Calculate the sabins of absorption at 1000 Hz in a room that has dimensions of 11.00m wide x 15.00m long x 3.50m high. The room has: a. Plasterboard (12mm(1/2") in suspended ceiling grid  b. Walls are constructed of concrete blocks (coarse). c. The floor is covered with marble.   2. The absorption coefficients of the materials at 1000Hz are as follows: a. Plasterboard (12mm(1/2") in suspended ceiling grid – 0.04 b. Concrete blocks (coarse) - 0.29 c. Marble flooring -0.01   3. Compute the reverberation time (RT60) of the room. 4. Is the reverberation time appropriate for a room designed for speech? 5. As a designer, what will you recommend 5 to increase (or decrease) the reverberation time?

Q: shows two masses hanging from a steel wire. The mass of the wire is 58.5 gPart A What is mass m ?…

A:

Q: For a tube of fixed length, at higher harmonics, the frequency is and the wavelength is higher,…

A: harmonic series given below.

Q: Given the following information about the Diamond; lattice constant 3.56 A. the speed of sound in…

A:

Q: A certain organ pipe, open at both ends, produces a fundamental frequency of 275 Hz in air. Part A…

A:

Q: If you want a T1-weighted pulse sequence, what would be a suitable choice for TE?

A: A short TE would be a suitable choice for a T1-weighted pulse sequence. The equation for signal…

Q: 1. A signal given by x(t)=2cos(3a t) is sampled at a frequency of 20 Hz, starting at time t=0. i. Is…

A: The wave which moves periodically smoothly with same wavelength throughout the motion is known as…

Q: Example 1 A sound wave of wavelength 0.75 m is travelling in air at 0.0°C when it hits a block of…

A: Given data: The wavelength of sound wave is λ=0.75 m. The speed of wave in steel is v=5050 m/s.

Q: ASK YOUR TEACHER With the installation of noise suppression materials, the noise level in an…

A:

Q: The spectrum of color seen reflected off of a CD is caused by...   a. Dispersion   b.…

A: The spectrum of color reflected from a Compact Disk ( CD) is due to the optical phenomenon known as…

Q: Q. Solve f'(2) for f(x) = 7e0.5x with step size h = 0.7 using Newton Divided Difference method. Also…

A: Given: fx=7e0.5x Step size h=0.7. Introduction: Numerical differentiation is the process of finding…

Q: 4. Calculate the wavelength (in m) of the note middle "C" (frequency = 256 Hz) in air at room…

A:

Q: y occupies a volume of 725 ssuming the temperature re

A:

Q: Estimate the sound velocity of Xe (fcc crystal with lattice parameter of 6.202 Angstrom) from the…

A: Given: The lattice parameter is 6.202 A∘. Introduction: The lattice constant refers to the physical…

Q: A continuous-time signal x(t) has a bandlimited spectrum with the highest frequency of 5KHZ is…

A:

Q: 5. Kittel, Ch4-14, Heat capacity of liquid He at low temperature. The velocity of longitudinal sound…

A:

Q: Equal loudness curves represent the results of measurements of    A absolute threshold.   B…

A: The equal loudness is often referred to as Fletcher Muson Curve. Which is related to physics and he…

Debye Theory of Solids

In solid-state physics, debye theory is used to estimate the phonons contributing to the specific heat capacity in a solid. It explains that the specific heat is a consequence of the vibrations of the atomic lattice of the solid, which is in contrast to the Einstein model. In the Einstein model, solids are treated as independent, non-interacting quantum harmonic oscillators. This model clearly explains the low-temperature dependence of the heat capacity, which is proportional to T3. This is known as Debye T3 law.