Calculate the temperature required to overcome the Coulomb barrier in the CNO cycle melts (only the one with the highest height). cycle (only the one with the highest height). Do the same for the P-P cycle and find the ratio of the values. values. Calculate the energy released in both cycles. What is the ratio of the released energies?

Q: CO is oxidized to CO₂ in an excess of air in afterburner entering at To= 298 K. Assuming that air…

A: O2=20% N2=80%

Q: na heat exchanger an unknown gas with molecular weight of 30, K = 1.32 enters the eat exchanger at…

A:

Q: What are the modifications that we can do to improve the performance of gas powe  plant? Explain…

A: To increase the performance of the power plant various modifications are can be added, some of them…

Q: How did you derive that equation to find h3? I see you had to use constant specific heat assumption…

A: Turbine operation is done under process 3-4Let,Thus,Process 3-4s: Isentropic expansion in…

Q: . Steam is generated at 4.352 MPa and 451.325°C and condensation occurs at 0.1166 MPa. a) For…

A:

Q: What are your design assumption when developing crygenic plant?

A: This question is based on the concept cryogenics and cryogenic plant.

Q: A Rankine cycle is executed with steam expanding initially from 20 MPaa and 100 deg SH. Condensation…

A:

Q: A mix fresh feed A at temperature 20 °C is heated to reaction temperature of 180 °C, before feed to…

A:

Q: 3.Fuell cell use as fuell methane converted in hydrogen by steam methane reforming reaction. If unit…

A: unit output of electrical energy is 5 kW efficiency is 50%

Q: Can you please give 3 disadvantages of Reheat Regenerative Cycle?

A:

Q: Differentiate between equillibrium and non equillibrium cooling curve

A: The cooling curve is the graph showing phase change of material with respect to temperature of the…

Q: The following properties for Freon-12 were obtained. At -22 °C b (superheat) = 353 KJ/kg ha = 343…

A: The refrigeration effect is the amount of heat that is required to extract from the storage space in…

Q: initially from 12.111 Mpa and 540.111oC. The reheater pressures are 2.5111 MPa and the steam leaves…

A:

Q: During Basic Oxygen Process to manufacture low carbon stainless steel, 600 kg of cast iron (6%of…

A: It is given that, Amount of cast iron =600 kg in which 6 % is carbon,Hence,600 kg of cast iron…

Q: Please help me find out where you got the s values from for the exergies for each of the processes,…

A:

Q: Typical gasoline octane is burned with 20% excess air by weight. Find the partial pressure of the…

A:

Q: for step 1, why would it be 13350 kW and not 31350kW?

A: The answer to your query is give below.

Q: An SI engine operating on stoichiometric propane fuel burns 0.00005 kg of fuel in each cylinder…

A:

Q: A 110-volt electrical heater is used to warm 0.3 m3/s of water from 19oC to 98°C . Assume heat…

A:

Q: Does R134a suitable refrigerant in Cryogenic plant for liquid oxygen produduction? Explain, if not…

A: Cryogenic plant is used where we require cooling far below the zero degree centigrade so we have to…

Q: Give PV and TS Diagrams of Actual Bryton Cycles. Give also the Work and efficiency equation

A:

Q: A 110-volt electrical heater is used to warm 0.3 m3/s of water from 19°C to 98°C . Assume heat…

A:

Q: Consider an ideal Hampson-Linde cycle in which no heat is lost to the environment. Use the data in…

A: The Linde-Hampson cycle, is a type of refrigeration cycle that allows gases to reach very low…

Q: 7. Calculate the heat transfer required to heat boiler feed water at a temp of 170° to steam at a…

A:

Q: the work performed; (b) the heat that enters and leaves during the cycle; (c) the income.

A:

Q: 576rty

A: First, we need to write down the stoichiometric equation for the combustion of propylene (C3H6) with…

Q: Asample steam has 5°C a5 the degree of superheat. Before and after throttling. its pressures 3re 40…

A: Throttling is a thermodynamic process in which enthalpy remains constant. Degree of superheat is the…

Q: • The pressure drop across the combustor affects: a. The fuel consumption and power output. It is…

A: The pressure drop across the combustor decreases the turbine pressure ratio. Thus it affects the…

Q: The condensing pressure for a Rankine Engine is 1.6 bar. 200°C and the steam at the beginning of…

A: To calculate the efficiency of a Rankine cycle we need to use the given information and apply the…

Q: Define the Exergy Destroyed During Stirring of a Gas.

A: Exergy has been a primary tool under the second law of thermodynamics. Exergy efficiency becomes…

Q: A geothermal heat pump or 'ground source heat pump,' is a highly efficient renewable energy…

A: It is asked to design the heat pump based on the given design criteria Required heat demand = 12.3…

Q: 3) Isooctane (C, H,) is burned with air in an engine at an equivalence ratio of 0.833, ind air-fuel…

A: Write the expression of equivalence ratio.   λ=AFRAFRstoichiometric   Write the value of air-fuel…

Q: A reheater cycle is executed of 1kg steam expanding initially from 12.356 Mpa and 540.356oC. The…

A:

Q: A fuel of Q₁ = 6888 kcal/kg was burned in the furnace of a 223 m² water tube boiler which was…

A:

Q: Find the air-fuel ratio for a combustion process to which the fuel is C3Hs.

A: We have to calculate the stoichiometric air-fuel ratio for c8h8

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A: ⇒given data;⇒pressure ratio (r)=P2P1=16⇒inlet temeperature of air  in compressor (T1)=300K⇒mass flow…

Q: 13.32 Methane is burned with dry air at 40°C, 100 kPa with AF 22 on a mass basis. For complete…

A:

Q: The "typical" coal in Example 7.10 is being burned under the conditions in that example, a rate of…

A: Given Flow rate = 1000 kg/hr Temperature = 400 F To find Flow rate in scfm Flow rate in acfm

Q: Calculate the energy contained if 500 kg of PMMA burns, assume the caloric value of PMMA is 24 MJ/kg…

A: Calculate the energy contained if 500 kg of PMMA burns, assume the caloric value of PMMA is 24 MJ/kg…

Q: A power plant is using C12H30 as fuel. Calculate the heating value at 15.6°C and the specific…

A: