Blocks A and B each have a mass m = 14 kg. The coefficient of static friction between A and B is μs = 0.3. The angle shown is 0 = 48°. Neglect any friction between B and C. A P 0 B C Determine the largest horizontal force P that can be applied so that A will not slip on B Ŕ = number (rtol=0.05, atol=1e-08) N

Blocks A and B each have a mass m = 14 kg. The coefficient of static friction between A and B is μs = 0.3. The angle shown is 0 = 48°. Neglect any friction between B and C. A P 0 B C Determine the largest horizontal force P that can be applied so that A will not slip on B Ŕ = number (rtol=0.05, atol=1e-08) N

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 76PQ: Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to...

See similar textbooks

Similar questions

Check Your Understanding Find the angle between forces F1and F3in Example 2.16.
A piece of bacon starts to slide down the pan when one side of a pan is raised up 5.0 cm. If the length of the pan from pivot to the raising point is 23.5 cm, what is the coefficient of static friction between the pan and the bacon?
(a) What is the maximum frictional force in the knee joint of a person who supports 66.0 kg of her mass on that knee? (b) During strenuous exercise, it is possible to exert forces to the joints that are easily 10 times greater than the weight being supported. What is the maximum force of friction under such conditions? The frictional forces in joints are relatively small in all circumstances except when the joints deteriorate, such as from injury or arthritis. Increased frictional forces can cause further damage and pam.
In Problem 10, the mass of the sign is 25.4 kg, and the mass of the potted plant is 66.7 kg. a. Assuming the objects are in equilibrium, determine the magnitude of the static friction force experienced by the potted plant. b. What is the maximum value of the static friction force if the coefficient of static friction between the pot and the roof is 0.572?
A uniform pole is propped between the floor and the ceiling of a room. The height of the room is 7.80 ft, and the coefficient of static friction between the pole and the ceiling is 0.576. The coefficient of static friction between the pole and the floor is greater than that between the pole and the ceiling. What is the length of the longest pole that can be propped between the floor and the ceiling?
A crate of mass 100.0 kg rests on a rough surface inclined at an angle of 37.0with the horizontal. A massless rope to which a force can be applied parallel to the surface is attached to the crate and leads to the top of the incline. In its present state, the crate is just ready to slip and start to move down the plane. The coefficient of friction is 80of that for the static case. (a) What is the coefficient of static friction? (b) What is the maximum force that can be applied upward along the plane on the rope and not move the block? (c) With a slightly greater applied force, the block will slide up the plane. Once it begins to move, what is its acceleration and what reduced force is necessary to keep it moving upward at constant speed? (d) If the block is given a slight nudge to get it started down the plane, what will be its acceleration in that direction? (e) Once the block begins to slide downward, what upward force on the rope is required to keep the block from accelerating downward?
A 0.400-kg pendulum bob passes through the lowest part of its path at a speed of 3.00 m/s. (a) What is the tension in the pendulum cable at this point if the pendulum is 80.0 cm long? (b) When the pendulum reaches its highest point, what angle does the cable make with the vertical? (c) What is the tension in the pendulum cable when the pendulum reaches its highest point?
In a tug-of-war game on one campus, 15 students pull on a rope at both ends in an effort to displace the central knot to one side or the other. Two students pull with force 196 N each to the light, four students pull with force 98 N each to the left, five students pull with force 62 N each to the left, three students pull with force 150 N each to the right, and one student pulls with force 250 N to the left. Assuming the positive direction to the tight, express the net pull on the knot in terms of the unit vector. How big is the net pull on the knot? In what direction?
A rectangular block has a length that is five times its width and a height that is three times its width. The blocks surfaces are all identical except for size. When the block is placed on a horizontal tabletop so that the area in contact with the table is length width, it is found that a horizontal force of 10.0 N applied to the block is just sufficient to overcome the static friction force and cause the block to move. The block is then knocked over so that the area in contact with the table is length height. Now, what minimum horizontal force will cause the block to move? Explain.
Check Your Understanding Suppose that Balto in Example 2.10 leaves the game to attend to more important matter, but Astro Clifford and Dug continue playing. Astro and Clifford’s pull on the toy does not change, but Dug rims around and bites on the toy in a different place. With how big a force and in what direction must Dug pull on the toy now to balance out the combined pulls from Clifford and Astro? Illustrate this situation by drawing a vector diagram indicating all forces involved.
A One end of a metal rod of weight Fg and length L presses against a corner between a wall and the floor (Fig. P14.64). A rope is attached to the other end of the rod. Find the magnitude of the tension in the rope if the angle between the rod and the rope is 90.
Find the angle between vectors for (a) D=(-3.0i-4.0j)m and A=(-3.0i+4.0j)m and (b) D=(2.0i+4.0j+K)m and B=(-2.0i+3.0j+2.0K)m .