calculate the enthalpy of stream 8

Q: the equivalent length of the exchanger as a complete unit (in terms of 20 mm diameter tube).

A: Consider a heat exchanger of length 12m, 10 close return bends and 15 x 90° elbows connected in…

Q: How about the relative error and percentage error of the volume?

A:

Q: Use water as a drilling mud to drill a well to a depth of 3000 feet , calculate the pressure…

A: This question is based on pressure gradient. The data given are: Depth = 3000 feet

Q: An oil burner nozzle is labeled 60°. This is the angle from straight ahead tothe direction that the…

A: Paper is placed 12 inches from the nozzle.  the oil burner is labeled at 600C, The Schematic of the…

Q: Describe the difference between average pressure and false pressure

A: The force applied perpendicular to the surface of an object per unit area over which that force is…

Q: A 2 mm diameter glass tube is inserted into an open glass of water (contact angle between the tube…

A: Diameter of glass tube =  2 mmContact angle,  = 0

Q: A B Rate of deformation, duldy Shear stress, 7

A: There are several properties defined for fluid such as density, specific gravity, viscosity, etc. In…

Q: In general, why should the operating pressure be high and the operating temperature be low for an…

A: The reason for the high pressure and low temperature for the absorption process is to be mentioned…

Q: Calculate the volume of an HCP unit cell in terms of cell edge (a) and height (c).

A:

Q: Why do positive displacement pumps cause pose more overpressure hazard compared with centrifugal…

A: In a positive displacement (PD) pump, a fixed volume of liquid is trapped inside an enclosed chamber…

Q: Cone has top and bottom diameters of 10 and 20 cm and a height of 10 cm. Calculate the shape factor…

A:

Q: 10 - 10 -10 10 120 10 10 50 80 10 160

A: distance H from the bottom of the base plate  i.e. y co-ordinate of the centroid we have to…

Q: 3. Define the hydraulic and energy grade lines, and explain the method of calculating and drawing…

A: It is asked to define the Hydraulic grade line and energy grade line  and explain the method of…

Q: What is a flexible wedge gate used for

A:

Q: Why does the fluid drop in the fluid level measurement experiment when the pump is turned off?

A: In a typical fluid level measurement experiment, the pump is used to recirculate the fluid in a…

Q: C; Draw the temperature distribution long the insulated tip fin.

A: Fins are used in heat transfer to increase the surface area of a heat exchanger, thereby increasing…

Q: It refers to the vapor that is brought back to the column for better separation.   a Distillate…

A: In distillation we have key component as feed, distillate,residue,reflux and boilup.

Q: Calculate the porosity of the core

A: Given data: The density of the oil = 0.85 g/cc Weight of dry sample in air = 42.4 g Weight of the…

Q: Determine the following for each item: 1. Equivalent surface diameter 2. Equivalent volume diameter…

A: (1) Equivalent surface diameter is defined as the diameter of the sphere having equal surface area…

Q: Using a flow chart, show how a lubricant oil with high viscosity index can be manufactured from…

A: In petroleum industries, Crude oil is a type of fossil fuel that is a naturally occurring petroleum…

Q: production of paper from ground nutshell complete flow chart

A: In this question flow chart of production paper from ground nutshell is to be discussed.

Q: What

A: The hydrosphere is combined mass of water on ,above and below surface of earth.

Q: What is the maximum radial distance traveled by any particle in cyclone seperator?

A: Chemical processes consist of the separation stages in which the process streams are separated and…

Q: What is the difference between permeability and permeance?How are they analogous to diffusivity and…

A: The difference between the permeability and the permeance is to be mentioned along with the relation…

Q: 1. Calculate the surface per unit volume in square centi- meters per cubic centimeter of galena…

A: Mesh%…

Q: Please discuss "Drilling problems related to drilling fluid rheological property"

A: Drilling muds or fluid is sued as carrier of rocks produced during the oil and gas drilling…

Q: mm diameter glass tube is inserted into an open glass of water (contact angle between the tube and…

A:

Q: Sketch the cross flow induced-draft cooling tower and illustrate all its parts.

A: Induced draft cooling towers Induced draft cooling towers are of two types based on the nature of…

Q: Represents and describes by means of a diagram the main parts of the evaporation equipment.

A: Evaporation  It is the process of concentrating the stream by removing water. The process is energy…

Q: A water bath is laboratory equipment made from a container filled with heated water. It is used to…

A: It is said that the piston that has a horizontal  design is placed in a water bath, the composition…

Q: Briefly describe the following: (i) Saddle Support (ii) Skirt Support.  In detail.

A:

Q: In what dimension is the concept of material balance based?

A:

Q: Calculate the viscosity of oxygen at 350 K and 1 atm pressure using equation 7.12 on page 90 of the…

A: Given data: Temperature = 350 K Pressure = 1 atm

Q: Describe laminar and turbulent regimes of fluidization

A: The turbulent fluidization regime is happened in between the bubbling and fast fluidization flow…

Q: Find the relation between a) True stress and engineering stress and b) true strain and engineering…

A: Stress is defined as the force per unit area, which can be divided into two types. They are True…

Q: Using Figure, determine the following properties of the magnetic material: remanance, saturation…

A: The remanence (Br)  is calculated as the measure of remaining magnetization if the driving field is…

Q: Write about the principle and operation of electrostatic precipitator.

A: Principal of electrostatic precipitator: Electrostatic Precipitator is a physical process by which…

Q: Write a on ILaminar And Turbulent Flows and flow friction losses in the piping

A: Reynolds Number:  It is use to distinguish the type of flow in the pipe. Laminor Flow: Flow in…