Block A of mass 2.0 kg moves with a velocity of 10 m s-1 B of mass 3.0 kg moves with a velocity of 5.0 m s-1 in from spring of force constant, k = 1000 N m-1 is attached to B 2.0 kg %3D 3.0 kg A

Q: A four-cylinder engine, with a cylinder capacity of 1385.44 cm3, stroke of 9 cm. Calculate the…

A: GivenV=1385.44 cm3L=9cm

Q: If a car weighing 2400 lbs is able to go 1000 ft up a mountain incline whose angle of inclination is…

A: Given data: Weight of car = 2400 lbs                      Distance which car moves up the incline =…

Q: Explain why efficiency can never be 100% or more on a machine

A:

Q: Estimate the number of tennis ball that will fit in a box 3ft on a side.

A: Diameter of the tennis ball isd=2.7 inr=1.35 inNow the volume of tennis ball…

Q: Start a new Part in SolidWorks. Make a 1" diameter x 5" tall cylinder. Put a 0.5" diameter hole…

A: Given that-Diameter of cylinder = 1'' = 1 inchHeight of cylinder = 5'' = 5 inchDiameter of hole at…

Q: c) The bore of each cylinder in a six-cylinder car engine is 52 mm and the stroke for each piston is…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.