Calculate the capacitance of a single phase 50 Hz overhead line 40 km long consisting of two parallel wires each 5 mm in diameter, 1.5 metres apart, taking the effect of ground into consideration. The height of the conductors above ground is 7 metres. Derive any formula used. [A.P.S. Univ. Electric Power Generation, Transmission and Distribution 1978] [Ans. 0.174 µF]

Calculate the capacitance of a single phase 50 Hz overhead line 40 km long consisting of two parallel wires each 5 mm in diameter, 1.5 metres apart, taking the effect of ground into consideration. The height of the conductors above ground is 7 metres. Derive any formula used. [A.P.S. Univ. Electric Power Generation, Transmission and Distribution 1978] [Ans. 0.174 µF]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A generating station has a maximum demand of 25,000 kW. Calculate the cost per unit generatedfrom the following data: Capital cost = P 120M; Annual load factor = 45%; Annual cost of fuel and oil = P6.5M ; Taxes, wagesand salaries etc. = P6M and Interest and depreciation = 13%
The RMS voltage between conductor and ground is called Choose correct answer : A) Line to Line voltage B) Phase voltage C) Line voltage D) Neutral voltage
I need the answer as soon as possible
For transferring electrical power at 220 kV, six conductors of ACSR Drake constitute a 60Hz double circuit three phase line arranged as shown below. The vertical spacing between consecutive conductors is 14ft; the longer horizontal distance is 32ft whereas the shorter horizontal distance is 25ft. a. Find the inductance per phase per mile and the inductive reactance per phase in ohms per mile. b. Find the capacitive reactance to neutral in ohm-miles. c. Find the resistance per phase per mile in ohms per miles. d. If the length of the line is 90 miles then draw an equivalent circuit of the line and analyse the open circuit and short circuit performance of the line. e. Find the maximum power we can transmit over the line. f. If the line is delivering power to a load of 20MW at 0.8 power factor lagging then find the voltage at the receiving end of the line. Also, Determine the voltage regulation, losses and efficiency of the line. g. If a fixed shunt compensation of 3 MVAr is attached at…
Problem 1 Power System Standards and Related Assume a standard duplex outlet is wired correctly and meets the National Electric Code (U.S.) The load is operating correctly with no defects in operation or internal wiring. Answer the following: Write a time domain, rms phasor, and peak phasor (a) expressions for the voltage between: (i) Short slot with respect to the long slot (ii) Short slot with respect to the round hole (iii) Long slot with respect to the round hole (b ) (NEUTRAL WIRE, HOT WIRE, GROUND WIRE) of a power distribution system and this wire is color coded (GREEN OR BARE, BLACK OR RED, WHITE) and would connect to the (ROUND HOLE, SHORT SLOT, LONG SLOT) of a standard duplex receptacle. The National Electric Code specifies that a circuit breaker or fuse must always be located in the (c) (10% of the current in the black wire, 10% of the current in the white wire, Zero, 90% of the current in the black wire, 90% if the current in the white wire). The current in the ground…
Forward Voltage Wave In Figure 1 below, a voltage source, Vs, drives a transmission line of impedance Zo through a source resistance Zs. Zs Z. To 00 Figure 1 (a) Prove that the forward voltage wave is VẸ Vs/2 regardless of the value of Zo. – (b) If the positions of Vs and Zs are swapped, do the results of part (a) still hold? Why?
The inductance effect is predominant in underground cables than overhead lines. Select one: True False
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473
Discuss the principles and benefits of High Voltage Direct Current (HVDC) transmission in power systems.
Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the ratio of C1/C=0.1 (Shunt capacitance per self-capacitance) is given. If the string is connected to line of voltage 33kV. a) What is the voltage distribution over the unit of string and what is the string efficiency? b) When the string is supplied by a Guard Ring and this lead to add a two air capacitance of value 0.2C, 0.1C respectively to the nearest to the conductor. Find the new voltage distribution and the new efficiency.
Derives and analyse relation of capacitance for 3-core cables ? proper explanation in details
Describe the primary phases involved in the generation of electrical power.