used to push a box up a ramp 5.0 m long that is at an angle of 15°…

A: If a force F is inclined at an angle θ with the horizontal, then the component of force along the…

Q: 3. How much heat is released by a system when 45Jof work is done on it to decrease energy to 23 J

A: Given Data Work done on the system is : W=45 J Decreased energy of system is : ∆E=-23 J Now from…

Q: c) A power station has an output of 2000MW and its thermal efficiency is 25%. Determine the amount…

A: Given Data Power output W=2000 MW = 2*109 w Efficiency, 25% Calorific value of coal, CV = 30 MJ/kg =…

Q: Question 1 11A 50 kg cement Dlock needs to be moved, over a distance ofr 10m, the power avalabie is…

Q: How much mass of aluminium materials required (in kg) with a specific heat capacity of 0.92 kJ/KgK…

Q: what is the cost of that heat loss to the home owner for 10hours if the cost of electricity is PHP…

A: Given Time, t = 10 hours Rate, R = PHP 0.45/kWh Heat loss, Q = 2.46 kJ/s Find…

Q: Why do we calculate/measure power? (From engines, electricity, etc.)

A: Measuring power of different equipment is so important due to following reason ,

Q: . A man whose mass is 70 kg walks up to the third floor of a building. This is a vertical height of…

A: Given, Mass of man = m = 70 kg Change in height = h = 12 m Time spent = t = 20 s Additionally, we…

Q: Write down the derivation of formulas and describe each variable for Work and Energy.

Q: Given data m-20 kg g-10 m/s2 h-2 m Find Potential energy

A: Given data : Mass=m Acceleration due to gravity=g height=h Required : Potential energy

Q: The figure belows shows an object whose mass is 15 lb attached to a rope wound around a pulley. The…

Q: The ventilation in a house changes the air every five hours. How much power does it take to warm the…

A: Given : A = 150 m2 T0 = 0 C To find : Power required

Q: QI. A hydroelectric station has a cubic tank of height 50m above the earth. This cubic tank has an…

Q: A lawnmower pulling a cord wrapped in a wheel with a diameter of 12 cm it is being operated. Motor…

A: Given Diameter of wheel d=12 cm Force F=80 N angle turned in 3 revolutions θ=3×2π=6π rad

Q: A worker pushes horizontally on a large crate with a force of 310 N, and the crate is moved 3.6 m.…

A: As per given question we have determine workdone ??

Q: 360 kJ of heat is transferred from a hot reservoir of 600 K to a cold reservoir of 250 K. If the…

Q: How much thermal energy is created when a 2523 kg car brakes to a stop from 17.8 m's on a level…

Q: 1. A gas has an internal energy of 215 KJ/Kg. It had a velocity of 100 m/s and an elevation above…

Q: What is the kinetic energy if the mass is 35 lb and the velocity is 21 ft/s in ft-lbf?

Q: A cable that weights 2 lb / ft is used to lift 800 lb of coal up a mineshaft 500 ft deep. Find the…

Q: A biomass digester receives 23 kJ of energy in the form of heat. There is a mechanical mixer that…

Q: A cylinder with volume V0 has enclosed air in it. Air temperature is T and pressure is p0. The air…

A: Given, Initial volume of the gas, Vo Initial temperature , T Initial pressure , Po Volume of the…

Q: person heats up a can of soup on a stove. If they do 200 joules of work on the soup by stirring it…

A: Given information: The work done on the soup by stirring (W) = - 200 J (“-ve” since work is done on…

Q: During a process, a system receives energy by heat transfer of 35 J, loses energy by heat transfer…

A: Given data :- Heat transfer = 35 J ( received ) Heat transfer = 5 J ( loses ) Work done by the…

Q: An electric resistance heater is used to provide space heating at an efficiency level of 100%. The…

A: Space heating demand: 1137.8 MBHConversion factor: 1 MBH = 1000 BTU/hElectricity cost: $0.13 per…

Q: mechanical energy at the rate of 35 W. If thermal conductivity of

A: Given that, Diameter of the rod, D=5 cm,Length of rod, L=90 cm,Environment Temperature, T∞=32…

Q: A machine does 9-kJ of work in 1 min. What is the power developed by the machine? A) 2000 Watts B 42…

Q: 10: In a piston cylinder arrangement the pressure is proportional to the square of volume. The…

A: Initial condition : p1=10 bar, V1=0.1 m3 Final condition : p2=2 bar Given that, Pressure, p∝…

Q: A cable that weighs 6 lb/ft is used to lift 500 lb of coal up a mine shaft 350 ft deep. Find the…

A: Mass of cable per unit length, m = 6 lb/ftMass of coal, Mc = 500 lbDepth, h = 350 ftRequired:W (…

Q: 2) The energy consumed by a shower for 30 days is 22kwh. It is known that the resistance of the…

A: To find: The value of time in minute. Given: The value of energy consumed is, 22 KWh. The value of…

Q: Consider an isolated system that is, one that does not interact with its surroundings. In this case…

A: An isolated system is defined as the thermodynamic system in which neither energy or work can cross…

Question

Figure below shows the power consumption of a certain household in 1 day. Calculate the total energy consumed in kWh

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Write the total energy equation for power (p)-time (t) graph.

VIEW

Step 2: Draw the given graph into five rectangular segment.

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A block sits on top of a 15 m high wall. The brick has a mass of 3.5 kg. What is the potential energy of the brick. Use gravity due to acceleration as 10
1.6 World energy consumption reached about 500 quadrillion Btus in 2010. Estimate the equivalent energy quantities in: barrels of oil, metric tons (tonnes) of coal, standard cubic feet of natural gas, gallons of reservoir water elevated 1000 m above sea level, kilograms of steam (saturated vapor) at 200°C, kilograms of hot water (saturated liquid) at 200°C, cubic meters of granite at 250°C.
A movable piston compresses a gas in a cylinder to a volume half that of its original volume. The gas lost 300 KJ of heat during the process, but the internal energy value is zero. What is the work done on the gas? Select one: O a. 150 KJ O b. 100 KJ O c. 300 KJ O d. 200 KJ
A block of 3 kg, initially at rest, is pushed uphill on an incline of 30 degrees over a distance d,. The pushing force is directed horizontally and has a constant magnitude of 35 N. The surface of the incline offers a constant kinetic friction (µk = 0.3). a) Make a FBD for the block and use Newton's 2nd law to find the normal force and the friction. b) Use work-energy approach to calculate how much farther the block moves uphill after we stop pushing (this distance (d,) should be expressed as a proper or improper fraction of the "pushing distance"(d,) – I am not asking for a number!!). Take as your SYSTEM: BALL+INCLINE+EARTH. Make sure to make lists of all the forces that are relevant and to calculate the work done by each of them, as seen in the lectures.
A gas furnace has an efficiency of 75%. How many BTU will itproduce from 1000 BTU of natural gas.
A vehicle having 6509 lbm travels at speed of 100 miles per hour. Compute (a) the mass of the vehicle in kgm, (b) its speed in km/hr and (c) its kinetic energy in kcal.
6. An ideal gas with Cv = 1.62 kJ/kg-K and R = 273J/kg-K expands from 0.15m3 (cubic meter) and 27 deg. C to 0.35 m3 (cubic meter) during an isobaric process with p = 150kPa. Consider the process reversible nonflow, determine:
Thermodynamics
A rigid tank consisting of two equal parts has a pressure of 300 kPa and 6 kg of water at 30oC on one side. The other side is completely empty (vacuum) and after a certain time, the valve in between opens and the water goes to the empty side. provided. Since the temperature inside the tank remains 30oC; a)Find the volume of the tank b)Find the final pressure, work done and heat transfer.
A closed system loses energy by heat transfer at the rate of 10kJ/s. Write the energy balance for this problem if the system operates at steady state
Q2. From the following figure; 400 power, kw L 200 0 12 8 Time, hr 1. 2. What will be the highest power value for this project? ( What will be the total rated output? (
In a closed container whose volume does not change, a mass of 1 kg, a pressure of 1000 kPa and 400°C There is water in the form of superheated steam at temperature. All of the water in the bowl is saturated Heat is given to the environment until it turns into steam. a) Calculate the heat transfer (kj). b) Find the final temperature of the water (°C). c) By taking the boundary temperature between the container and the environment equal to the final temperature of the water, Find the amount of entropy produced during this process (kj/K). Note: The changes in kinetic and potential energies will be neglected and T (K) = 273 + °C will be taken.