b. BCD where measurements are done using orthogonal methe Ehox Round the area to 2 decimal place.

Q: negligible mass. Determine the force (Fin) that the small piston exerts on fluid in small cylinder.…

A:

Q: D = 875 kN L = 1450 kN SECT. 2 SECT.1 Square Tubing Pipe Fy = 290 mPa Do 4.8m So S, = outide…

A: Question is not clear. Please upload the full question so that the understanding in problem may…

Q: Show FBD and complete solution.    The system of knotted cords shown in the figure support the…

A: To find tensile force in each rod

Q: No. 9 bars compression bars in a column are to be lap spliced. There is no excess steel and the bars…

A: Given,  Compression bar no. #9 is spirally reinforced with dia 3/8 inch and pitch 3 inches.…

Q: From the figure shown which of the following gives the best outside dimension of the square tubing…

A: Given: Length of the column, L = 4.8 m Support condition: One end is fixed and the other end  hinged…

Q: A composite beam is fabricated by bolting two 3.8-in-wide by 8-in.-deep timber planks to the sides…

A: Given data  LAB = LCD = 3 ft ,        LBC = 11 ft  Modulus of elasticity of steel (Es) = 28700 ksi…

Q: Deflection  Given: the beam cross-section shown have the following cross-sectional properties  f'c…

A:

Q: 3) For the concrete beams shown, draw the approximate deflection shape and draw the locations of the…

A: To draw: Approximate deflection shape and location of reinforcing bars

Q: c)How much shorter will the cylinder get under load? d)What is the volume change? e)Supposethere…

A:

Q: ) Prove that stroctare is salee I Stakicalle dotaminate

A: Since the question number to be solved is not specified, the solution for subpart a is as follows:…

Q: Solve equations 1 and 2 shown below. All the values are given below please subsitute in the two…

A: L = 13 ft 2 in b = 2 ft 10.5 in DL = 40 psf

Q: 12. Assume a uniformly load simply support beam with a rectangular cross section. The width of the…

A: Given Data: The width of the both the beams (aluminum and steel) is b. The depth of the aluminum…

Q: side and 4 mm thick. The walls are 3 mm thick, and the total height of the cup = 50 mm. The SL used…

A:

Q: Please present FBD/s A tensile test is performed on a brass specimen 10mm in diameter using a gage…

A:

Q: Beam and load cases Maximum Beam Deflection PL³ dmax 3EI

A: To find maximum deflection of cantilever beam

Material Properties

Construction in civil engineering demands high strength, durability, and longevity. These targets can be achieved by better design and analysis, along with the correct choice of materials. Different materials have different properties and hence, they respond and performs differently under the various condition of external loadings. It is therefore a critical task of an engineer to select the right material based on the property that the material is supposed to function in real-time. When speaking about the property, there are different categories of material properties like chemical property, physical property, mechanical property, electrical property, magnetic property, thermal property, etc. These material properties form the basis of material selection in various applications.