B) Catalyst pelle air at 1 atm and 80 C particles is 960 kg/m sufficient for fluidize viscosity of 0.00002

Q: A container projectile passage was replaced in September of 2008 with the initial thickness of 750…

A: Given that in september of 2008 ,initial thickness ,t1 = 750 mils In Feb 2021 ,actual thickness…

Q: A parallel plate type ESP used for indoor air cleaning to remove particles. The ESP is handling 100…

A: Given that, The volumetric flow rate of gas Q = 100 m3h Space between two plates = 10 cm Height of…

Q: For a monosized media filter with a particle size of 2.5 mm in diameter, a bed depth of 2 m and…

A: Given data: Diameter of particle = 2.5 mm Depth of bed = 2 m Porosity = 20 % Water temperature = 15…

Q: 5-7. Malfunctioning in a uranium oxide compacting machine resulted in the manufacture of a 0.2-in.…

A:

Q: Distillation column working with infinite reflux ratio, what is the value of  the distillate…

A: The distillate product value and number of stages in the distillation column at the infinite value…

Q: For typical silica optical fibres with ncore = 1.45 and Δ = 5 x 10-3, calculate nclad and  NA

A: Given, The refractive index of the core, n1 = 1.45 Relative refractive index difference, ∆ = 5×10-3…

Q: (B):-During corrosion tests, current density of 0.86 Amp/m² sample immersed in sea water.

A:

Q: A diluted suspension contains food particles with a diameter of 5x10-2 mm, which are to be extracted…

A:

Q: Potential enray(ft llbc) of 100 lb drum hanging 10ft above Surface if eaih. A5 Mistares TRYING

A:

Q: 7. What the type of calculated permeability in Permeability of Liquid method ?

A: Permeability of the material is defined as capacity of that material of transmitting or passing…

Q: A non-deforming, extrude insulating material’s heat transmission coefficient is given as 0,029…

A: Consider the insulating material as shown in figure below: The following assumptions are made for…

Q: what is the concentration of caffeine in 10 microliter injection given a peak area of 10.3

A:

Q: /A10 sq. meter lead plate containing a small (1m) drop of un on surface is immersed in sea water.…

A: Here the anodic area is much larger than the cathodic area.

Q: Q3// A plate and frame press gave a total of 0.001 m' of filtrate in 14s and 0.005 m in 160s. The…

A: Given that, The volume of the filtrate obtained in time t1 = 14 s is V1 = 0.001 m3 The volume of the…

Q: Given the following for a simple, cocurrent exchanger: tube outside diameter, Do = 0.75 inches tube…

A:

Q: A core was mounted in a gas permeameter to measure permeability, and the following laboratory data…

A: Given data: Diameter of core = 2.59 cm Length of core = 6.03 cm Gas viscosity = 0.0148 cP Pressure…

Q: (b) The general characteristics of three oil wells selected for artificial lift as production method…

A: Table of 3 well are given.

Q: How membrane separation process can be relate to the fundamental of heat/mass transfer?

A: The membrane separation process is a very important water treatment process in which the mass…

Q: Zsm-5 a catalyst material has a surface of 425 m^2/g what is the surface area of its material in…

A:

Q: A container of gas is being cooled. Identify the physical change occurring during the time interval,…

A: The process that is taking place between the time interval of 4 mins to 9 mins is to be chosen.

Q: Distillation column working with infinite reflux ratio, what is the value of the distillate product,…

A:

Q: Verify that thermal conductivity

A:

Q: A steel coupon with an anode surface area of 1000 cm2 is placed in an electrolyte. The corrosion…

A: As the  metals are found in the ores present naturally in the environment. The corrosion process can…

Q: v Abrasive A. Fireclay v High thermal shock resistance B. Whiteware clay ceramic v Washbasin C.…

A: To match entries in the left column with those in right column

Q: A dual-medium filter is composed of 0.3 m anthracites (mean size of 2.0 mm) that are placed over a…

A: Given data: Diameter of anthracites particle = 2 mm Length of anthracites layer = 0.3 m Diameter of…

Q: Identify conditions listed in the following table for a 50-fold scaleup of batch crystallization of…

A: Given conditions for the batch crystallization in laboratory and plant are given as:

Q: 6-Calculate the overall heat transfer coefficient based on the inner diameter for a steel pipe…

A: Given, The inner diameter of the pipe, di = 20 mm The thickness of the pipe, δs = 2 mm The thickness…

Q: A piece of hollow fiber membrane shows a flux value of 5.70 cm³/cm².s based on the outside area of…

A: Given: Flux value based on outside diameter is 5.70 cm3/cm2 s Flux value based on inside diameter is…

Q: Q4/ It is desired to carry out a process in a packed column with heat transfer. The column an be…

A:

Q: For mass transfer across a phase interface, what is the difference between the film, penetration,…

A: The difference between the film, penetration and surface renewal theories with respect to the…

Q: Calculate the liquid-phase mole fraction, and vaporphase mole fraction for Pentane - Hexane mixture…

A: To calculate the liquid-phase mole fraction (χi​) and vapor-phase mole fraction (yi​) for a…

Q: One of these is an advantage of Biodiesel. O All of these O Low freezing point Good as a lubricant O…

A: Biodiesel is a type of diesel fuel that is made from the usage of plants or animal waste, vegetable…

Q: Write the difference between packed bed and Fluidized bed reactors.

A: Given, it is asked to find  the difference between packed bed and Fluidized bed reactors.

Q: What is the effect of roughness on heat transfer, explain it with diagrams

A:

Q: why: rte Water Content decreases the ete performance of thermal in sulator

A: Thermal insulation is used to reduce the heat loss. The layer of insulation is wrapped over pipe…

Q: 6) For a thin stationary phase that equilibrates rapidly with analyte, the minimum theoretical plate…

A: Given: The equation for minimum theoretical plate height in terms of column radius (r) and retention…

Q: A high pressure 3 phase separator operates at 5MPa and 400 deg C. The separator is producing gas,…

A: Step 1: (1). Wall Thickness Calculation for 5 MPa Separator: We use the ASME formula for calculating…

Q: Design a spherical tank, with a wall thickness of 2 cm that will assure that no more than 50 kg of…

A: Given: Wall thickness = 2 cm=0.02 m Operating Temperature = 5000C=773.15 K Allowed hydrogen loss =…

Q: Discuss the factors that influence the strength of a metallic bond. Modern steel is so much stronger…

A: Introduction Metallic bonding is a type of chemical bonding that arises from the electrostatic…