Magnetic Field of Single Coils / Biot-Savart’s Law Calculate B(0). Draw B (measured values)- n curve for current 1AB(0) (mT)I (mm)R (mm)MeasuredCalculated75160133.55150160137.003001601314.2 B: Magnetic flux densityH: Magnetic field constantI: Current flowing through areaR: Coil Radiusn: Number of trnsWhere 4, = 1.2566 10° H'm is the magnetic field constant.

According to Biot - savart law , the magnitude of the magnetic field at any point due to current…

Answered: Calculate B(0). Draw B (measured…

Calculate B(0). Draw B (measured values)- n curve for current 1A B(0) (mT) I (mm) R (mm) Measured Calculated 75 160 13 3.55 150 160 13 7.00 300 160 13 14.2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Two identical coils A and B having 1000 turns and wound on a common magnetic core. 60 % of the flux…

Q: A coil that con sists of 450 windings is wound around a bakelite rin g. The mean diameter of the…

A: We are authorized to answer only 1 question at a time since you have not mentioned which question…

Q: A mmf is supplied by a current of 1 A through 100 turns. The magnetic unit consists of a steel core…

A: Reluctance =length premeability×area And rotal reluctance is the sum of reluctance of air gap and…

Q: Scenario: Consider a magnetic circuit with a mean length of 0.6 m. A 4x102 turn coil is wound around…

A: Given a magnetic circuit made from silicon steel with a, Mean length, l = 0.6 m Number of turn, N =…

Q: ten-turn solenoid has a ferromagnetic core with a relative permeability of 10,000. The length of the…

Q: A ring of ferromagnetic material has a rectangular section. The inner diameter is 15 cm. The outer…

A: We have given the following problem A ring of ferromagnetic material has a rectangular section. The…

Q: The magnetic flux linked with a single turn coil is given by the equation: o = 5t2 + 3t + 6. The %3D…

A: Given, Magnetic flux linked with a single turn coil, φ=5t2+3t+6 The induced emf in the coil in the…

Q: A solenoid is 1 Cm long with a diameter of 0.5 Cm. The core is SiFe with a relative permeability of…

A: Length of solenoid Diamter Current I = 100 mA.Relative permeability Magnetic field

Q: Two identical coils A and B having 1000 turns and wound on a common magnetic core. 60% of the flux…

A: Given:Number of turns in coil A=1000Number of turns in coil B=100060% of the flux is linked…

Q: Given a common magnetic core whose length is 100 cm, its cross-sectional area is 25 cm square. The…

Q: Problem 1 In the magnetic circuit shown in figure P-1 the depth of the core is 5 cm. The winding has…

A: Core depth d=5cm Number of turns N=400 Relative premeability μr=4000 Current I=5A Asked to find…

Q: rectangular coil of wire has a length of 3 cm and a width of 4 cm. It is in a 0.004 T magnetic…

Q: A biped magnetic core (core) is shown in the figure. The coil on the left leg of this core (N1) has…

A: In this question we need to find the flux produced by coil current i1 and i2 .

Q: Explain the hysteresis that can be found in materials due to force, magnetic and electrical…

A: The behavior of a ferromagnetic materials like iron, cobalt, and nickel can easily explained in…

Q: The applied MMF to a simple magnetic circuit is 350AT. It was found that the resulting magnetic…

A: Flux in core = flux density × area of core. But flux = mmf / reluctance. Substitute given values to…

Q: The physical construction of two pairs of magnetically coupled coils is shown. Assume that the…

A: (a) The magnetically coupled coils are shown below: As per the direction of the fluxes, there are…

Q: 4. Consider a coil of wire wrapped around an iron core. If the flux in the core is given by the…

Q: H+ 7 cm 30 cm +4 7 cm 7 cm -0.07 cm 30 cm- +7 cm+ 300 turns 30 cm- 0.05 cm cm Core depth = 5 cm

A: Given data Relative permeability; μr=1500 Core depth=5 cm Number of turns on the center lag of the…

Q: directions shown in the figure. If the dimensions are as shown, then what flux would be produced by…

A: In this question we need to choose a correct option.

Q: In a certain magnetic circuit, the core is represented two reluctances as shown below. Assume a…

A: The magnetic circuit diagram is shown below, Number of turns, N=640 turns.Current, I=2.2 A.

Q: A magnetic circuit consists of silicon steel of 3000 permeability and an air gap. The length of the…

A: MMF = H ×length MMF = NI Where N is number of turns and I is current in the coil. so find H in each…

Q: A magnetic circuit has a mean flux path length of 800 mm and a reluctance of 2.5.105 A-t/Wb. A…

Q: Two identical coils connected in parallel, each with a coefficient of self-induction (L), each…

Q: The reluctance of a non-magnetic path is 12 AT-Wb. Find the flux needed to be set up if surrounded…

Q: Example(6): A magnetic circuit containing an air gap is shown in Figure below. With the dimension as…

A: Given data, Ac=Ag=5 cm2=Area of core =Area of air gapg=gap=0.2 cmlc=20 cm=Length of coreN=100…

Q: A coil that consists of 450 windings is wound around a bakelite ring. The mean diameter of the ring…

A: When a coil of turn N is wounded on a ring with peripehral length L and carry a current I then it…

Q: Figure 1 shows a ring formed with two different materials – cast steel and mild steel. Mild steel…

Q: In a certain magnetic circuit, the core is represented two reluctances as shown below. Assume a…

A: In this question, we need to determine the current in the circuit to produce the given flux. We…

Q: Draw the electrical circuit analog for the magnetic circuit shown below. Pay special attention to…

A: According to right hand thumb rule find the polarity of the mmf sources . Then find the analog…

Q: The magnetic structure in the figure below is made of silicon steel. Determine the values of IB…

A: Note: Relative permeability (μr) for silicon steel is not given . We assume μr = 2000 Given NB=…

Q: The self-inductances of the coils in Fig. 6.30 given below are L 1=25 [mH] and L3=100 [mHJ. If the…

A: Fig: Given circuit Given that i1=10AL1=25 mHL2=100 mHK=1calculate…

Q: An air core toroidal coil has 120 turns, the length is 12 cm and 12 sq. cm in area What is the…

Q: 3- A magnetic core with an air gap is shown in below Figure. The depth of the core is 3 cm, the…

A: Reluctance Reluctance is a property of magnetic material which opposes the flux in the magnetic…

Q: A simple generator has a square armature 9.0 cm on a side. The armature has 80 turns of…

A: In the circuit, Find the value of frequency f. We know Emf = 4.44fN Φm . All parameters are given.

Q: Consider the magnetic circuit in Figure. Assuming that the core µ= 1000µo has a uniform cross…

Q: Problem 4 The magnetic circuit shown in the figure has two windings and two air gaps. The core can…

Q: Probl The rectangular coil in the figure below is in a field B = 0.01a,T. a. Find the torque about…

Q: In a magnetic circuit, the property by which the flux generated in the core of the circuit is…

A: Flux Density:- It is defined as the uniformly distributed flux per unit area of the cross-section…

Q: The relative permeability of a certain silicon steel is 4500. A certain magnetic loop consist of a…

A: According to the question we have to find the value reluctance of the magnetic circuit.

Q: The flux in a magnetic circuit is analogous to in electric circuit ....... resistance current emf…

A: In electric circuit, I=VR Where, I is current, V is EMF and R is resistance. In magnetic circuit,…

Question

Magnetic Field of Single Coils / Biot-Savart’s Law

Calculate B(0). Draw B (measured values)- n curve for current 1A
B(0) (mT)
I (mm)
R (mm)
Measured
Calculated
75
160
13
3.55
150
160
13
7.00
300
160
13
14.2

B: Magnetic flux density
H: Magnetic field constant
I: Current flowing through area
R: Coil Radius
n: Number of trns
Where 4, = 1.2566 10° H'm is the magnetic field constant.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. A magnetic circuit constructed of sheet steel has an average length of 1.5 m and cross sectional area of 0.025 m². A 50 turns coil wound on the ring has a resistance of 0.8 Q and draws 4 A from A DC supply. The relative permeability is 5000. Determine a) The flux density. b) Voltage applied. c) If the material is replaced with another material with a relative permeability of 3000 and keeping the other parameters as it is then calculate the new flux and explain what happened.
A magnetic circuit has 150 turns-coil, the cross- sectional area 5 x 10-4 m2 and the length of the magnetic circuit 25 x 10-2 m. What are the values of magnetic field intensity and relatíve permeability when the current is 2 A and total flux is 0.3 x 10-3 Wb? (a) 1200 AT/m and 397.9 (b) 300 AT/m and 500 x 10-6 (c) 300 AT/m and 397.9 (d) 1200 AT/m and 500 x 10-6
Consider the magnetic circuit given in below figure with parameters: u=153 Ho, d1=9 cm, d236.2 cm, d3=7.9 cm, da=0.3 cm and N=497. Assume that all branches have the same cross-sectional area of 5 cm. Magnetic flux density is 0.1 Wb/m2 in the air gap. Based on the given configuration calculate the current I in [A] in the coil. d2 d3 d, Tolerance + 0.1 relative
The magnetic flux through each turns off a 100-turn coil is (³-2) milli-webers where t is in seconds. The induced EMF at t = 2 second is?
Magnetic saturation is that condition of a magnetic material when all of the magnetic domains are oriented in the direction of the applied mmf True False
Explain why do we need a B-H curve when we solve a parallel magnetic circuit in which one of the fluxes is give?
Below you can find a ferromagnetic core and its magnetization curve. If i1=0.4 A and i2= 0.9A, find magnetic flux in the core and the relative permeability under these conditions.
A 2-pole machine is designed to have an armature emf of 600 V. The armature has 35 slots with 16 conductors in each slot. Find the maximum allowable number of turns per coil, and the corresponding number of commutator segments
The applied MMF to a simple magnetic circuit is 350AT. It was found that the resulting magnetic field denstiy is 0.7 Wb/m2. The average length of this magnetic circuit is 1.64ft and its cross-sectional area is 4cm². What is the relative permeability of the magnetic material of the core?
A three-legged ferromagnetic magnetic core with the coil dimensions shown below has a of 500 turns wrapped around the right leg. The core relative permeability is 4000 times, The magnetic flux in the left leg of the core has a value of 40 mWb. The center leg has an air gap of 0.8 mm, its fringing effect is neglected. Draw the corresponding magnetic circuit and find the values of the coil current i, and the flux in each leg of the core. cm 10 cm, 25cm 25 cm 10 cm 10 cm 25 cm 0.8 mm 500 turns 10 cm Core depth = 10 cm