BCQ4 is a four-bar linkage. Q2 and Q4 are fixed centers on a horizontal line 10-inches apart. Q2B is a link 5-inches long oscillating about Q2. Q4C is a crank 21⁄2-inches long which rotates about Q4. BC is a connecting rod 111⁄2-inches long. Q2 is to the left of Q4. A link EF, 6-inches long is pinned to Q2B at E, 11⁄2-inch.from B. Another link, GF, 31⁄2-inches long is pinned to link BC, 4-inches from C. These links, EF and GF, are pinned together at F in their upper position. Trace the paths of the points F and G while Q4C makes 1 complete revolution. Find the points for each 15o position of Q4C and any others necessary in order to secure a smooth curve. Scale: Space, 1⁄2 in. = 1 in.

Q: justt using the rule attached plss i need her all sloving

A: Based on the information you've provided and the image you sent, I can help you with the heat…

Q: For the mechanisms shown below determine the number of links, full joints, half joints and the…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Find the degrees of freedom of the following two different links Pin in slot b.

A: Solution:

Q: For the following mechanism, Given: . • Lengths: O₂A=4 in., O;B-8 in, BC=5 in., O₂O3-4 in. and…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: LO2: Perform kinematics analysis of different mechanisms. Q.1 Determine velocity of link 4 using…

A: Given r1=10cm=0.10r2=12 cm =0.12 mθ2=60°ω2=500 rpm Find the velocity link 4

Q: Whitworth quick-return mechanism has been shown in (a). The dimensions Fig. of the links are OP…

A:

Q: i need to solve part b pls quickk very urgent part (a) is solved

A:

Q: For the linkage in Figure P4-8, find its limit (toggle) positions in terms of the angle of link 0₂A…

A:

Q: The device shown in figure below can be analyzed as a pin-jointed fourbar mechanism in series with a…

A: The angle made by the link OC with the horizontal axis, The length of the link AB, The length of the…

Q: A general fourbar linkage configuration and its notation are shown in Figure below. The link…

A: Given data To determine the angular velocity of link 3 and 4 ω3 and ω4

Q: Given the mechanism in Question #6, and L1 = 1.4 in, L2= 3.8 in, L3 = 7.6 in, and 82 = 18.6 deg: If…

A: GIVEN: *L1=1.4 in*L2=3.8 in*L3=7.6 in *θ2=18.6°*Angular velocity ω2 of crank L2=3.41 rad/s CW TO…

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.