B. Water h=? Oil R.D 0.8 0-30m 0-15m 0-30m 0.10m 0.08m Carbon tetrachloride 1.60

Q: You work for the Marvellous Toy Company, who manufacture toy plastic figurines and dolls. State what…

A: In a toy company where the molten polymer is required to be pumped, we have to use a high power…

Q: Describe the seven different parts that make up the Open System.

A: A system that interacts with outside world is an open system.  Depending on the field thatdefines…

Q: The center of pressure will be always acting O at the same level of the center of gravity below the…

A:

Q: Write short note on the Difference between the PVT diagram of water and other liquids

A: Solution: To Determine: The difference between the Phase diagrams of water and other liquid.

Q: pressure that is less than atmospheric pressure is called what?

A:

Q: Explain the working principle of the submersible pump with neat diagram

A: A submersible pump is a pump that is able to be placed underwater and still carry out its intended…

Q: Where is the jet of the pump located? Select one: A. AT WATER LEVEL B. AT GROUND LEVEL C. JUST ABOVE…

A: In the jet pump When motor drives the pump, water flows from the small  nozzle or jet with…

Q: For forced draft counter flow cooling tower a. fan is kept at top of cooling tower and air and water…

A: Solution:

Q: Complete the diagram below by positioning labels into the correct position, identifying the main…

A: Solution:   The complete labelled diagram is given below:

Q: What is high pressure pump?

A: High-pressure pumps generate a very high pressure of fluid supply. Generally, high-pressure pumps…

Q: Show in Figure 1 is the water flow system. The velocity head difference is v²₁-v²₂. -= 2.0m. Volume…

A: Given data                 V12-V222g=2m                Q=0.5m3/s               h1=1m…

Q: Primary pump fill the tank in 2hrs.Secondary pump fill the tank in 4 hrs.The 2 pump is connected in…

A:

Q: n. Normal saline is a mixture of salt and water, it is called normal because it's concentration…

A: Given question: Normal saline is a mixture of salt and water, it is called normal because it's…

Q: ration i

A: given: Methods for treating vibration in pumps

Q: Water is stored in a pressurised container at a height Нт = 9 m. It then moves through a horizontal…

A:

Q: Transpiration it is the evaporation taking place from any surface water * body

A: Transpiration is the process of evaporation of water from the surface. In this process, the water…

Q: In a Three phase separator; the fluid enters the separator and hits an inlet diverter. This sudden…

A: A device that is used to separates the well fluids into gas, oil and water is called a three-phase…

Q: _is the temperature at which an oil substance gives off vapor continuously, when a flame is applied.…

A: TEMPERATURE  Temperature is the degree or intensity of heat contained in a substance or system, as…

Q: Describe the difference between closed and open system

A: Given data  Difference between closed and open system

Q: The amount of energy actually entering the fluid from a pump is the a. theoretical horsepower b.…

A:

Q: What must the water pressure need to be on for the third floor sink (36ft off the ground) to have…

A: Given data,  H= 36 ft =10.9728 m. Pressure at third floor  P=32 lbf/in2 =220632 Pa.   Let density of…

Q: Water in the form of water vapour is called as

A: The process converting water want to the water vapour is the vaporization process. This water vapour…

Q: Gasoline flows through a 1.6 inch diameter hose at an average velocity of 4 ft/s. What is the rate…

A: Given:Hose diameter, d=1.6 inch=1.612ftAverage velocity of gasoline through the hose, v=4 ft/sVolume…

Q: If a liquid is flowing through a pipe the ratio of discharge to area of the pipe will give O a.…

A: Option c is correct velocity

Q: If a fluid’s viscosity is low, but not negligible then A. it is expected that the flow is laminar B.…

A: Because of its molecular constitution, a fluid with low viscosity flows freely. Low viscosity…

Q: What is smoke point? What happens to an oil which is heated to beyond its 'smoke point

A: Smoke point: The smoke point is the temperature at which an oil or fat starts to break down and…

Q: A fluid line that carries a fluid that is physically dangerous to personnel must be marked with the…

A: A fluid line that carries a fluid that is physically dangerous to personnel must be marked with the…

Q: Why must the Cp value be estimated for oil when it is given in the problem statement.  i.e. why…

A: You want to know why the value of Cp is taken as 1.92 kJ/kg-K

Q: A small tube immersed vertically inside the liquid container, then it's known as the…

A: Capillary is a phenomenon of rising or falling of liquid surface in a small tube compared to the…

Q: If the mass flow is 5 kg/s, how long will it take to fill a container with 7000 g of fluid? O a. 0.7…

A:

Q: How to a fule pump transfers mechanical energy to a fluid by raising its pressure.

A: A pump is a device which converts mechanical energy into pressure energy

Q: What are the characteristics of oil pumps for boilers and engine generators? Select all that apply.…

A: Oil is sent to the engine-driven fuel pumps through booster pumps, which pass it via heaters and…

Q: Two types of pumps

A:

Q: I'm not getting the solution

A:

Q: 2.) What is the Speed of Sound in the Reservoir? * O 447.33 m/s O 458.95 m/s O 510.21 m/s O 412.98…

A:

Q: Why cavitation in pumps need to be avoid from occuring

A: Cavitation is the rapid process of formation and collapse of vapor bubbles in a liquid. In a pump,…

Q: If the mass flow is 5 kg/s, how long will it take to fill a container with 7000 g of fluid? O a. 0.7…

A:

Q: For forced draft counter flow cooling tower a. fan is kept at top of cooling tower and air and water…

A: Forced draft counter flow cooling tower: The schematic for forced draft counter flow cooling tower…

Thermodynamic Relations

Thermodynamics is the division of physics that deals with the transfer of any kind of energy, whether it be heat, temperature, or work, from one object to another.