band-pass filter in the figure is required to pass signals at f =44kHz frequency with a tolerance of 10%.  When RG1=470Ω , RG2=560Ω , RF1=1.2Ω , RF2=2kΩ , C1=0.05µF , C2=0.03µF what is the value of R1 and R2 ? (ideal op-amp)

Q: Find the values of the input and output impedances. • Determine the closed-loop voltage gain. The…

A: For the given circuit calculation of input and output impedances. And also calculate the closed loop…

Q: The input to the circuit below is a sine wave with amplitude 1 V and frequency 500 Hz. What is the…

A:

Q: If the unity gain bandwidth of an opamp is 40 MHz then what will be the bandwidth of opamp when the…

A: One very important property of an operational amplifier (opamp) is that its gain-bandwidth product…

Q: An op-amp comparator in a firing circuit can produce waveforms at the output of up to 28 V…

A: Given: Peak to peak voltage, Vp-p=28V, Therefore the maximum voltage will be, Vm=14V, Firing angle,…

Q: 1. The input signal in Figure 1(a) is applied to the comparator in Figure 1(b).Draw the output…

A: The input signal and the comparator circuit is shown below, The maximum output levels of the…

Q: An op-amp comparator in a firing circuit can produce waveforms at the output of up to 30 V…

A: A direct current voltage source with negative and positive terminals attached to the first and…

Q: A differentiator sub-system is built from an op-amp, a 10 „F capacitor and a 200 ka resistor. The…

A: Types of operational amplifier  Inverting amplifier  Non inverting amplifier  Application  Summer…

Q: An A/D converter has the following circuit on its input port.   a. bandpass filter   b. high…

A: A/D converter converts the analog input signal to the digital signal  input side continuous signal…

Q: Design the operational amplifier circuit so that vout = 5v1 – 2v2.

A: An operational amplifier circuit needs to be designed which will follow the following input-output…

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.