Question 12Caffeine, benzoate, and aspartame content of mountain dew soda was determined using reverse phase HPLC. The concentration of the standard used are as follows, caffeine: 0.70 mg/mL, benzoate: 1.6 mg/mL, and aspartame 5.0 mg/mL. The following volume of the standards were taken to a 50.0 mL volumetric flask and diluted to themark to construct a calibration curve:CaffeineBenzoateAspartame1 mL1 mL1 mL2 mL2 mL2 mL3 mL3 mL3 mL4 mL4 mL4 mL5 mL5 mL5 mLThe 12-oz can mountain dew sample were treated as follows: The 12- oz can were has been left out overnight to get rid the carbonation then, 2 mL were drawn into a plastic syringe, filtered, and placed into a vial. An equal amount of deionized water was added. A 100 μL sample were injected into a sample loop using same parameterswith the standards. Assume 12 oz = 354.9 mLThe following data were obtained:Peak AreaBenzoateCaffeineAspartameStd 12.303.543.33Std 24.105.595.83Std 37.379.989.63Std 49.5614.6012.78Std 512.1818.1616.33Mountain Dew10.2114.977.96Determine the equation of the line for caffeine.O A.y = 119.531x - 1.101O B. y 180.142x -0.464O C. y = 32.95x -0.305O D.y = 314x - 6.10

Given: Concentration of standard Caffeine used = 0.70 mg/mL Concentration of standard Benzoate used…

Caffeine, benzoate, and aspartame content of mountain dew soda was determined using reverse phase HPLC. The concentration of the standard used are as follows, caffeine: 0.70 mg/mL, benzoate: 1.6 mg/mL, and aspartame 5.0 mg/mL. The following volume of the standards were taken to a 50.0 mL volumetric flask and diluted to the to const a calibration curve:

Caffeine, benzoate, and aspartame content of mountain dew soda was determined using reverse phase HPLC. The concentration of the standard used are as follows, caffeine: 0.70 mg/mL, benzoate: 1.6 mg/mL, and aspartame 5.0 mg/mL. The following volume of the standards were taken to a 50.0 mL volumetric flask and diluted to the to const a calibration curve:

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

6) Provide a sample calculation for determining the mass of glucose, in milligrams, in the cuvette that contains the assay solution for the 0.02M Glucose Standard. The molecular weight of glucose is 180 g/mol, or 180 mg/mmol.
Calculate the concentration of sodium hydroxide solution in g/l and in mol/L
25mL 10% Na04 salution ? mmol theo mmoldikenzalacetone theo mass divemaaletone mass recovered 1 mmol 26g benzaldehyde. ? ML 2 mmol 7. 0.8mL acetone 2 mmol
VIII. A primary standard of HCI is sodium carbonate, Na2CO3. A measured mass of solid Na2CO3, mNa2CO3' in grams, is dissolved in water and then titrated with HCI solution using methyl 2 NaCl + CO2 + H2O. orange indicator. The reaction is: Na2CO3 + 2 HCI- Complete the following formulas using the context described above: MHCI × VHCI in mL at the methyl orange endpoint = mNa2CO3 × ( )= mol of Na2CO3 mol of Na2CO3 X (— ( - - )= mol of HCl
Solution X 100 mL of 0.10 M NaOH(aq) is mixed with 100 mL of 0.10 M HBr(aq) Solution Y 100 mL of 0.10 M NaBr(aq) is mixed with 100 mL of 0.10 M HBr(aq) Solution Z 100 mL of 0.10 M HC,H,O,(aq) is mixed with 100 mL of 0.10 M NaC,H3O,(aq) 6. A student prepares three solutions, X, Y, and Z, as described in the table above. The values of Ka for the acidic species in the solutions are given in the table below. Species Ka HBr(aq) >>I (very large) HC,H;O,(aq) 1.8 x 10-5 a. Using the information above, write the letters of the solutions in the boxes below to rank the solutions in order of increasing pH. Explain your reasoning for the ranking Lowest pH Highest pH b. Does the pH of solution Y increase, decrease, or remain the same when 100 mL of water is added? Justify your answer. c. The student adds 0.0010 mol of NaOH(s) to solution Y, and adds 0.0010 mol of NaOH(s) to solution Z. Assume that the volume of each solution does not change when the NaOH(s) is added. The pH of solution Y changes…
12 of 19 View Available Hint(s) ? molarity of luminol solution : Value Units %3D
Apple seeds contain amygdalin, a substance that releases cyanide into theblood stream. if 3.5 kg of apple seeds contain 750 milligram of amygdalin, theconcentration of cyanide in ppm will be.. * Non of these O 214.28 0.0046 O 4.66 O 0.214
Just needing help on part b please.
number 15 (POST) please answer A&B ! thank you!
please answer fast i give upvote
A sample may contain any combination of sodium hydroxide, sodium carbonate and sodium bicarbonate with inert matter. A 3.00g sample requires 57.57ml of 0.5N hydrochloric acid to reach phenolphthalein endpoint and a total of 105.4ml of acid was used until the methyl orange endpoint was reached. What is the percentage inerts in the mixture? What is the percentage sodium bicarbonate in the mixture? What is the percentage sodium hydroxide in the mixture? What is the percentage sodium carbonate in the mixture?
please calculate the concentration in ppm (last column) for each solution