B The shaft shown in the figure rotates at a constant speed of 1500/π rpm. Three masses rotating with the shaft are connected to the shaft as shown in the figure and cause instability. dynamic balance Determine the positions and values (kg.mm) of the masses that must be added to the DI and DII planes to ensure

Q: Figure 2 shows the forklift has a weight of 1000 kg with center of gravity at G₁, and the load…

A: (a) To find : The shortage stooping distance without causing any of the wheel to leave the ground.…

Q: The smooth surface of the vertical cam is defined in part by the curve r = (0.2 cos 0+0.3) m.…

A: Write the given data.

Q: Figure Q2 shows 8 cylinders Radial engine with their connecting rods are coupled to a single crank.…

A: Mass of reciprocating parts per cylinder is 1.2 kg.Engine running at ()=1800 rpm =length of…

Q: F=350 N C R-0.2m Vo 2 m/s Figure Q4

A:

Q: Calculate the normal reactions on front and rear axles in case of front wheel drive vehicles. Take,…

A:

Q: wraps radiu 0.8 ft, and weighs 10 lbs. Drum B has radius rs = 2 ft, radius of gyra 20 lbs. I stand…

A:

Q: Specify the bearings required,

A:

Q: The 0.4 kg B pin in the figure moves freely inside the circular slide DE with radius b and the…

A: Solution:

Q: A 500 pound weight is attached to a cable that is being lifted by a 10 inch diameter drum.  The 48V…

A: GIven data: The diameter of the drum is d=10 in The weight attached to the cable is Ft=500 lb The…

Q: Regarding the gyroscope illustrated below, consider that you give a push for a brief moment on the…

A: The precessional angular velocity of shaft for gyroscopes is given by right hand screw rule. For the…

Q: Don't Use Chat GPT Will Upvote And Give Handwritten Solution Please

A: Solution:

Q: Find the value of the input torque on the crank-shaft mechanism in following Figure. The centers of…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.