Calculate the largest weight W that can be attached to the two wires shown in Figure P-103. The stresses in wires AB and AC are no more than Mpa 100 and Mpa 150 respectively, knowing that the cross-sectional area of wire AB is 400 square millimeters and for wire AC is 200 square millimeters. Answer W = 33.5 kN

Q: A B 60° 55° C Determine the largest weight W that can be supported by two wires shown in figure. The…

A:

Q: Determine the largest weight W that can be supported by the wires shown in figure. The stress in…

A:

Q: A solid steel bar with a diameter of 50 mm is subjected to three forces as shown in the figure,…

A: In the given problem, the main stresses will be developed at point B due to 1200N force which will…

Q: A wire with a Young’s Modulus, E, of 8.5 x 106 N/m2 and an original length of 1.5 m is under…

A: Calculate the strain in the wire. ε=δll Here, l is the original length of the wire, δl is the change…

Q: Determine the maximum shear stress acting at section a-a of the cantilevered structure, as shown in…

A:

Q: B = 30° A 50 mm

A: The moment of inertia about the y-axis and z-axis are determined as follows.

Q: The round bar in the figure is made of steel (E-207 GPa). The load F has a magnitude of 100 N. You…

A: Young modulus of the material,(E)=207 GPa. Applied force (F)=100 N. Diameter of the shaft,(d)=20 mm.…

Q: Figure Q5 shows a thick cylinder of 50 mm internal radius and 130 mm outer radius is subjected to an…

A: 2   Given: The internal radius, ri = 50 mm The outer radius, ro = 130 mm The internal pressure, Pi =…

Q: The Mohr's circle for a point near the base of a traffic pole is shown below. the center of the…

A: Consider the diagram shown below for the given Mohr’s circle.

Q: n element is subject to the stresses shown below in Figure 5 Calculate the centre and radius of the…

A: Givenσx=75MPaσy=-30MPaτxy=14MPa

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.