Bronze Aluminum ЗР Steel 2P P 4P - 0.6 m →- 1.0 m - e 0.8 m A (mm²) E (GPa) a, (MPa) Bronze 450 83 120 Aluminum 600 70 80 Steel 300 200 140

Q: d has a diameter of 40 mm. (Figure 1) It is ed to the force system Fx = 1560 N, 505 N, F=830 N. Part…

A:

Q: Answer fast and explain the answer

A:

Q: 3. The stress element is shown in the figure. Determine the equivalent stress according to the third…

A: Solution: Given: σx=40 MPaσy= 40 MPaτxy=60 MPa Equivalent stress according to third and fourth…

Q: Three round bars welded together axially loaded as shown. Find the normal are stress in each bar if…

A: Stress is defined as the force acting per unit area of a bar. The stress in a bar is directly…

Q: The 1.16-in.-diameter rod in (Figure 1) is subjected to the loads shown. Determine the state of…

A:

Q: The 1.16-in. diameter rod in (Figure 1) is subjected to the loads shown. Determine the state of…

A:

Q: A rod is composed of an aluminum section rigidly attached between steel and bronze sections, as…

A: σ=PA     ----( 1 ) here σ is stress , A is cross sectional area and P is force applied Calculate σst…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.