Practice Exercise 2: Let us analyze!Read and answer the following problems. Show your complete solution. You may writeyour answer at the back of this paper.1. Bleach solution contains the solute sodium hypochlorite (NAOCI). How many grams ofNaOCI in a 1500.0 grams of 3.62% bleach solution?2. What is the percent by volume of rubbing alcohol, an aqueous solution of liquid isopropylalcohol, in a solution that contains 42 ml of isopropyl alcohol in 1.2L of water?3. What is the molarity of a bleach solution containing 12.5 grams of NaOCI per liter ofbleach?4. What is molality of a lye solution containing 2.00 moles of NaOH in 500 ml NAOH-watersolution?5. What is the mole fraction of H,So, in an aqueous solution that contains 45.2 grams ofH;SO, in 90.8 grams H20?

Since you have asked multiple questions, we will solve the first question for you. If you want any…

Answered: Bleach solution contains the solute…

Bleach solution contains the solute sodium hypochlorite (NaOCI). How many grams of NaOCI in a 1500.0 grams of 3.62% bleach solution?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter4: Types Of Chemical Reactions And Solution Stoichiometry

Section: Chapter Questions

Problem 47E

See similar textbooks

Similar questions

The figures below are molecular-level representations of four aqueous solutions of the same solute. Arrange the solutions from most to least concentrated.
Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?
What kinds of solute particles are present in a solution of an ionic compound? Of a molecular compound?
Addition of water to concentrated sulfuric acid is dangerous because it generates enough heat to boil the water, causing it to spatter out of the container. For this reason, chemists remember to add acid to water. In a dilution experiment, we calculate the amount of the more concentrated solution that must be measured out. If we place this concentrated solution (Figure 4.7) in the volumetric flask first, then dilute with water, we violate the caution Add acid to water. Describe a safer variation on the method shown in Figure 4.7 that allows the quantitative dilution of concentrated sulfuric acid. Figure 4.7 Preparing a dilute solution from a concentrated solution. (a) Draw the concentrated solution into a pipet to a level just above the calibration mark. (b) Allow the liquid to settle down to the calibration line. Touch the tip of the pipet to the side of the container to remove any extra liquid. (c) Transfer this solution to a volumetric flask. Again touch the pipet to the wall of the flask to ensure complete transfer, but do not blow out the pipet because it is calibrated for a small amount of liquid to remain in the tip. (d) Dilute to the mark with solvent. Frequently, especially with concentrated acids, it is best to have some solvent present in the volumetric flask before you add the concentrated sample.
Mixtures of gases are always true solutions. True or false? Explain why.
An experiment calls for 100. mL of 1.25 M HC1. All that is available in the lab is a bottle of concentrated HC1, whose label indicates that it is 12.1 M. How much of the concentrated HC1 would be needed to prepare the desired solution?
Stock solutions of HCl with various molarities are frequentlyprepared. Complete Table 14.7 by calculatingthe volume of concentrated, or 12M, hydrochloric acidthat should be used to make 1.0 L of HCl solution witheach molarity listed.
An experiment in a general chemistry laboratory calls for a 2.00-M solution of HCl. How many mL of 11.9 M HCl would be required to make 250 mL of 2.00 M HCl?
A solution is formed by mixing 1 gal ethanol with 10 gal gasoline. Identify the solvent and the solute.
A throat spray is 1.40% by mass phenol, C6H5OH, in water. If the solution has a density of 0.9956 g/mL, calculate the molarity of the solution.
What mass of a 4.00% NaOH solution by mass contains 15.0 g of NaOH?
What does it mean when we say that a 200-mL sample and a 400-mL sample of a solution of salt have the same molarity? In what ways are the two samples identical? In what ways are these two samples different?