C- Consider the causal LTI systems described by difference equation, determine the impulse response of the systems (y [n]). 5 y[n]+ y[n=1]-y[n=2]= x[n]-÷x[n-1]-x[n- 2] 4

Q: an input signal ranges from 20–40 A (microamps), with an output signal ranging from .5–1.5 mA…

A:

Q: What is the mean value of half-wave rectified output signal if the peak voltage of input sine wave…

A: Peak voltage Output waveform of half wave rectifier is given by,

Q: (a) Define sampling and quantization.

A: In this question we will define sampling and quantization....

Q: When using Oscilloscope Differential Probes Select one: a. A differential probe uses a built in…

A: When using Oscilloscope Differential Probes :

Q: Why there is a need to study about digital Electronics?

A: Given: Digital electronics

Q: 16/ Which of the following can be used in amplifier circuits? a. Transistors b. Photodiodes c.…

A:

Q: In a controlled process sample data in Normal pattern. Explain Yes or No

A: Yeas controlled process sampled Data is normal in pattern  Control charts square measure a way of…

Q: Report 4-1 IC 555 chip and using it as oscillator circuit to generate a binary output signal and a…

A: Astable IC 555 - The 555 Timer IC may be attached in both Monostable or Bistable mode to make a…

Q: Find this specification of 333 -2SURC/S400 -A8 (LED)

A: 333 -2SURC/S400 -A8  LED is manufacture by the mouser electronics LED means - Ligh emitting Diode

Q: 19) Consider a 6-bit ADC and full scale voltage measurement range of (0-59).The Resolution will be…

A: Given that  fullscale value  is 59 6-bit n = 6 Resolution = (Full scale value )/2^n

Q: Create the Diode Characteristic Curve for this data values. Diode Voltage (VD) Diode Current (ID)…

A: Given,  Diode voltage, VD (in volts) Diode current, ID (in Amperes) 1.374 8.626 1.279 6.721…

Q: Then write down three things that have changed from analogue to digital. What was the reason for…

A: Analog marketing is marketing that uses analog channels to interact with customers, such as…

Q: (a). Write any two advantages of a digital signal over an analog signal.

A: We need to write two advantage of digital signal .

Q: The Excess-3 value of (0111.1010) 2 is

A: Excess 3 code of the given Add 0011 in each four bit

Q: 6. Draw the circuit diagram and find the value of 'X' bit for a digital to analog conver, if Vout…

A: According to the question we have to draw the circuit diagram and find the value of 'X' bit for a…

Q: (2) Consider a frequency modulated signal. The modulating signal frequency is increased from 10 kHz…

A: In this question we have to find the correct optionsrgarding modulated signal bandwidth

Q: Question) Why to Digital and viee conversion im below mentioned process? need Amala we Nersa we…

A: Any physical signal,such as sound,or a light,or a voltage is considered an analog signal. The thing…

Q: Using Flash ADC method to convert the analoge voltage signal to digital (3-bit) ,where Vi=5V and…

A:

Q: 6.q1

A: To solve the given problem for an 8-bit Digital to Analog (D/A) converter with an output voltage…

Q: A 5-bit flash converter has a reference voltage of 16 V. What is the center code voltage for a…

A: The solution is given below

Q: 7.what do you mean by instruction cycle,mechine cycle and T- state

A: Instruction cycle: The time taken by the processor to  fetch and execute an instruction is called…

Q: Discuss the evolution of microchip technology and its impact on the field of electronics.

A: We need to discuss the evolution of microchip technology and its impact on the field of electronics.

Q: The primary to secondary turns ratio of a transformer used in a HWR is 20:1. The primary is…

A: The solution is given below

Q: 64) A circuit that provides a varying output signal, typically of square-wave or triangular-wave…

A: VCO is a type of oscillator that can produce varying outputs based on the DC voltage.

Q: 6.q1

A: The resolution of a D/A converter is the smallest change in voltage that can be produced by a 1-bit…

Q: How to do the study of Digital Electronics

A: Digital Electronics

Q: ISCUSSION: Give to applications for the multiplexer.

A: There are following multiplexer application are: 1.  We can take output as per according…

Q: Compared to Gallium Arsenide (GaAs), Silicon: 1. Higher signal rate as electron mobility is higher…

A: GaAs has Arsenic which has higher vapor pressure.

Q: State three advantages of digital technology compared with analog technology.

A: Analog technology is very complex to design, but digital technology is not complex in design; it can…

Q: n ideal operational amplifier circuit in the closed-loop negative-feedback configuration is shown in…

A:

Q: What is the principle of the method for direct digital synthesis (DDS) of analog signals?

A: We need to explain the principle of the method for direct digital synthesis (DDS) of analog signals.

Q: 3- What are the factor which affect the frequence stability of an oscillator?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: disadvantages of Digital System over Analog System

A: Digital system : A system which contains devices such as flip flops,registers,logic gates and…

Q: Discuss the challenges and innovations in printing electronics and flexible circuits for various…

A: Printing electronics and flexible circuits represent a rapidly evolving field with a wide range of…

Q: Explain in detail, what is the difference between sampling and quantization

A: To create digital image continuous data is converted to digital form. This conversion needs two…

Q: Design circuit BCD-8421 to 7 segment Decoder using Gate circuit. combination

A: BCD to 7-segment decoder

Q: Figure Q4(a)(1) shows two unit of multiple clock source. Referring to the internal circuit diagram…

A:

Q: However, what exactly is digital audio? how analog sound waves are converted into digital audio.

A: Digital signal: Any signal that transmits data as a series of discrete numbers is referred to as a…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.