Calculate the capacitive reactance in Q-km of a bundled 60 Hz three-phase line having three ACSR Rail conductors per bundle with 45 cm between conductors of the bundle. The spacing between bundle centers is 9, 9, and 18 m.

Calculate the capacitive reactance in Q-km of a bundled 60 Hz three-phase line having three ACSR Rail conductors per bundle with 45 cm between conductors of the bundle. The spacing between bundle centers is 9, 9, and 18 m.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

30/0° V rms -j22 42 Determine the power factor of the entire circuit of as seen by the source. ww
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
For the Figure 9 shown: A 65 -km long, 59 Hz, three-phase, transmission line is composed 2 parallel lines. The conductors in the lines are stranded with GMR of 15.92 -mm each. If the distance D in the figure is 2.46 m., What is inductive reactance per line in (ohm)? Figure 9 $0 D 1.732D 2D 1.732D 1.732D D b' 1.732D
The Cost OF Single phase overhead feeder is OMR q Per KM(a is area of cross section in sq mm) and the intrest and depre Ciation Chargs onfeeder omical carrent density are 7Y. defermain to use for the most econor requiring Full load current of 27% of the 12 baisa is year. The Cost per unit ass ume resistance of Im lenahth length and I mm² secfion of Conductor as 1/32 find Current densi ty =?
A two conductor single phase line operates at 55 Hz. The diameter of each conductor is 25 mm and the spacing between the conductor is 3 m. Calculate i) the inductance of each conductor per km ii) the loop inductance of the line per km iii) the inductive reactance per km, and iv) the loop inductance per km of the line when the conductor material is steel of relative permeability 55.
The following figure illustrates the configuration of a two-bundle and completely transposed transmission line system operating at 50 Hz. The transmission line length is 100 km, and each bundle consists of conductors with a diameter of 6.0 mm. The resistance of each bundle is 0.12 22 per kilometer. Answer the following questions. a) The inductance in H/m for each phase of the transmission line. b) The total inductive reactance in 2 for each phase of the transmission line. c) The capacitance in F/m for each phase of the transmission line. d) The total capacitive reactance in 92 for each phase of the transmission line. e) Sketch the nominal- circuit of the line 3m 3m 0.06 m 8m
For the Figure 11 shown: A 454 -km long, 58 Hz, three-phase, 3-line with bundling, transmission line is composed of stranded conductors in each of the bundle with GMR of 6.09 -mm. The distance d in the bundle set is 22 cm. If the distance D in the figure is 1.37 m., what is inductive reactance per line in (ohm)? Figure 11 0.75D b 1.25D
A 60-Hz, single-phase two-wire overhead line has solid cylindrical copper conductors with a 1cm diameter. The conductors are arranged in a horizontal configuration with 0.71 m spacing. Calculate in mH/km (a) the inductance of each conductor due to internal flux linkages only, (b) the inductance of each conductor due to both internal and external flux link- ages, and (c) the total inductance of the line.
Three Conductors of a 3-phase line are arranged at the corners of a triangle of sides 20, 10, and 18 meters. The diameter of each line conductor is 1 cm. Calculate the Capacitance per phase per km (C1) for this arrangement. Calculate Capacitance per phase per km(C2) if the spacing between the conductors are reduced by 1/4th of given spacing. NOTE -- an Capacitance inuF per Phase per Km for Arrangement 1 (C1) Capacitance in µF per phase per km for Arrangement 2 (C2)
The capacitance between the line to neutral of a three-phase 50 Hz, 66KV overhead line conductors with horizontal configuration is 8.5 x 10- Farad/ph/m. Then the line to line capacitive reactance in 2/km is ..
A) Two conductors of a single phase line, each of 1 cm diameter, are arranged in a vertical plane with one conductor mounted 1 m above the other. A second identical line is mounted at the same height as the first and spaced horizontally 0-25 m apart from it. The two upper and the two lower conductors are connected in parallel. Determine the loop inductance per km of the resulting double circuit line.
please help solve this question A 100 km Three-Phase 50 Hz transposed transmission line is composed of bundle of three ACSR, 1,431,000 cmil, 47/7 Bobolink conductors as shown in Figure 2 (a). The Three-Phases (bundled Conductors) have flat horizontal spacing of 11 meters as shown in the Figure 2(a). The conductors have a diameter of 3.8 cm and a GMR of 1.5 cm. The Line is going to be replaced with a six conductor bundle of ACSR, 477,000 cmil, 26/7 Hawk conductors. The conductors have a diameter of 2.5 cm and a GMR of 0.9 cm. The new line will have a horisontal phase spacing of 14 meters as it is going to be operated at higher Voltage rating. The new line is shown in Figure 2 (b). The spacing between the bundles in Figure 2 (a) and (b) is 45 cm. Determine,a) The capacitance for each case and the percentage change in capacitanceb) The inductive reactance for each line and the percentage change.c) The inductance for each case and the percentage change ininductance