(c) Suppose a transmitter produces 50 W of power. (1) Express the transmitter's power in units of dBm and dBW. (i) If the transmitter's power is applied to a unity gain antenna with a 900-MHz carrier frequency, determine the received power in dBm at a free space distance of 100m and 10 km, respectively.

(c) Suppose a transmitter produces 50 W of power. (1) Express the transmitter's power in units of dBm and dBW. (i) If the transmitter's power is applied to a unity gain antenna with a 900-MHz carrier frequency, determine the received power in dBm at a free space distance of 100m and 10 km, respectively.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

4.) How much power (in mW) is received when a 1 GHz signal with a power density of 5 mW/m² is intercepted by an antenna having a gain of 10 dB?
For an Omni-directional antenna, the measurements show the Half Power Beam Width (HPBW) in vertical and horizontal planes are 30 degree and 20 degree respectively. If this antenna has a loss resistance of 25ohm and efficiency n=0.8, calculate:i. Antenna’s gain in dB;ii. Radiation resistanceiii. How the efficiency of this antenna can be improved? Support your answer with applicable equations and results.
The transmit power is 20 dB, the transmit antenna gain is 2 (in linear scale), the receiveantenna gain is 3 (in linear scale), the carrier frequency is 300 kHz, the transmit antenna heightis 10 meters, the receive antenna height is 1 meter, the distance between the transmitter andreceiver is 1 km, L = 1. The transmission environment is air (the path loss exponent is 2). Usethe free space propagation model.a. Calculate the receive power in dBm.b. Calculate the path loss in dB.
2. We wish to transmit the information signal vm=5sin (2x6,000t) V. a) Calculate the wavelength of the given signal. b) Would it be practical to directly transmit this information signal using an antenna? Why/why not? c) Suppose a carrier signal of vc = 10sin (2x250,000t) V is amplitude-modulated by the information signal given above. Sketch and label the frequency spectrum (i.e., the frequency domain representation) of the baseband signal, the carrier signal and the AM signal (three separate sketches are required). d) What is the bandwidth of the AM signal?
You are given 5 identical antennas (with the same structure and features) of unknown gain to be used at 2 GHz. One of the antennas is connected to a transmitter with an output power of 0.01 W, and the other to a receiver 10 m away. Since the power of the received signal is measured as 9 uW, find the gain of the antennas. (You can assume free space radiation between the receiving and transmitting antenna)
A 0.48520λ0 dipole antenna is made to work at 4 GHz. The antenna is then connected to a 12 V voltage source which has an internal resistance of 25 Ω) a) Make a diagram of the above system, b) Is an impedance matching circuit needed? If yes, where should the impedance circuit be inserted and make a diagram of the system with the adjusting circuit, c) How many cm is the length of the dipole antenna above, d) How much power is emitted when not using the adjusting circuit and e) How much power is emitted when using the adjusting circuit. Solve subparts D,E max 20 minutes ASAP
B) If transmitter produced 50W of power is applied to an antenna with 1.2GHz carrier frequency, find the path loss and the received power in dem by using: 1) Free space model at 10 km of distance, if hBs=30m and hмs=1m. Lee model at 10 km of distance, if hBs=25m and hms=1m. Assume unity gain of antennas.
Suppose a transmitter produces 0.5 W of power. (a) Express the transmit power in units of dBW (decibel-watt) and dBm (decibel- milliwatt). (b) If the transmitter's power is applied to a unity gain (i.e., G=1) antenna with a 100- MHz carrier frequency, what is the received power in dBm at a free space distance of 200 meters? Assume that the receiver's antenna has a unit gain too.
Problem 2.4 Assume that the antennas in Problem 2.3 are dish antennas such that A =. If the beamwidth factor for either antenna is 51°, find the beamwidth of each antenna for each frequency. Problem 2.5 A receiver is located 5 km from a transmitter in free space. The output at the termi- nals of the receive antenna is -87 dBm. The receive antenna has a gain of 2 dBd and there is a total of 2.8 dB of system loss. Calculate the transmitter EIRP in watts given a transmit frequency of 890 MHz. If the transmit antenna has a gain of 7.5 dBi, what is the transmit power in watts? Problem 2.6 A transmitter radiates an ElIRP of 1 W into free space. A receive antenna located at 1 km from the transmitter has a gain of 5 dBi. Assume that there are 2 dB of system loss. A. If the system operates at 900 MHz, what is the power level at the output of the ontonna terminals?
If 50 watts are transmitted by a unity gain antenna at 900 MHz carrier frequency, find the received power (assuming unity gain receiver antenna) [W] at a free space distance of: i) 100 m from antenna and ii) 10 km from antenna.
Suppose you have a receiver whose sensitivity is -100 dBm (minimum received power with which it can operate) and a signal is transmitted to it at a power of 1W. At both ends of the link there are antennas with 3dB gains; installed at heights of 5 and 1 meter, respectively. The stage is flat terrain with no obstacles. What is the maximum distance that these transmitters can be separated? Assume an operating frequency of 700 MHz.
3 Signal strength. A transmitting antenna of 100 m height radiates 50 kW at 30 MHz uniformly in azimuth plane. Calculate the maximum LOS range and strength of the received signal at 9 m high receiving antenna at a distance of 20 km. At what distance would the signal strength reduce to half of that received at 20 km?