Based on the data given in the table below, explain in å SENTENCE, how does the pressure of the gas change with each degree Celsius change in temperature? (your answer must mention the relationship between the two variables, T and P, and which gas law is indicated). A student collected the following data for a fixed volume of gas. Pressure Temperature °C (mm Hg) 10 726 20 750 40 800 70 880 100 960

Based on the data given in the table below, explain in å SENTENCE, how does the pressure of the gas change with each degree Celsius change in temperature? (your answer must mention the relationship between the two variables, T and P, and which gas law is indicated). A student collected the following data for a fixed volume of gas. Pressure Temperature °C (mm Hg) 10 726 20 750 40 800 70 880 100 960

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A reaction between liquid reactants takes place at 32.0 °C in a sealed, evacuated vessel with a measured volume of 30.0 L. Measurements show that the reaction produced 41. g of carbon monoxide gas. Calculate the pressure of carbon monoxide gas in the reaction vessel after the reaction. You may ignore the volume of the liquid reactants. Round your answer to 2 significant digits. pressure: | atm x10
Sometimes in lab we collect the gas formed by a chemical reaction over water (see sketch at right). This makes it easy to isolate and measure the amount of gas produced. Suppose the CO gas evolved by a certain chemical reaction taking place at 40.0 °C is collected over water, using an apparatus something like that in the sketch, and the final volume of gas in the collection tube is measured to be 44.1 mL. x10 collected X gas water Sketch of a gas-collection apparatus Calculate the mass of CO that is in the collection tube. Round your answer to 2 significant digits. You can make any normal and reasonable assumption about the reaction conditions and the nature of the gases. chemical reaction
Two gas tanks contain different gases. The pressure, volume, and termperature of each gas are shown in the diagram. Ne(g) Tank X Tank Y P 120 atm V = 50 L P = 150 atm V = 50 L T 25°C T 25°C Which of the following could explain the difference in the observed pressures? (Assume that the gases behave ideally.) Nitrogen gas is composed of molecules, but neon gas is composed of individual atoms. The molar mass of N2 (g) is greater than that of Ne (g). The N, (g) particles have a greater average kinetic energy than the Ne(g) particles. D. There are more gas particles in tank Y than in tank X
Sometimes in lab we collect the gas formed by a chemical reaction over water (see sketch at right). This makes it easy to isolate and measure the amount of gas produced. Suppose the CO₂ gas evolved by a certain chemical reaction taking place at 50.0 °C is collected over water, using an apparatus something like that in the sketch, and the final volume of gas in the collection tube is measured to be 103. mL. g 0 collected gas X water ال Calculate the mass of CO₂ that is in the collection tube. Round your answer to 2 significant digits. You can make any normal and reasonable assumption about the reaction conditions and the nature of the gases. chemical reaction Sketch of a gas-collection apparatus
A gas cylinder that contains argon has an internal volume of 43.8 L. A pressure gauge attached to the cylinder reads 1890 psi (1 atm = 14.7 psi) at 22.3 °C. What mass of argon is contained in the cylinder? mass = g
A student completes the experiment The Universal Gas Constant and obtains the following data for one trial. mass of magnesium (g): Initial gas volume (ml): Final gas volume (ml): Temperature (°C): Atmospheric pressure (inHg): 30.39 Calculate the universal gas constant, R, for this trial. Assume that the water levels inside and outside the eudiometer tube are the same; that is, assume Ah = 0.00 cm water. Give your answer to two decimal places in the units of L-torr-mol-1. K-¹. 1 in Hg = 25.4 mmHg 1 cm water = 0.735559 mmHg 1 mol Mg = 24.305 g Mg on i TABLE D-4 TEMP DEGA C T 0 1 2 3 4 amm 14.579 4.612 4.646 | 4.660 4.714 4.924 4.959 4.9955.031 15.068 5.291 5.329 5.367 5.406 15.445 15.683 5.723 | 5.7645.805 5.146 16.100 1 6.143 6.1866.2306-274 1 6.318 10.6 I 0.7 J L 1 LI 1 4.7484.783 4.818 1 4.853 I 4.888 1 5.104 | 5.141 | 5.178 5.216 | 5.253 5.484 5.523 5.563 1 5.60215.647 I 5.888 | 5.930 | 5.972 1 6.014 1.6. 7_1 5.363 | 6.407 6.453 I 6.498 1 6.823 | 6. 871 6.919 1 6.967 1 1 | 6.544 |…
A reaction between liquid reactants takes place at 30.0 °C in a sealed, evacuated vessel with a measured volume of 30.0 L. Measurements show that the reaction produced 17. g of dinitrogen monoxide gas. Calculate the pressure of dinitrogen monoxide gas in the reaction vessel after the reaction. You may ignore the volume of the liquid reactants. Round your answer to 2 significant digits. atm pressure:at x10 X S
3 Enter your answer in the provided box.A sample of sulfur hexafluoride gas occupies 7.69 L at 218°C. Assuming that the pressure remains constant, what temperature (in °C) is needed to reduce the volume to 2.89 L? Report your answer to the proper number of significant figures.°C
Q1. An organic chemist isolates a colourless liquid from a petroleum sample. She places the liquid in a flask and puts the flask in a boiling water bath, which vaporizes the liquid and fills the flask with gas. She closes the flask, reweighs it, and obtains the following data: Volume of flask (V) = 213 mL T=100°C P=754 torr (760 torr in 1 atmosphere) Mass of flask+gas = 78.416g Mass of empty flask = 77.834g Calculate the molar mass of the liquid, carefully converting to appropriate units, where necessary. (Note: Gas constant; R = 0.082057 L.atm.K-¹.mol-¹)
11a
Subject:
Dinitrogen monoxide gas is collected at −4.0°Cin an evacuated flask with a measured volume of 50.0L. When all the gas has been collected, the pressure in the flask is measured to be 0.360atm. Calculate the mass and number of moles of dinitrogen monoxide gas that were collected. Be sure your answer has the correct number of significant digits.