Answered: Calculate the heat transfer rate (in W)…

Calculate the heat transfer rate (in W) from a 1,180 ft2, 7 in. thick concrete wall with inside and outside surface temperatures of 22°C and 6°C. W

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A 50-L electrical radiator containing heating oil is placed in a 50-m³ room. Both the room and the…

A: Heater is kept on approximately 41 minutes Thankyou! Feel free to ask if you have any…

Q: À commercial building is built on a slab on grade foundation that is a 40 m by 18 m rectangular…

A: Given, Slab length L=40 m B=18 m Temperature (t)= -15° C

Q: Problem 8 Water enters the tubes of a cold plate at 65°C with an average velocity of 50 ft/min and…

Q: While the pressure remains constant at 85 psig, the volume of air changes from 20 ft3 to 12 ft3.…

A: Give data: P= 85psiV1 (initial volume) = 20 ft3V2 (final volume) = 8 ft3∆V=V1-V2=20-12=8…

Q: 3- 50 m tape was used to measure line SF; if the measured distance was 1288.54 m. Find the corrected…

A: Given that: Nominal length of tape, l=50mMeasured distance, L=1288.54 mTrue…

Q: 1. Outer skin 220mm brickwork

A: Data is insufficient for the calculation but the ways to minimise heat will be given below..

Q: Estimate the temperature at 1000 m given a surface temperature of 22 °C for a clear sunny day with a…

A: Surface temperature = 22• CTemperature required at 1000m or 1 km.

Q: Estimate the amount of precipitable water in a saturated air column 1.5 m² of ground surface. The…

A: Column size- Surafce pressure- 101.3 kPaSurafce air temperature- 28CLapse rate- 6.5C/kmR= 287…

Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…

A: The length of line measured = 746.22mThe standard length of tape at 20°C, l1 =50mThe average…

Q: Air enters a diffuser operating at steady state at 540°R, 15 lbf/in.², with a velocity of 600 ft/s,…

Q: n areas where the air temperature remains below 0°C for prolonged periods of time, the freezing of…

A: Initial uniform ground temperature, Air temperature, Snow pack temperature, Time, Soil properties,…

Q: Problems: Q1/ The inner and outer surfaces of a 5-m 6-m brick wall of thickness 30 cm and thermal…

A: My dear Given data Dimensions of wall Thermal conductivity Temperature difference of surfaces.

Q: Esumate the vapor pressure, all pressure, relative humidity, and all density at a height of 1800 in…

A: The height of the atmosphere = 1500 mThe total pressure = 100 kPaThe air temperature = 28°CThe dew…

Q: 2. A parallel flow heat exchanger is used to cool 4.2 kg/min of hot liquid of specific heat 3.5…

A: Following are the given data. Mass flow rate of hot liquid, mh=4.2 kg/min=0.07 kg/s Specific heat of…

Q: Given a closed tank with 80mm diam. orifice at the side. If Cv=0.95 and Cc=0.60: a) Determine the…

Q: Calculate the RSI-total for the walls using the tabular method demonstrated in class, and the…

Concept explainers

Temperature as a Fundamental Dimension

There are certain rules to write dimensions of a physical quantity using the fundamental dimensions. They are outlined below.

Question

Calculate the heat transfer rate (in W) from a 1,180 ft2, 7 in. thick concrete wall with inside and outside surface temperatures of 22°C and 6°C.
W

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For an air-conditioning system, the outdoor and indoor design dry bulb temperatures are 45°C and 25°C respectively. The space to be air-conditioned Is 20m x 30m x 5m and infiltration is estimated to be one alr are 1.2 (kg of dry air)/m³ and 1.02 kJ/(kg of dry air) °C, then the sensible heat load due to Infiltration is, nearly
Assume a pressure of 100 kPa absolute at ground level. What is the pressure (in kPa)at the top of a 3-m-high wall on the outside where the temperature is -20°C and on the inside of a house where the temperature is -22°C? (This difference results in infiltration even if no wind is present.)
are maintained at uniform temperatures of 300°C and 4 cm Tem 5 cm 10cm hem 100°C,respectively. Determine the rate of heat transfer through the wall and draw the thermal circuit. Q2) A double-pipe counter flow heat exchanger is to coo! ethylene glycol (Cp-2560J/kg.°C) flowing at a rate of 3.5 kg/s from 80°C to 40C by water (Cp-4180J/kg.°C) that enters at 20°C and leaves at 55°C. The overall heat transfer coefficient based on the inner surface area of the tube is Celd water 20C Hot glycel 250W/m2.°C. Determine: 15gs (a) The rate of heat transfer. (b) The mass flow rate of water. (c) The heat transfer surface area on the inner side of the tube. Q3) A(10 m) long section of a 0.05m diameter horizontal hot water pipe passes through a large room whose temperature is 22°C. If the temperature of the outer surface of the pipe is 65°C, determine the rate of heat loss from the pipe by natural convection? The properties of air at 43.5°C is k = 0.02688 W/m.°C, u = 1.735 10 m /s, Pr = 0.7245.…
Round off 2 decimal places :)
Compute the cooling load for the south windows on a middle floor of an office building that has no external shading. The windows are the insulating type with regular plate glass inside and out. Drapes with a reflectance of 0.2 and transmit- tance of 0.5 are fully closed. The total window area is 400 ft². Assume that the indoor temperature is 78 F and the outdoor temperatures are 100 F in July with a 22 deg F daily range. Make the calculation for 12:00 noon at 36 deg N latitude. To determine the zone type, make assumptions for a modern office building. d
4. Estimate the temperature at 1000 m given a surface temperature of 22 °C for a clear sunny day with a gentle breeze.
A line was measured using a 50m tape and was recorded as 746.22m. when the average temperature during measurement was 16°C. If the tape is of standard length at 20°C and a coefficient of thermal expansion of 0.0000116m/°C. Compute the correct length of the measured line.
Calculate the heat loss from a double-pane glass window consisting of two pieces of glass, each having a thickness of 10 mm with a thermal conductivity of k = 1.3 W/m.K . The two glass panes are separated by an air gap of 7 mm. Assume thermal conductivity of air to be k = 0.022 W/m.K .