C1 (i). Three Identical capacitors are connected in delta to 420 Volts, F = 50 Hz, 3 phase supply. If the line current is 14 A. Calculate its reactance and capacitance value. [3 marks) Reactance Xc is The capacitance of each capacitor, C

C1 (i). Three Identical capacitors are connected in delta to 420 Volts, F = 50 Hz, 3 phase supply. If the line current is 14 A. Calculate its reactance and capacitance value. [3 marks) Reactance Xc is The capacitance of each capacitor, C

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A coil of resistance 52 and inductance 120 mH in series with a 100 µF capacitor, is connected to 300…

A: Now, the below figure shows the circuit diagram of the given data :

Q: Don't use chatgpt will upvote

A: Step 1:Step 2:

Q: Air-cooled condensers and cooling towers can be cooled by a propeller fan Select the correct…

Q: 2 The zero energy of the-19 * simple harmonic oscillator is E=hw E=hw/2 E=3hw/2

A: The lowest allowed harmonic oscillator is not zero, it is hw/2

Q: 4.Find the gain vo/vs of t

A: To find Gain of circuit

Q: find the complex Fourier series of fon the given interval. f(x) = x, 0 <x<27

A: The complex Fourier series is, f(x)=π+∑n=-∞n≠0∞ineinx

Q: Which of the following are correctly defined periodic functions: I1 h(t)=t+3, 0<t<2, h(t+4)3h(t) Il…

A: given; find periodic fumction;(i)h(t)=t+3 ,0<t<2 ,h(t+4)=h(t)(ii) g(t)=sin(t) ,0<t<π,…

Q: what is unit impulse response?

A: Impulsive excitations are considered to be a large magnitude force that acts over a very short time…

Q: An alternating current in a 4G signal transmitter is expressed as I= 5 sin(120nt + 0.52), I in mA, t…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: current t

A: I=0.05mA kindly refer attached file for detailed answer.

Q: A 10kW, 120V-DC series generator has an armature resistance of 0.1 ohms and a series field…

Q: For a sinusoidal voltage trace displayed by the CRO, the time/cm switch is on at 700μs/cm and…

A: Given dataTime per second = 700 μs/cmvoltage per cm of switch = 5V/cmWidt of the complete cycle =…

Q: 3. Figure 3 shows a nonlinear circuit consisting of a diode and a capacitor in parallel combination.…

A: (a) When the system is in equilibrium, the voltage ( v(t) ) is constant, denoted as (vo). In this…

Q: 10/. A capacitor of 1 μF is connected to a 50 Hz supply. The capacitive reactance (Xc) is…

A: Reactance

Q: Determine the reverse voltage and reverse current for the diode for each diode models. Also, find…

A: To calculate 1.The reverse voltage and reverse current for diode 2.The voltage across the limiting…

Q: epiciency of the system n2=95%, and ny=70%. Ger tin Geno

A: GIVEN:ηl=80%η2=95%η3=70%

Q: Three Identical capacitors are connected in star to 430 Volts, F = 50 Hz, 3 phase supply. If the…

A: Given data: The line voltage value is, VL=430 V. The frequency value is, f=50 Hz. The line current…

Q: 1) What is the name for 1, 2, 5 and 6 respectively? 2) What is the function of this circuit?…

Q: Q4 For the circuit shown in Figure below, calculate the current dr and husing the mesh analysis…

Q: 9. An R-L series circuit contains a resistor and an inductor. The resistor has a value of 6.5 2. The…

A: Question - 10: The voltage drop across the resistor in an R-L series circuit can be found using…

Q: In figure below, The total voltage of .3 * the sources connected in series is 6 V 6 V 8 V +20v O +4v…

A: Voltage in series =8-6-6=-4V

Q: Find out the error for the io = 1.7e-8; % dark saturation current tc = 27; % cell temperature in…

A: given data

Q: An N-degree of freedom system with no repeated natural frequencies will have O N resonances O 1…

A: Resonance occurs when the frequency of the system becomes equal to the natural frequency of the…

Q: 2. In both circuits of this exercise the negative terminals of the sources are connected to ground.…

A: when the negative terminals of sources are connected to the ground, for nodal analysis it is a…

Q: 8. For the sine wave in Figure 11-77, determine the peak, peak-to-peak, rms, and aver- age values.…

A: A sine wave graph is shown in figure below,

Q: A (18 KW), 420 V, 50 Hz, three phase star connected synchronous Motor with synchronous impedance Zs…

A: Given dataPower = 18kWVolts V = 420VFrequency f = 50HzSynchronous impedance Zs = 1+5 ohm/phaseTo…

Q: In the network shown, Find the current I and the power supplied by the voltage source, for V = 6 V.…

A: We need to calculate the current and power in the question

Q: An R-L series circuit has a reactive power of 1234 VARs and an apparent power of 4329 VA. By how…

A: DISCLAIMER FOR MULTIPLE Since you have asked multiple question, we will solve the first question for…

Q: 4. A circuit contains a 20-92 resistor and an inductor with an inductance of 0.093 H. If the circuit…

A: Given: Resistance and inductance Required: Total impedance.

Q: 1. The armature and shunt field resistance of a 50-kW, 220 V shunt generator is 0.026 ohm and 52…

Q: The following circuit is known as a peak detector. When a time-varying signal Vin is applied at the…

Q: Given the model * – (μ + 2)x + (2μ + 5)x = 0 b. For the stable case, for what values of μ is the…

Q: 2-Calculate characteristic length, (m); L̟ =V/ Biot number Bi =".L k :Fourier number ; diffusivity a…

A: Solution The characteristic length of the wall LC=VAS=t2×w2t×w=t2 where t =…

Q: 1. If a E G has order d, prove that a' also has order d if and only if r and d are relatively prime.…

Q: Question 10 + x¡(t) k3 m2 Using the Figure above, Take k=3, k2-3, kg-4 and my=1, mg1, mgu1 The…

Q: The input power to a 3-phase load is measured as 6600 watts. If the line voltage and line current to…

Q: The current in an inductor decreases linearly from 2 mA to zero in 4 ms. Calculate the average emf…

Question

C1 (i). Three Identical capacitors are connected in delta to 420 Volts, F = 50 Hz, 3 phase supply. If the line
current is 14 A. Calculate its reactance and capacitance value. [3 marks]
Reactance Xc is
The capacitance of each capacitor, C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Phase Diagrams and Its Applications in Metallurgy

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A transformer transforms (a) frequency (b) voltage (c) current (d) voltage and current. 2. Which of the following is not a basic element of a transformer? (a) core (b) primary winding (c) secondary winding (d) mutual flux. 3. In an ideal transformer, (a) windings have no resistance (b) core has no losses (c) core has infinite permeability (d) all of the above. 4. The main purpose of using core in a transformer is to (a) decrease iron losses (b) prevent eddy current loss (c) eliminate magnetic hysteresis (d) decrease reluctance of the common mag- netic circuit. 1
3
فقرة Q3 Find the phase relationship for the following waveforms,also sketh. a)v = 5sin(wt-70°),i=sin 2.5(wt+10°) b)v=-4sin(wt+10°), i = 2cos(wt+80°) I
5....
A voltage signal having the equation v(t) = 325.269 sin(376.99t - 30). What is the average voltage? 230V O 120V O 207.07V 325.269V
rad 2- A uniform plane wave of angular frequency w = = 5x10® propagates in a lossless medium sec with parameters ɛ = 9ɛo and u = µo. The phasor electric field intensity is in the form Ē (f) = (Aây + j2âz)e-skxx-4y) (V/m) Where ky is a real, nonzero, positive constant. a) Comment the value of A. Can it be different from zero? Verify your answer. b) Determine the value of ky. c) Find the expression for the time-domain electric field intensity. d) Determine the polarization (type and sense, if applicable) of this wave. e) Find the expression for the phasor magnetic field intensity, H(f).
how to solve it and how to now if - 120 or +120 i need her solving with explain please quickk
3. For the circuit below, calculate the Thevenin equivalent circuit seen through the terminals (a, b). Please make sure you draw the equivalent Thevenin equivalent. a 2 Ω W 3 Ω b 5 Ω 20 ww 10 V 3 Ω +
The equation underneath is do to with resonance, however resonance occurs when the input frequency is equal to the natural frequency what does this equation mean?