Calculate the forces in the ribs of the Muslim shown in Figure (1) and are the ribs of the Muslim in a state of tension or pressure? Explain this. 3.0 m 400 KN B 6.0 m 200 KN 3.0 m 800 KN m O 3.0 m 200 KN 3.0 m Figure (1) F

Q: what should you know before choosing a respirator

A: Workers should use respirators for cover from contaminants within the air on condition that…

Q: Describ the procedure for using air bleedvalves to purge out of a coolling  system

A: A bleed valve is typically utilized to eliminate the liquid from the vehicle's tank or for removing…

Q: evaporator, whích of the following could result? ine at the outie The bulb pressure would increase…

A: (44) . if a thermostatic expansion valves thermal bulb came loose from the suction line at the…

Q: Technician A says that suction lines become verywarm during A/C operation. Technician B says that…

A: Technician B is correct. discharge lines of pipe conducts hot, high-pressure refrigerant vapor from…

Q: Technician A says that suction lines become very warm during A/C operation. Technician B says that…

A: Suction line:The piping line which connects the outlet of the evaporator(refrigerated space)  to…

Q: One way to prevent leaking from glove valves in a Halocarbon refrigeration system is to employ…

A:

Q: Coolant hoses are being discussed. Technician A states that many manufacturers recommend coolant…

A: Coolant hoses are to be maintain and replace in certain time interval, it fails due to high…

Q: 17 Which of the following relief valves is designed to vent refrigerant under excessive pressure and…

A: Which of the following relief valves is designed to vent refrigerant under excessive pressure and…

Q: True or false The flexible duct system provides the lowest air resistance.

A: The above statement is false.  Explanation: The flexible ducts are made of metallic wires formed in…

Q: What are the funtions of an isolation/dump valve?

A:

Q: rainsient Cooling -Many years ago, the engineering building air compressor dryer failed and visible…

A: In less difficult terms, air temperature, humidity, compressor measure, and required weight will…

Q: Which process would best represent the opposite ofexhausting air from a system?A. CoolingB.…

A: Given Data : Exhausting air

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.