c. Determine the vertical deflection of point C using the conjugate-beam method. Use the conjugate-beam method to determine the slopes at ends A and D and the deflections at points B and C of the beam shown 80KN 150kN A В C D El = constant E = 12.5 GPa I = 1.92 × 1010 mm4 %3D %3D

Q: The pin at C is supported in a double shear connection. If the allowable shear stress is 70 MPa,…

A: step 1-

Q: 25KN 3M lookN 3M の

A:

Q: d W.S. 22.5KN 60⁰ pulley 5m hinged (Width normal to paper -2.8m)

A:

Q: Calculate the forces in the members EF, EG, EH and FH of the truss shown in Fig. P.4.6. Note that…

A: Using section and joint method

Q: The water nozzle ejects water at a speed vo = 39.8 ft/sec at the angle e = 34°. Determine the…

A: Ans is  2.675 feet, details are provided below

Q: A 180 kN 1.5 m 1.5 m 3 m Hinge B 3 m 180 kN 3 m

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.