Below is a figure showing the apparent viscosity for a slurry of finely pulverized pine wood in water, at different shear rates. (A) Explain what kind of rheological model will best match this data. (B) Sketch a figure for the shear stress t as a function of the shear rate y?. (C) Make your best estimate for values of the two parameters that describe the model you selected in part (A).

Below is a figure showing the apparent viscosity for a slurry of finely pulverized pine wood in water, at different shear rates. (A) Explain what kind of rheological model will best match this data. (B) Sketch a figure for the shear stress t as a function of the shear rate y?. (C) Make your best estimate for values of the two parameters that describe the model you selected in part (A).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A- Womersley number (a) of a human aorta is 20 and for the rabbit aorta is 17, the blood density is approximately the same across the species. The values of viscosity were 0.0035 Ns/m² for the human and 0.0040 Ns/m² for the rabbit. The diameter of the aorta is 2.0 cm for the man, and 0.7 cm for the rabbit, estimate the heart rate beats per minute (bpm) for both species
You have been moved into the laboratory for the fluid testing for hydraulic devices, where your job is to illustrate the results of a viscosity test on a Newtonian fluid at various temperatures and explain discrepancies after completing the following given data-sheet in Table A. A considerable amount of research has been carried out in an attempt to understand the exact nature of the temperature variation of viscosity. One relatively simple model assumes that the viscosity obeys an 'Arrhenius-like' equation of the form n = Xe(k)r Хе --------Equation 1 where X = 1.7419 and (E/R) = -0.018 are constants for a given fluid. You are required to carry out appropriate calculations on the effect of changes in temperature given in table A by using equation 1 for Ethanol on the viscosity of a fluid. Table A NO Temperature viscocity n T°C cP 10 3 20 30 40 6. 50 7 60 8. 70 2. 4) 5.
A laboratory capillary pressure test was conducted on a core sample taken from the Nameless Field. The core has a porosity and permeability of 16% and 80 md, respectively. The capillary pressure-saturation data are given as follows: Sw Per psi 1.0 0.50 0.8 0.60 0.6 0.75 0.4 1.05 0.2 1.75 The interfacial tension is measured at 50 dynes/cm. Further reservoir engineering analysis indicated that the reservoir is better described at a porosity value of 19% and an absolute permeability of 120 md. Generate the capillary pressure data for the reservoir. Sw Pc,old Pc,new 1 0.5 0.15 0.8 0.6 0.17 0.6 0.75 0.22 0.4 1.05 0.31 0.2 1.75 0.51
In viscosity, what is not true? (a) A fluid at rest has zero shear stress (b) Deformation of fluids halts at fixed strain rate (c) Immersed objects in fluid are not restricted by its relative motion (d) Viscosity is an intensive property
Part II. 1. Herschel-Buckley Equation An unknown non-newtonian fluid underwent theology analysis. Assuming the yield stress is 36.3 Pa. Determine the fluid behavior index, consistency coefficient and type of non-newtonian fluid. Shear Stress (Pa) Shear Rate (1/s) 1 159 10 260 20 312 30 350 40 380 50 407 60 430
Calculate the young’s modulus from one of these two graphs?
A new implantable drug delivery device is being developed in your lab. The device prototype is a very thin strip (0.1mm × 1mm × 15mm) of polymer coated on both sides with 22 milligrams of solid drug particles. To test the drug delivery profile, you "implant the device by suspending it in a homogenous model fluid that has following properties: viscosity = 0.0018 Pa.s, density = 1.32 g cm^-3, temperature = 37°C. The diffusivity of the drug is estimated to be 2.113×10^-6 cm^2/S. 1. Determine how far the drug would penetrate into the fluid in 2.2 hours.
When a chalk is broken into dust-like particles, the particles take a long time to settle down to the ground when compared to the original chalk although the density of the chalk and the viscosity of air remain the same. The reasons for this are: (i) (ii) (i) (ii) The Reynolds number is very low due to reduced length scale of the dust. The dust particle is much lighter than the chalk. The viscous force is a surface force proportional to the length square while the gravitational force is a body force proportional to the length cube. At very small length scale, length square is much larger than length cube. (iii) (A) (B) The largest animal is found in sea as it requires no energy to support its weight by using hydrostatic principle. However bird has to support its own weight by using Bernoulli principle to create pressure difference while in flight. Bird cannot be very large and there are also fewer species of large bird than small bird. The reasons are: There is less food in the air…
Question 3 As part of a processing of biofuels, water is pumped into a circular tank with a diameter Dt, as shown in Figure Q3. The flowrate into the tank is Q₁ and the flowrate out is Q2. When the vessel is heated, water evaporates. The average velocity at which the vapour rises across the entire tank is vevap- You may assume that water has a density of Pw, and vapour has a density of P₁. Acceleration due to gravity is g. a) Find an expression for the rate of change of the mass of water in the tank.
"Select the most suitable complement among listed options for the 10 items: TReal fluids (a) are viscous (b) possess surface tension (c) are compressible (d) possess all the above properties (e) possess none of the above properties. 2) In a static fluid (b) fluid pressure is zero (c) linear deformation is small (a) resistance to shear stress is small (e) viscosity is nil. (d) only normal stresses can exist 3) When the flow parameters at any given instant remain same at every point, then flow is said to be (d) uniform (e) Static. (a) Turbulent (b) Steady state (c) laminar 4) The increase of temperature results in (a) increase in viscosity of gas (d) decrease in viscosity of liquid (b) increase in viscosity of liquid (c)decrease in viscosity of gas (e) (a) and (d) above. 5) Consider the flow in pipe in figure. If P₁ -AP/y. b) The ow direction is from 2 to 1 if AZ v3 (b) p3>pl; vl>v3 (c) p2>p3; v2> v3 (d) p4 vl (e) p4>pl; v4 Cohesion (b) Cohesion > Adhesion
The Table below shows the following data for a fluid to be constant temperature: du/dy (rad*s-1) 0,2 0,4 0,6 0,8 (N*m-2) 1,0 1,9 3,1 4,0 (a) Determine the behavior of the fluid and its viscosity. (b) Explain why the viscosity of a liquid decreases while the viscosity of a gas increases with increasing temperature.
You have two materials to choose from to make a thermometer out of. The material property (let's call it A) you plan to use varies with Temperature T as follows for the two materials Material 1: A(T) = 3T+ (7 * 10^-6) T^2 Material 2: A(T) = 6.3 T+ (0.001)T^2 Which material would you choose? Justify your choice with an explanation.