Before energizing the motor of a drill press, always ensure that the: Chuck key is placed in the chuck B) Shank drill bit is placed in the spindle C Chuck key is removed from the chuck D) Shank drill bit is removed from the spindle

Q: what are the four different uses of gear systems

A:

Q: Technician A says the size of the pads, shoes, drums, and rotors is based on the weight of the…

A: A drum brake is a brake that uses friction caused by a set of shoes or pads that press outward…

Q: dnives?

A: 23) Harmonic drives or harmonic gears are mechanical gear system in which there is flexible spline…

Q: and the restorer

A:

Q: What is Valve Guide Knurling?

A: Knurling is a process of manufacturing which is generally conducted in a lathe where a pattern of…

Q: Which rings (inner or outer) are mounted with interference? e) How many stops on the shaft are…

A: Given the Worm wheel assembly part:

Q: Which of the following determine the size of the casing to run? a. Reservoir pressures b. Size of…

A: Size of the casing depend on many factors which are mentioned below

Q: Worn teeth on a speed gear can cause?

A: worn teeth creates a big problem in gear drive.

Q: Thech a says that fixed calipers use one or more pistons only on one side of the rotor. Tech B say…

A: given: Thech a says that fixed calipers use one or more pistons only on one side of the rotor. Tech…

Q: What are two things that gear boxes typically used for?

A: The gearbox is used to increase the torque of the main shaft while the speed of  the shaft is…

Q: A chain saw will run in many positions. Tech a says that this is because of its float type…

A: A chain saw will run in many positions because of its diaphragm type carburetor. Diaphragm allows…

Q: what pushes the baulk ring into the cone no gear when the sleeve starts to move on the hu

A: what pushes the baulk ring into the cone no gear when the sleeve starts to move on the hub?

Q: Which of the following is NOT a Mechanical Engineering Student Shop safety rule? Wear open shoes Put…

A: Which of the following is NOT a Mechanical Engineering Student Shop safety rule?   A) Wear open…

Design of Shafts and Shaft Components

The shaft is basically defined as the machine element that rotates, is in circular cross-section, it is majorly used to transfer the power from one part of the system to another, or from a power generating machine to a power absorbing machine. The shaft is supported on bearings and is rotated with the help of a set of gears or pulleys that are used for the power transmission. Bending moment, torsion, and an axial force act upon the shaft. Designing of shaft primarily involves determining stresses at a critical point in the shaft that is arising due to loading.