Calculate the average power dissipated in a circuit, in which the input current and voltage are given by: i=4sin (wt +20º)    , v =12sin (wt + 70º)

Q: A series RL circuit connected to an AC voltage sinusoidal source of 100 V peak voltage and 1 kHz…

A:

Q: The P.S.D of a signal is shown figure (a) Find the normalized average power of the signal. (b) Find…

A:

Q: Given V, = 20 sin(@t + 60°) and V, = 60 cos(@t – 10º) . What is the phase angle between the…

A:

Q: Find the RMS voltage of a waveform whose voltage is v(t) = 17sin(70t) Vp

A: To find the RMS voltage (Vrms) of a sinusoidal waveform, you can use the formula:Vrms​=2​Vp​​where…

Q: Q.1). Find the average and R.M.S values for the current waveform shown below. 60 40 20 t (s) 1ms 2…

A: As per the guidelines of Bartleby we supposed to answer first question only for solution of…

Q: A supply voltage has a mean value of 150V. Determine its maximum value and its rms value.

A: Given, Mean voltage of a supply, Vavg=150 V.

Q: The periodic triangular current having a peak value of 180 [mA] shown below is passing through a 5…

A: Given Peak to peak value of current I =180 mA Peak to peak value is defined as difference of the…

Q: What is RMS voltage in a factory from an outlet that has a nominal voltage of 230 VAC

A: Given: Nominal voltage from an outlet is 230 VAC.

Q: An AC voltage

A:

Q: HW: Sketch the waveforms Vc and Vo versus 9V Vin 9V 1mA( Vin 7621 1uF 8 4 3 5 Vo 1uF 56 N 00+ ww R R…

A: RS is a flip flop or a latch used for the temporary storage of data. It can hold up to 1 bit. To…

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: VAvg= 2V/pi VRMS=V/sqrt(2) Where V= peak voltage

Q: Q-4: a) Calculate the values of R and C in the following circuit for maximum average power transfer…

A: The given circuit diagram is shown below,

Q: Derive the average value of the voltage in the figure v(t) 311-12V 2TT >wt

A:

Q: Write the general voltage equation for a 250-Hz source whose peak voltage is 300 V.

A: In this question,  We need to Write the general voltage equation If frequency f=250-Hz source  peak…

Q: A harmonic analysis of the current drawn by a CFL yields the following data. Find the rms value of…

A: We have an data of CFL lamp with harmonics as shown in table and corresponding currents of that…

Q: Given: Vi = Vpeak Sin wt V Vpeak %3| = 5 V With the ideal foward voltage = 0.7V, draw the waveforms…

A: It is given that: V1=VPeak Sin ωtVPeak=5VRL=1KΩVD=0.7V

Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…

A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz

Q: Determine the load (a)rms voltage and (b) average load current when the conduction angle is 30…

A:

Q: 4. Sketch the output waveform resulting in the opposite figure. V₁+1SV. 2002 0.1μF

A:

Q: (2) A certain alternating voltage is described by the equation : v = 170 sin 628 t volts = Vp sin w…

A: Compare the given equation with the standard equation V=vpsin ωt volts

Q: *30. Find the average power loss and power factor for each of the circuits whose input current and…

A:

Q: A voltage wave of 250 kHz has a Vmax=5 V and Vmin=-35 V. The duty cycle of this wave is 0.875. This…

A:

Q: The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True…

A: Due to guidelines we can solve one question at a time.

Q: A load is connected to a 210 V, 50 Hz supply. If it has resistance of 300 and a capacitor of 0.25…

A: Given, A load is connected to a supply with V=210 V, f=50 Hz. Resistance, R=30 Ω and Capacitance,…

Q: (b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

A:

Q: An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

A:

Q: A triangular voltage source has a peak value of 10 V. What is the computed RMS value of this source?…

A:

Q: 1/ Calculate the average and r.m.s values of the following waveform v(t), 80 50 20 .O(rad) Ans [50V,…

A: We need to find out average and RMS value for given waveform.

Q: Given the AC signal: v= 200 Sin (377t-30) a) What is the RMS voltage? b) What is the period of this…

A:

Q: When a load is connected to a power line with a frequency of 230V (rms) 50 Hz, it draws 4500 W at a…

A: We will find out reactive power ,from reactive power we will find capacitance .

Q: Calculate the R value in ohms, since the 13kHz frequency sinusoidal sign is observed at the output…

A: C= 10nF Frequency, f= 13 kHz R=?

Q: 1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the…

A:

Q: For the current waveform that shown in Figure below Find:- 1). Average value 2). R.M.S value 3).…

A:

Q: The rms current in a 33.0-N resistor connected to an AC source is 2.80 A. (a) What is the rms…

A:

Q: Vm = 10 V T = 2 ms V0 = 7.07 V 1) Find the frequency of the voltage in Hz. 2) What is the frequency…

A: